The present paper is related to the conversion of Ti–6Al–4V chips into powder and investigates the usability of the produced powder in powder metallurgy applications. In this regard, a disc-milling process was appli...The present paper is related to the conversion of Ti–6Al–4V chips into powder and investigates the usability of the produced powder in powder metallurgy applications. In this regard, a disc-milling process was applied to Ti–6Al–4V chips and the obtained powder was subsequently compacted. The compacted samples were sintered by the sinter hot isostatic pressing (sinter-HIP) method at 1200°C under high vacuum, their mechanical properties and microstructure were investigated and compared with those of commercial powder compacts subjected to the same preparation processes. The results showed that the produced powder exhibits greater flowability and higher apparent density than the commercial powder. However, the sintered products prepared from the commercial powder exhibited a higher relative density, lower porosity, and, as a result, greater flexural strength compared with the sintered compacts prepared from the produced powder. In addition, transgranular fracture was greater in the sintered products of the commercial powder. The microstructural studies revealed that the sintered products made from both the commercial and the produced powders consisted of α- and β-phase but contained more α-phase. All of the examined properties were found to be substantially affected by the particle size of the powders.展开更多
基金financially supported by Faculty Member Training Program funded by Council of Higher Education Turkey [OYP-05276-DR-12]
文摘The present paper is related to the conversion of Ti–6Al–4V chips into powder and investigates the usability of the produced powder in powder metallurgy applications. In this regard, a disc-milling process was applied to Ti–6Al–4V chips and the obtained powder was subsequently compacted. The compacted samples were sintered by the sinter hot isostatic pressing (sinter-HIP) method at 1200°C under high vacuum, their mechanical properties and microstructure were investigated and compared with those of commercial powder compacts subjected to the same preparation processes. The results showed that the produced powder exhibits greater flowability and higher apparent density than the commercial powder. However, the sintered products prepared from the commercial powder exhibited a higher relative density, lower porosity, and, as a result, greater flexural strength compared with the sintered compacts prepared from the produced powder. In addition, transgranular fracture was greater in the sintered products of the commercial powder. The microstructural studies revealed that the sintered products made from both the commercial and the produced powders consisted of α- and β-phase but contained more α-phase. All of the examined properties were found to be substantially affected by the particle size of the powders.
基金finacially supported by National Natural Science Foundation of China(51404077)Guangdong Province Natural Science Foundation(2015A030313775)+2 种基金Guangzhou International Science&Technology Cooperation Program(201508030032)Guangdong Academy of Sciences Project(2017GDASCX-0117)Guangzhou Science and Technology Planning Project(ZWY201704003)
