Absorption linewidth inversion with wavelength modulation spectroscopy

For absorption linewidth inversion with wavelength modulation spectroscopy（WMS）, an optimized WMS spectral line fitting method was demonstrated to infer absorption linewidth effectively, and the analytical expressions for relationships between Lorentzian linewidth and the separations of first harmonic peak-to-valley and second harmonic zero-crossing were deduced. The transition of CO_2 centered at 4991.25 cm^（-1） was used to verify the optimized spectral fitting method and the analytical expressions. Results showed that the optimized spectra fitting method was able to infer absorption accurately and compute more than 10 times faster than the commonly used numerical fitting procedure. The second harmonic zero-crossing separation method calculated an even 6 orders faster than the spectra fitting without losing any accuracy for Lorentzian dominated cases. Additionally, linewidth calculated through second harmonic zero-crossing was preferred for much smaller error than the first harmonic peak-to-valley separation method. The presented analytical expressions can also be used in on-line optical sensing applications, electron paramagnetic resonance, and further theoretical characterization of absorption lineshape.

High-Gain N-Face AlGaN Solar-Blind Avalanche Photodiodes Using a Heterostructure as Separate Absorption and Multiplication Regions

It is well known that -nitride semiconductors can generate the magnitude of MV/cm polarization electric field which is comparable with their ionization electric fields. To take full advantage of the polarization electric field, we design an N-face AlGaN solar-blind avalanche photodiode (APD) with an Al0.45Ga0.55N/Al0.3Ga0.7N heterostructure as separate absorption and multiplication (SAM) regions. The simulation results show that the N-face APDs are more beneficial to improving the avalanche gain and reducing the avalanche breakdown voltage compared with the Ga-face APDs due to the effect of the polarization electric field. Furthermore, the Al0.45Ga0.55N/Al0.3Ga0.7N heterostructure SAM regions used in APDs instead of homogeneous Al0.45Ga0.55N SAM structure can increase significantly avalanche gain because of the increased hole ionization coefficient by using the relatively low Al-content AlGaN in the multiplication region. Meanwhile, a quarter-wave AlGaN/AlN distributed Bragg reflector structure at the bottom of the device is designed to remain a solar-blind characteristic of the heterostructure SAM-APDs.

Investigation of Ga_(2)O_(3)/diamond heterostructure solar-blind avalanche photodiode via TCAD simulation

A Ga_(2)O_(3)/diamond separate absorption and multiplication avalanche photodiode(SAM-APD)with mesa structure has been proposed and simulated.The simulation is based on an optimized Ga_(2)O_(3)/diamond heterostructure TCAD physical model,which is revised by repeated comparison with the experimental data from the literature.Since both Ga_(2)O_(3)and diamond are ultra-wide bandgap semiconductor materials,the Ga_(2)O_(3)/diamond SAM-APD shows good solar-blind detection ability,and the corresponding cutoff wavelength is about 263 nm.The doping distribution and the electric field distribution of the SAM-APD are discussed,and the simulation results show that the gain of the designed device can reach 5×10^(4)and the peak responsivity can reach a value as high as 78 A/W.

SAGCM avalanche photodiode with additional layer and nonuniform electric field

This paper presents a new method to increase the speed of the separated absorption, grading, charge, and multiplication avalanche photodiode （SAGCM-APD）. This improvement is obtained by adding a new thin charge layer between absorption and grading layers, with assuming the non-uniform electric field in different regions of the structure. In addition, a circuit model of the proposed structure is extracted, using carrier rate equations. Also, to achieve the optimum structure, it is tried to have trade-offs among thickness of the layers and have proper tuning of physical parameters. Eventually, frequency and transient response are investigated and it is shown that, in comparison with the previous conventional structure, significant improvements in gain-bandwidth product, speed and also in breakdown voltage are attained.