Recovery of carbon monoxide from flue gases by reactive absorption in ionic liquid imidazolium chlorocuprate(I): Mass transfer coefficients

Recovery of carbon monoxide from flue gases by selective absorption of carbon monoxide in an imidazolium chlorocuprate（l） ionic liquid is considered in this work as an alternative to the use of molecular volatile solvents such as aromatic hydrocarbons. The present work evaluates the CO mass transfer rates from the gas phase to the ionic liquid solutions in the absence of chemical reaction. To that end, carbon dioxide was employed as an inert model gas and absorption experiments were performed to assess the influence of different process variables in a batch reactor with fiat gas-liquid interface. The experimental mass transfer coefficients showed significant var- iation with temperature, （3.4-10.9） × 10^-7 m·s^-1 between 293 and 313 K; stirring speed, （10.2- 33.1）× 10^-7 m.s 1 between 100 and 300 r·min^-1; and concentration of copper（1）, （6.6-10.2） × 10^-7 m·s^-1 between 0.25 and 2 mol· L^- 1. In addition, the mass transfer coefficients were eventually found to follow a poten- tial proportionality of the type kL ∝μ^-0.5 and the dimensionless correlation that makes the estimation of the mass transfer coefficients possible in the studied range of process variables was obtained： Sh=10^-2.64 Re^1.07 , Sc^0.75,These results constitute the first step in the kinetic analysis of the reaction between CO and imidazolium chlorocuprate（I） ionic liquid that determines the design of the separation units.

Carbonation of low heat portland cement paste precured in water for different time

The carbonation technique was applied to accelerate the hydration of low heat portland cement （LHC）. Before carbonation, the demoulded pastes were precured in water for 0, 2, 7, and 21 d, respectively. The results show that precuring time in water strongly influences the carbonation process. The phenolphthalein test indicates that the paste precured in water for a shorter time is more quickly carbonated than that for a longer time. The content of calcium hydroxide increases with increasing the precuring time in water, whereas, the amount of absorbed carbon dioxide changes contrarily. Scanning electron microscope （SEM） observation shows that portlandite always fills up big air bubbles in the paste during precuring in water, and the mercury intrusion porosimetry （MIP） results show that there are less large capillary pores in the paste precured in water for a longer time. It is found that the paste without precuring in water has more carbon dioxide absorption during curing in carbon dioxide atmosphere, and its total pore volume decreases remarkably with an increase in the carbonation time than that precured in water. X-ray diffraction （XRD） and Brunauer-Emmett-Teller （BET） surface area analyses indicate that the carbonate products are vaterite and calcite; CxSHy formed from carbonation has low BET surface area in comparison with that of C-S-H formed from curing in water.

Performance of CO_2 absorption in a diameter-varying spray tower

The application of spray towers for CO2 capture is a development trend in recent years. However, most of the previous jobs were conducted in a cylindrical tower by using a single spray nozzle, whose configuration and performance is not good enough for industrial application. To solve this problem, the present work proposed a diameter-varying spray tower and a new spray mode of dual-nozzle opposed impinging spray to enhance the heat and mass transfer of CO2 absorption process. Experiments were performed to investigate the mass transfer performance （in terms of the CO2 removal rate （η） and the overall mass transfer coefficient （KGae）） of the improved spray tower under various operating conditions. Experimental results showed that the liquid to gas ratio and mole ratio of MEA to C02 are major factors, which affect the absorption performance and the maximums of η and KGae that are 94.0% and 0.574 kmol. m^-3·h^-1·kPa^-1, respectively, under the experimental conditions. Furthermore, new correlations to predict the mass transfer coefficient of the proposed spray tower are developed in various CO2 concentrations with a Pearson Correlation Coefficient over 90%.

Efects of amine, amine salt and amide on the behaviour of carbon dioxide absorption into calcium hydroxide suspension to precipitate calcium carbonate

The amount of carbon dioxide （CO2） absorption and calcium ion （Ca^2＋） concentration besides the pH of aqueous solution were observed during the COz absorption to precipitate calcium carbonate （CaCO3） from calcium hydroxide （Ca（OH）2）. A reaction rate-limiting effect of an amount of CO2 absorption without any organic additives in the early stage of the precipitation was observed, which was attributed to an interruption effect of bicarbonate ion （HCO3） on the precipitation of CaCO3. The improvement for the reaction rate was achieved not only by amine additives but also by neutral additives such as ε-caprolactam or amine salt. When the hexamethylene diamine was dissolved in the solution, successive change of crystal forms of CaCO3 aragonite to calcite in aqueous suspensions, confirmed by Ca^2＋ concentration change and X-ray diffraction, was concluded that a local environment around the amine group in aqueous solution and an interaction of the diamine with precipitated CaCO3 particles were important factors for these reactions.

Temperature dependence of line parameters of 12C16O2 near 2.004 μm studied by tunable diode laser spectroscopy

The absorption spectrum of carbon dioxide at 2.004 μm has been recorded at sample temperatures between 218.0 K and room temperature, by using a high-resolution tunable diode laser absorption spectrometer（TDLAS） combined with a temperature controlled cryogenically cooled absorption cell. The self-, N^（2-）, and air-broadening coefficients for nine transitions of ^（12）C^（16）O_2 belonging to the 20012←00001 band in the 4987 cm^（-1）–4998 cm^（-1） region have been measured at different temperatures. From these measurements, we have further determined the temperature dependence exponents of the pressure-broadening coefficients. To the best of our knowledge, the temperature dependence parameters of the collisional broadening coefficients are reported experimentally for the first time for these nine transitions. The measured halfwidth coefficients and the air temperature dependence exponents of these transitions are compared with the available values reported in the literature and HITRAN 2012 database. Agreements and discrepancies are also discussed.

Ground-based remote sensing of atmospheric total column CO_2 and CH_4 by direct sunlight in Hefei

Fourier transform spectrometry has played an important role in the three-dimensional greenhouse gas monitoring as the focus of attention on global warming in the past few years. In this paper, a ground-based low-resolution remote sensing system measuring the total columns of CO2 and CH4 is developed, which tracks the sun automatically and records the spectra in real-time and has the advantages of portability and low cost. A spectral inversion algorithm based on nonlinear least squares spectral fitting procedure for determining the column concentrations of these species is described. Atmospheric transmittance spectra are computed line-by-line in the forward model and observed on-line by direct solar radiation. Also, the wavelength shifts are introduced and the influence of spectral resolution is discussed. Based on this system and algorithm, the vertical columns of O2, CO2, and CH4 are calculated from total atmospheric observation transmittance spectra in Hefei, and the results show that the column averaged dry-air mole fractions of CO2 and CH4 are measured with accuracies of 3.7% and 5%, respectively. Finally, the H2O columns are compared with the results observed by solar radiometer at the same site and the calculated correlation coefficient is 0.92, which proves that this system is suitable for field campaigns and used to monitor the local greenhouse gas sources under the condition of higher accuracy, indirectly.