A nonparametric spectrum estimation method for dispersion and attenuation analysis of borehole acoustic measurements

Dispersion and attenuation analysis can be used to determine formation anisotropy induced by fractures,or stresses.In this paper,we propose a nonparametric spectrum estimation method to get phase dispersion characteristics and attenuation coefficient.By designing an appropriate vector filter,phase velocity,attenuation coefficient and amplitude can be inverted from the waveform recorded by the receiver array.Performance analysis of this algorithm is compared with Extended Prony Method(EPM)and Forward and Backward Matrix Pencil(FBMP)method.Based on the analysis results,the proposed method is capable of achieving high resolution and precision as the parametric spectrum estimation methods.At the meantime,it also keeps high stability as the other nonparametric spectrum estimation methods.At last,applications to synthetic waveforms modeled using finite difference method and real data show its efficiency.The real data processing results show that the P-wave attenuation log is more sensitive to oil formation compared to S-wave;and the S-wave attenuation log is more sensitive to shale formation compared to P-wave.

SAR STEREO IMAGING ALGORITHM BASED ON CAPON SPECTRUM ESTIMATION

This letter presents a novel approach for the Synthetic Aperture Radar (SAR) stereo imaging based on the Capon spectrum estimation technique. In order to deal with nonuniform sampling space and lead to super resolution in the elevation direction, Capon approach is used to focus the SAR data on a certain height. Results obtained on simulated data demonstrate the feasibility of the Capon based algorithm. Compared with the classical Fast Fourier Transform (FFT), the Capon based algo-rithm shows better resolution quality.

Classical and modern power spectrum estimation for tune measurement in CSNS RCS

Precise measurement of betatron tune is required for good operating condition of CSNS RCS. The fractional part of betatron tune is important and it can be measured by analyzing the signals of beam position from the appointed BPM. Usually these signals are contaminated during the acquisition process, therefore several power spectrum methods are used to improve the frequency resolution. In this article classical and modern power spectrum methods are used. In order to compare their performance, the results of simulation data and IQT data from J-PARC RCS are discussed, It is shown that modern power spectrum estimation has better performance than the classical ones, though the calculation is more complex.

The characteristics of frequency-time azimuth spectrum estimation by a vector hydrophone in shallow water

The mechanism of interaction between the energy flows of the far-field ship noise and the near-field platform is studied, and the characteristics of frequency-time azimuth spec- trum is discussed. Based on normal modes theory in acoustic vector fields, the model of the near-field platform is established, and the simulated result is similar to the investigation in shallow water. The frequency-time aziinuth spectrum of the energy flow is investigated by the vector hydrophone changes with frequency. The energy flow of the far-field ship noise interacts with the near-field platform, so four kinds of stripes are shown in the frequency4ime azimuth spectrum, which is the same with the investigation of sea trial. The estimation of direction of arrival appears inaccuracy, and varies with frequency. The main factor that affects the charac- teristics of frequency-time azimuth spectrum of resultant energy flow is the difference of sound pressure level. The estimation of the direction of arrival benefits from this when a number of sources exist in shallow water.

Maximum likelihood spectrum estimation method and its application in seismo－magnet－icrelation

Ｍａｘｉｍｕｍｌｉｋｅｌｉｈｏｏｄｓｐｅｃｔｒｕｍｅｓｔｉｍａｔｉｏｎｍｅｔｈｏｄａｎｄｉｔｓａｐｐｌｉｃａｔｉｏｎｉｎｓｅｉｓｍｏ┐ｍａｇｎｅｔ┐ｉｃｒｅｌａｔｉｏｎＸＩＡＯ－ＰＩＮＧＺＥＮＧ１）（曾小苹），ＹＵＮ－ＦＡＮＧＬＩＮ１）（林云芳），...

Estimation of dynamic stress spectrum distribution in structural fatigue test

The determination of structural dynamic stress spectrum distribution is of great signifi- cance in the structural fatigue strength evaluation as well as reliability design. In previous empirical data processing methods, the data grouping and distribution fitting were excessively coarse and contained distinctive defects. This paper proposed an effective approach to statistically group actual measured dynamic stress data and validly extrapolate the combined distribution to fit the dynamic stress spectrum distribution. This approach has been verified its effectiveness through chi-square test, stress spectrum extrapolation and damage calculation in dynamic stress study.

