Electrical Properties of Dead Sea Water

In this paper, dielectric measurements were carried out to obtain conductivity, permittivity (real and imaginary parts) and loss tangent of Dead Sea water. These dielectric properties were measured using two different methods: Vector Network Analyzer “VNA” (Dielectric Assessment Kit “DAK”) and Four Probe method, all measurements taken at room temperature (25˚C). The collected data has been analyzed in the frequency range (200 MHz - 9 GHz), by making a comparison between the measured data for Dead Sea water and distilled water, the results have shown that a huge difference in dielectric properties for the two samples. The conductivity of Dead Sea water is much larger than the conductivity of distilled water, which has been expected because of the fact of the high salinity of Dead Sea water.

Low-cost portable dielectric spectrometer based on mini-vector network analyzer and open-ended coaxial probe technology

As a simple,fast,and non-destructive measuring technology,dielectric spectroscopy is usually used to analyze the dielectric properties of agricultural products and food,and then to predict the main components of materials.However,the large and expensive vector network analyzers(VNA)with expensive analysis software applied in measuring dielectric properties make research limited to the laboratory.To acquire dielectric spectra in situ,a model for solving relative complex permittivity was derived,and its performance was validated.Then,a low-cost portable dielectric spectrometer with a mini VNA,a Raspberry Pi,and a coaxial probe as core parts was developed over the frequency range of 100-3000 MHz.The stability and accuracy of the developed spectrometer were tested using milk and juice.The results indicated that the relative errors of the model were within±5%for dielectric constant(ε′)and loss factor(ε″).The coefficients of variation of measuredε′andε″by the developed spectrometer at 100-3000 MHz were less than 1%and 2%,respectively.Compared with the dielectric properties obtained by using a commercial dielectric measurement system,the relative errors of measuredε′andε″were within±3.4%and±6.0%,respectively.This study makes fast,non-destructive,and on-site food quality detection using dielectric spectra possible.

Recent advances in microwave photonics

Microwave photonics （MWP） is an interdisci- plinary field that combines two different areas of microwave engineering and photonics. It has several key features by transferring signals between the optical domain and microwave domain, which leads to the advantages of broad operation bandwidth for generation, processing and distribution of microwave signals and high resolution for optical spectrum measurement. In this paper, we comprehensively review past and current status of MWP in China by introducing the representative works from most of the active MWP research groups. Future prospective is also discussed fi＇om the national strategy to key enabling technology that we have developed.

Representative volume element of asphalt pavement for electromagnetic measurements

The motivation for this study was to investigate the representative volume element （RVE） needed to correlate the nondestructive electromagnetic （EM） measurements with the con- ventional destructive asphalt pavement quality control measurements. A large pavement rehabilitation contract was used as the test site for the experiment. Pavement cores were drilled from the same locations where the stationary and continuous Ground Penetrating Radar （GPR） measurements were obtained. Laboratory measurements included testing the bulk density of cores using two methods, the surface-saturated dry method and determining bulk density by dimensions. Also, Vector Network Analyzer （VNA） and the through specimen transmission configuration were employed at microwave frequencies to measure the reference dielectric constant of cores using two different footprint areas and therefore vol- ume elements. The RVE for EM measurements turns out to be frequency dependent; therefore in addition to being dependent on asphalt mixture type and method of obtaining bulk density, it is dependent on the resolution of the EM method used. Then, although the average bulk property results agreed with theoretical formulations of higher core air void content giving a lower dielectric constant, for the individual cores there was no correlation for the VNA measurements because the volume element seizes deviated. Similarly, GPR technique was unable to capture the spatial variation of pavement air voids measured from the 150-mm drill cores. More research is needed to determine the usable RVE for asphalt.