Optimization of the extraction process of total flavonoids from Trichosanthis Fructus by Box-Behnken response surface method combined with differential spectrophotometry

Objective:To optimize the extraction process of total flavones in Trichosanthis Fructus(composed of Trichosanthis pericarpium and Trichosanthis semen in certain proportion).Methods:The effects of the mixture ratio of Trichosanthis pericarpium and Trichosanthis semen,ethanol concentration,ultrasonic extraction time and extraction temperature on the extraction rate of total flavonoids in Trichosanthis Fructus were investigated.The extraction process of total flavonoids in Trichosanthis Fructus was optimized by Box-Behnken response surface method combined with differential spectrophotometry.Results:The optimum extraction conditions of total flavonoids in Trichosanthis Fructus were as follows:The mixture ratio of Trichosanthis pericarpium and Trichosanthis semen was 4:6,the ethanol concentration was 70%,the ultrasonic extraction time was 60min and the extraction temperature was 40℃.Conclusion:Box-Behnken response surface method combined with differential spectrophotometry can optimize the extraction process of total flavonoids from Trichosanthis Fructus,which can provide reference for the extraction and application of total flavonoids in Trichosanthis Fructus.

Box-Behnken效应面法筛选聚氧乙烯骨架缓释片处方和释药机制的研究

目的:优化聚氧乙烯骨架片的处方并对释药机制进行研究。方法:以水溶性药物酒石酸美托洛尔为模型药物,釆用药物与聚氧乙烯等辅料混合均匀后直接压片的方法制备聚氧乙烯骨架片。以药物释放数据的零级方程拟合度R02和处方在1小时和24小时的累积释药百分率Q1h、Q24h为评价指标。用Box-Behnken效应面法筛选最优处方。获得最优处方的释放数据进行Higuchi equation、Korsmeyer equation、Peppas-Sahlin equation方程拟合。结果:优化处方是:酒石酸美托洛尔100 mg、聚氧乙烯170 mg、卡波姆65 mg、碳酸钠102 mg,按照该处方制备的酒石酸美托洛尔聚氧乙烯骨架片,对应的评价指标测得值与预测值的偏差小于5%。经验方程拟合和各种方法验证了骨架片的药物释放是扩散和溶蚀的协同作用。结论:利用Box-Behnken效应面法筛选酒石酸美托洛尔聚氧乙烯骨架片的处方的主方法是有效可行的,模型的预测值与理论值相符。药物的释放机制是扩散和溶蚀的协同作用。

A quick evaluation model for CO_2 flooding and sequestration

CO2 flooding not only triggers an increase in oil production,but also reduces the amount of CO2 released to the atmosphere （by storing it permanently in the formations）.It is one of the best ways to use and store CO2.This paper firstly selects the key factors after analyzing the factors influencing the CO2 storage potential in the formations and oil recovery,and then introduces a series of dimensionless variables to describe reservoir characteristics.All influencing factors with varying values are calculated through a Box-Behnken experimental design.The results are interpreted by a response surface method,and then a quick screening model is obtained to evaluate the oil recovery and CO2 storage potential for an oil reservoir.Based on the evaluation model,sensitivity analysis of each factor is carried out.Finally,research on CO2 sequestration and flooding in a typical reservoir indicates that the evaluation model fits well with the numerical simulation,which proves that the evaluation model can provide criteria for screening attractive candidate reservoirs for CO2 sequestration and flooding.

Parametric optimization of friction stir welding process of age hardenable aluminum alloys-ANFIS modeling

A comparative approach was performed between the response surface method(RSM) and the adaptive neuro-fuzzy inference system(ANFIS) to enhance the tensile properties, including the ultimate tensile strength and the tensile elongation, of friction stir welded age hardenable AA6061 and AA2024 aluminum alloys. The effects of the welding parameters, namely the tool rotational speed, welding speed, axial load and pin profile, on the ultimate tensile strength and the tensile elongation were analyzed using a three-level, four-factor Box-Behnken experimental design. The developed design was utilized to train the ANFIS models. The predictive capabilities of RSM and ANFIS were compared based on the root mean square error, the mean absolute error, and the correlation coefficient based on the obtained data set. The results demonstrate that the developed ANFIS models are more effective than the RSM model.

Study on the Effect of Preparation Parameters of K₂CO₃/Al₂O₃Sorbent on CO₂Capture Capacity at Flue Gas Operating Conditions

In this paper, study on the effect of preparation conditions of K2CO3/Al2O3 sorbent was done. Box-Behnken design was applied to study the influence of four parameters involve initial solution concentration, impregnation time and calcination step temperature and time. A quadratic model was used to correlate the sorbent capture capacity. The model was used to calculate the optimum conditions for preparing sorbent. From the analysis of variance (ANOVA), the most influential factor on each experimental design response was identified. The potassium-based sorbents used in this study were prepared by impregnating K2CO3 on Al2O3 support. The CO2 capture capacity was measured in the presence of H2O in a fixed-bed reactor at CO2 capture temperature of 60°C using breakthrough curves. The optimum sorbent prepared by this method showed CO2 capture capacity of 77.21 mg CO2/g sorbent. It was observed that the experimental values obtained were in good agreement with the values predicted by the model, with relatively small errors between the predicted and the actual values. The results obtained in this study can be used as basic data for study on design and operating condition optimization of CO2 capture process using these sorbents.

Optimization of Solid-Phase Extraction Conditions for Perfluorooctanoic Acid in Leachate

In order to optimize the solid phase extraction(SPE)conditions of perfluorooctanoic acid(PFOA)in the raw leachate and treated leachate,the effects of activator properties,SPE cartridge,p H value,ionic strength,and eluent properties were studied through single factor experiments.The optimal results of each single factor were obtained.Considering that the concentration of PFOA in the treated leachate is lower than that of the raw leachate,the SPE conditions of the treated leachate have been further optimized.Based on the above single-factor experiment,the main influencing factors were screened out as the volume of activator,ionic strength,and volume of eluent,and the three-factor threelevel response surface methodology(RSM)was optimized.The optimum SPE conditions of PFOA from treated landfill leachate were as follows:Activation of weak anion exchange(WAX)cartridge with 10 mL methanol,dosage of 600 mg KCl,6 m L 1%ammonia methanol eluted PFOA,the theory recovery rate is over95.67%.It has been verified that the error between the predicted value and the actual extraction recovery is small and has good repeatability.