Symmetrical Processing of Interferogram and Spectrum Reconstruction in Interference Spectrometer

Because of its all-reflective layout based on the Fresnel double-mirror interference system, the newly developed Fourier transform imaging spectrometer has a very large spectral bandwidth ranged from a cut-off wavelength (related to the cut-off wave number σ max ) to far infrared. According to the signal's symmetry and wide-band characteristics, a simple method that can efficiently weaken the low frequency noise in the reconstructed spectrum is presented. Also, according to the symmetry, the eigenvector method is applied to the reconstruction of the spectrum.

Improvement of Attributed Scattering Center Extraction by Using SAR Super-Resolution Preprocessing

Synthetic aperture radar(SAR)is able to acquire high-resolution method using the active microwave imaging method.SAR images are widely used in target recognition,classification,and surface analysis,with extracted features.Attribute scattering center(ASC)is able to describe the image features for these tasks.However,sidelobe effects reduce the accuracy and reliability of the estimated ASC model parameters.This paper incorporates the SAR super-resolution into the ASC extraction to improve its performance.Both filter bank and subspace methods are demonstrated for preprocessing to supress the sidelobe.Based on the preprocessed data,a reinforcement based ASC method is used to get the parameters.The experimental results show that the super-resolution method can reduce noise and suppress sidelobe effect,which improve accuracy of the estimated ASC model parameters.

Methods of Validating Simulation Model and Program Design

Validating simulation model is one of the important aspects for modeling and simulation. Some methods of validating model are compared and analyzed. Several typical methods, such as TIC’s inequality coefficient, gray interconnected analysis, direct spectrum estimation, maximum entropy spectral estimation based on Burg or Marple, are chosen and programmed in C language. Some examples by using the program are given. The results show that the program is available and it is best to adopt multi methods for validating models.

Multitaper spectral method to estimate the elastic thickness of South China: Implications for intracontinental deformation

The effective elastic thickness （Te） represents the thickness of the elastic layer or the flexural rigidity of the lithosphere, the equivalent of which can be calculated from the spectral analysis of gravity and topographic data. Studies of Te have profound influence on intracontinental deformation, and coupling of the tectonic blocks. In this paper, we use the multitaper spectral estimation method to calculate the coherence between Bouguer gravity and topography data, and to obtain the Te map of South China. Through the process of correction, we discuss the relationships of Te versus heat flow, and Te versus seismicity. The results show that Te distribution of South China is affected by three factors：the original age, which controls the basic feature;the Mesozoic evolution, which affects the Te distribution;and the neotectonic movement, which shaped the final distribution. The crust age has a positive correlation with the first-order Te distribution;thus the Yangtze Craton has a relatively higher Te （about 50 km） whereas the Te in Cathaysia block is only 10e20 km. By analysis and comparison among the tectonic models of South China, the Te distribution can be well explained using the flat-subduction model. As is typical with neotectonics, the region with a higher heat flow is related with a lower Te. The seismicity does not have a clear relationship with Te, but the strong seismicity could cause a low Te. Seismogenic layer （Ts） has a similar trend as Te in the craton, whereas in other areas the relationship is complex.

Analysis on the time variation and cycle of observed Argo profile data

The remote sensing data which are used by marine fishery forecast only can get the information of ocean surface, while Argo data can provide fishery forecast with temperature and saltinity data of deeper area. To use Argo data in cycle, we need to compute its circle to improve the quality of forecast. In 2001- 2008, the longer circle was 62.7 days and 117.5 days, and the shorter circle was 4.9 days and 9.8 days, which were obtained by power spectrum estimation. And there was an unobvious circle of 7 days. There existed big changes in observed profile data amount between years and within a year.

The spectrum entropy estimation method for ultrasonic backscattering signal in cancellous bones

In the application of cancellous bone ultrasound diagnosis based on backscattering method, it is of great importance to estimate fast and accurately whether the valid backscattering signal exists in the received signal. We propose a fast estimation method based on spectrum entropy method. With 984 records of adult calcaneus clinical data, we estimate the validity of the backscatter signal using this method. The results of the proposed method and the results of experience-base judgement were compared and analyzed. And two key parameters, the signal range length and the segment number of the spectrum entropy, were analyzed. The results show when the signal range length is 13 I^s and the segment number is 15 20, this method can get the best result （accuracy〉95%, sensitivity〉99%, specificity〉87%）, while taking little calculation time （1.5 ms）. Therefore, this spectrum entropy method can satisfy the accuracy and real-time requirements in the ultrasonic estimation for cancellous bone.

