Optimization of Texture Determination of ‘Yali' by Texture Analyzer

[Objectives] This study was carried out to determine texture parameters for texture profile analysis （TPA）, and optimize the texture determination of ‘Yali’ by texture analyzer.[Methods] The traditional varieties of ‘Yali’ were taken as the materials, and texture parameters were determined at different compression rates and deformations at target.[Results] In the process of the TPA, the deformation at target had an extremely significant influence on 8 TPA texture parameters, namely, the hardness, cohesiveness, springiness, adhesiveness, gumminess, resilience, fracturability, and chewiness （ P ≤0.01）, while the compression rate had significant influence on the hardness and gumminess （ P ≤0.05）, had an extremely significant influence on fracturability （ P ≤0.01）, and had no significant influence on other 5 TPA parameters.[Conclusions] Taking the compression rate of 1 mm/s and 20% deformation at target as the experimental conditions for TPA could avoid the impact load of high speed on the tissue and objectively reflect the textural characteristics of ‘Yali’ pulp tissue.

Morphological parameters of both surfaces of coupled joint

Twenty one joints were made with Brazilian tests and each surface was scanned by the Talysurf CLI 2000. Morphological characteristics of joint surface were quantified by statistical and textural parameters. By the contrast of these parameters between both sides of each coupled joint, the following conclusions are drawn. The upper and lower surfaces of coupled joints have approximately equal values of Sp（maximum height of joint surface）, Sa（arithmetic mean height of joint surface） and Sq（root mean square height of joint surface）, but the Ssk（skewness of the height distribution of joint surface） values of the two surfaces of a coupled joint are different, one is positive while the other is negative. The Saj（auto-correlation length） parameter values of both surfaces of each coupled joint are quite close, and the S^（texture aspect ratio） values have the same situation to the Sal parameter, but the same parameters of different surfaces have big differences which illustrates its own characteristics of each joint. The two surfaces of each coupled joint have similar values of θp （mean profile angle） which can be used to deduce the value of θp each other.

The effects of grain texture and phenotypic traits on the thin-layer drying rate in maize(Zea mays L.) inbred lines

To explore the relation of maize grain texture and phenotypic traits with grain thin-layer drying rate,we observed the ultra-structure of maize grain,and tested three traits about the maize grain texture and four phenotypic traits.The vitreous part percentage was different（P〈0.05） among different maize inbred lines.There was a significant relationship between the drying rate with grain texture and phenotypic traits.Main factors that influenced the drying rate were different during different drying stages.New results observed that empirical constants（k and N） in drying equation were different for seed of the 30 inbred lines of maize.The k of simplified diffusion equation and N of page equation were significantly influenced by both grain texture and phenotypic traits.These results could be used as guideline parameters for drying maize seeds having different grain characteristics during different drying stages.