Biomechanical behaviors of dragonfly wing:relationship between configuration and deformation

In this paper, the natural structures of a dragonfly wing, including the corrugation of the chordwise cross-section, the sandwich mierostructure veins, and the junctions between the vein and the membrane, have been investigated with experimental observations, and the morphological parameters of these structural features are measured. The experimental result indicates that the corrugated angle among the longitudinal veins ranges from 80° to 150°, and the sandwiched microstructure vein mainly consists of chitin and protein layers. Meanwhile, different finite element models, which include models I and I＊ for the planar forewings, models II and II＊ for the corrugated forewings, and a submodel with solid veins and membranes, are created to investigate the effects of these structural features on the natural frequency/modal, the dynamical behaviors of the flapping flight, and the deformation mechanism of the forewings. The numerical results indicate that the corrugated forewing has a more reasonable natural frequency/modal, and the first order up-down flapping frequency of the corrugated wing is closer to the experimental result （about 27.00 Hz）, which is significantly larger than that of the planar forewing （10.94 Hz）. For the dynamical responses, the corrugated forewing has a larger torsional angle than the planar forewing, but a lower flapping angle. In addition, the sandwich microstructure veins can induce larger amplitudes of torsion deformation, because of the decreasing stiffness of the whole forewing. For the submodel of the forewing, the average stress of the chitin layer is much larger than that of the protein layer in the longitudinal veins. These simulative methods assist us to explain the flapping flight mechanism of the dragonfly and to design a micro aerial vehicle by automatically adjusting the corrugated behavior of the wing.

Optimization of investment casting process parameters to reduce warpage of turbine blade platform in DD6 alloy

The large warping deformation at platform of turbine blade directly affects the forming precision. In the present research, equivalent warping deformation was firstly presented to describe the extent of deformation at platform. To optimize the process parameters during investment casting to minimize the warping deformation of the platform, based on simulation with Pro CAST, the single factor method, orthogonal test, neural network and genetic algorithm were subsequently used to analyze the influence of pouring temperature, shell mold preheating temperature, furnace temperature and withdrawal velocity on dimensional accuracy of the platform of superalloyDD6 turbine blade. The accuracy of investment casting simulation was verified by measurement of platform at blade casting. The simulation results with the optimal process parameters illustrate that the equivalent warping deformation was dramatically reduced by 21.8% from 0.232295 mm to 0.181698 mm.

Simulation Analysis of Stress Field of Walnut Shell Composite Powder in Laser Additive Manufacturing Forming

A calculation model of stress field in laser additive manufacturing of walnut shell composite powder(walnut shell/Co-PES powder)was established.The DFLUX subroutine was used to implement the moveable application of a double ellipsoid heat source by considering the mechanical properties varying with temperature.The stress field was simulated by the sequential coupling method,and the experimental results were in good accordance with the simulation results.In addition,the distribution and variation of stress and strain field were obtained in the process of laser additive manufacturing of walnut shell composite powder.The displacement of laser additive manufacturing walnut shell composite parts gradually decreased with increasing preheating temperature,decreasing laser power and increasing scanning speed.During the cooling process,the displacement of laser additive manufacturing of walnut shell composite parts gradually increased with the increasing preheating temperature,decreasing scanning speed and increasing laser power.