Dynamic modeling of ultra-precision fly cutting machine tool and the effect of ambient vibration on its tool tip response

The dynamic performances of an ultra-precision fly cutting machine tool(UFCMT)has a dramatic impact on the quality of ultra-precision machining.In this study,the dynamic model of an UFCMT was established based on the transfer matrix method for multibody systems.In particular,the large-span scale flow field mesh model was created;and the variation in linear and angular stiffness of journal and thrust bearings with respect to film thickness was investigated by adopting the dynamic mesh technique.The dynamic model was proven to be valid by comparing the dynamic characteristics of the machine tool obtained by numerical simulation with the experimental results.In addition,the power spectrum density estimation method was adopted to simulate the statistical ambient vibration excitation by processing the ambient vibration signal measured over a long period of time.Applying it to the dynamic model,the dynamic response of the tool tip under ambient vibration was investigated.The results elucidated that the tool tip response was significantly affected by ambient vibration,and the isolation foundation had a good effect on vibration isolation.

Coherent Doppler lidar wind retrieval for a typhoon based on the genetic simulated annealing algorithm

A method of spectrum estimation based on the genetic simulated annealing(GSA)algorithm is proposed,which is applied to retrieve the three-dimensional wind field of typhoon Nangka observed by our research group.Compared to the genetic algorithm(GA),the GSA algorithm not only extends the detection range and guarantees the accuracy of retrieval results but also demonstrates a faster retrieval speed.Experimental results indicate that both the GA and GSA algorithms can enhance the detection range by 35%more than the least squares method.However,the convergence speed of the GSA algorithm is 17 times faster than that of the GA,which is more beneficial for real-time data processing.

Design and Experiments of Model-free Compound Controller of Flight Simulator

A model-flee compound controller design method is proposed to achieve the wide frequency bandwidth requirement of flight simulators. The method based on quantitative feedback theory, acquires system uncertainty under different working conditions through closed-loop identification with power spectrum estimation. Then in controller designing, it makes a trade, off between the strict requirements for magnitude-frequency characteristics and those for phase-frequency characteristics of flight simulators, by converting the indices of magnitude-frequency characteristics of flight simulators into quantitative feedback theory-based tracking specification bounds and using feedforward controller to attain the required phase-flequency characteristics. Simulation and experimental results indicate that, when used to design inner flame controller of flight simulator, the proposed method can fulfill the requirements for wide frequency bandwidth indices. Compared with other controller design methods, it has the property of model-free and transparency.

Two modified discrete chirp Fourier transform schemes

This paper presents two modified discrete chirp Fourier transform (MDCFT) schemes. Some matched filter properties such as the optimal selection of the transform length, and its relation-ship to analog chirp-Fourier transform are studied. Compared to the DCFT proposed previously, theo-retical and simulation results have shown that the two MDCFTs can further improve the chirp rate reso-lution of the detected signals.

Dual-Energy Technique at Low Tube Voltages for Small Animal Imaging

We investigate the feasibility of dual-energy method for image contrast enhancement in small animal studies using a low kV X-ray radiographic system. A robust method for X-ray spectrum estimation from transmission measurements, based on expectation-maximization （EM） method, is applied to an X-ray specimen radiographic system for dual energy imaging of a mouse. From transmission measurements of two known attenuators at two different X-ray tube voltages, the X-ray energy spectra are reconstructed using the EM-based method. From the spectra information thus obtained, the transmission data for bone and soft tissue in terms of vadous thicknesses are generated. Two polynomial functions of transmission data are then sought for to fit the inverted thicknesses of bone and soft-tissue. Scatters in cone-beam projection data acquired at two X-ray energies were corrected. From the scatter-corrected data, a bone thickness map is separated from a soft-tissue thickness map by use of the polynomial functions.

A method for improving the performance of MVDR beamforming

Minimum Variance Distortionless signal Response (MVDR) beamforming can be used as a wavenumber spectrum (bearing) estimation, whose precision or resolution is deter mined primarily by signal-to-noise ratio. This paper presents a method for improving MVDR beamforming bearing resolution by using an enhancement factor in its weight vector design for emulating a high signal-to-noise ratio condition which is known to be a principal factor in res olution improvement. This method can providc improved rcsolution not at the expense of sig nal-to noise plus interference ratio gain. Some of computer simulation results are also given.