In this work, a novel hollow fiber membrane extractor was set up to extract inorganic anions from ethyl acetate using deionized water. Inorganic anions in slightly soluble organic solvents can be determined by the in-...In this work, a novel hollow fiber membrane extractor was set up to extract inorganic anions from ethyl acetate using deionized water. Inorganic anions in slightly soluble organic solvents can be determined by the in-line hollow fiber membrane extractor coupled with ion chromatography at first time. Different aspects of the extraction procedure such as magnetic stirring speed, extraction flow rate and extraction time were optimized to achieve high extraction efficiency and good separation results. Satisfactory linear range, limits of detection and good repeatability were obtained. The procedure was applied to analyze inorganic anions in two commercial ethyl acetate samples.展开更多
Catalytic treatments of VOCs at normal temperature can greatly reduce the cost and temperature of processing,and improve the safety factor in line with the requirements of green chemistry.Activated carbon fiber(ACF)wa...Catalytic treatments of VOCs at normal temperature can greatly reduce the cost and temperature of processing,and improve the safety factor in line with the requirements of green chemistry.Activated carbon fiber(ACF)was pretreated with 10%H_(2)SO_(4)by single factor optimization to increase specific surface area and pore volume obviously.The catalytic ozonation performance of ACF loaded with Au,Ag,Pt and Pd noble metals on ethyl acetate was investigated and Pd/ACF was selected as the optimal catalyst which had certain stability.Pd is uniformly distributed on the surface of ACF,and Palladium mainly exists in the form of Pd0 with a amount of Pd+2.The specific surface area of the catalysts gradually decreases as the loading increases.The activation energy of ethyl acetate calculated by Arrhenius equation is 113 kJ mol 1.With 1%Pd loading and the concentration ratio of ozone to ethyl acetate is 3:1,catalytic ozonation performance is maximized and the conversion rate of ethyl acetate reached to 60%in 3050℃Cat 15,00030,000 h^1.展开更多
Concrete containing short carbon-coated-nylon fibers (0.4-2.0 vol. pct) exhibited quasi-ductile response by developing a large damage zone prior to fracture localization. In the damage zone, the material was microcrac...Concrete containing short carbon-coated-nylon fibers (0.4-2.0 vol. pct) exhibited quasi-ductile response by developing a large damage zone prior to fracture localization. In the damage zone, the material was microcracked but continued to local strain-harden. The carbon-coated-nylon-fiber-reinforced concrete composites (NFRC) were found to be an intrinsically smart concrete that could sense elastic and inelastic deformation, as well as fracture. The fibers served to bridge the cracks and the carbon coating gave the conduction path. The signal provided came from the change in electrical resistance, which was reversible for elastic deformation and irreversible for inelastic deformation and fracture. The resistance decrease was due to the reduction of surface touch resistance between fiber and matrix and the crack closure. The resistance irreversible increase resulted from the crack opening and breakage of the carbon coating on nylon fiber.展开更多
Acetalizatioin on the blend fibers of poly(vinyl alcohol) (PVA) and soybean protein (SP) was studied by using dialdehydes as cross-linking agents. The optimal acetalization conditions were determined by Latin square e...Acetalizatioin on the blend fibers of poly(vinyl alcohol) (PVA) and soybean protein (SP) was studied by using dialdehydes as cross-linking agents. The optimal acetalization conditions were determined by Latin square experiment, where the modified fibers with good mechanical properties can be achieved by treating in 41 g/L dialdehyde solution at 67 ℃ for 9 min. The cross-linking reactions of PVA and SP with dialdehydes were confirmed by Fourier transform infrared (FTIR) spectroscopy. Tensile test and boiling water shrinkage measurements showed that the physical properties of PVA/SP fibers crosslinked by dialdehydes were improved comparing with those formalized fibers.展开更多
尼龙6(PA6)树脂具有优异的性能,其连续纤维复合材料在汽车、航空航天领域具有广泛应用。但是PA6树脂熔融后黏度较高,不易对连续纤维充分浸渍,并且连续纤维与PA6的复合材料界面黏附性较差,限制了其复合材料的性能和应用。针对这些问题,...尼龙6(PA6)树脂具有优异的性能,其连续纤维复合材料在汽车、航空航天领域具有广泛应用。但是PA6树脂熔融后黏度较高,不易对连续纤维充分浸渍,并且连续纤维与PA6的复合材料界面黏附性较差,限制了其复合材料的性能和应用。针对这些问题,文中对连续玻璃纤维增强尼龙6(CGF/PA6)复合材料开展了研究。首先,采用阴离子开环聚合制备PA6,确定了其最佳制备工艺;其次,用硅烷偶联剂KH550(AP)对连续玻璃纤维(CGF)进行改性,并对其进行了红外光谱表征;最后,通过原位聚合法制备了CGF/PA6复合材料,研究了AP改性对CGF/PA6复合材料力学性能的影响,并对CGF/PA6复合材料的拉伸断口进行了扫描电镜分析。结果表明,AP被键合到了CGF表面,AP改性可以增强CGF/PA6复合材料的界面黏附性,从而使CGF/PA6复合材料的拉伸强度得到改善,当AP用量为2%时,CGF/PA6复合材料的拉伸强度高达88.52 MPa,此时,复合材料的断裂伸长率最低,为4.90%。CGF/PA6复合材料的冲击强度变化不大,均在50 k J/m2左右,说明复合材料的韧性受CGF表面改性影响较小。展开更多
基金supported by National Natural Science Foundation of China(No.20775070)by Zhejiang Provincial Natural Science Foundation of China(No.R4080124)Zhejiang Qianjiang Project of Science and Technology for Competent People(No.2008R10028).
文摘In this work, a novel hollow fiber membrane extractor was set up to extract inorganic anions from ethyl acetate using deionized water. Inorganic anions in slightly soluble organic solvents can be determined by the in-line hollow fiber membrane extractor coupled with ion chromatography at first time. Different aspects of the extraction procedure such as magnetic stirring speed, extraction flow rate and extraction time were optimized to achieve high extraction efficiency and good separation results. Satisfactory linear range, limits of detection and good repeatability were obtained. The procedure was applied to analyze inorganic anions in two commercial ethyl acetate samples.
基金the National Key R&D Program of the Ministry of Science and Technology,China(Grant No.2018YFC0705304)and the Key Scientific and Technological Support Projects,Tianjin City,China(Grant No.19YFZCSF01090).
文摘Catalytic treatments of VOCs at normal temperature can greatly reduce the cost and temperature of processing,and improve the safety factor in line with the requirements of green chemistry.Activated carbon fiber(ACF)was pretreated with 10%H_(2)SO_(4)by single factor optimization to increase specific surface area and pore volume obviously.The catalytic ozonation performance of ACF loaded with Au,Ag,Pt and Pd noble metals on ethyl acetate was investigated and Pd/ACF was selected as the optimal catalyst which had certain stability.Pd is uniformly distributed on the surface of ACF,and Palladium mainly exists in the form of Pd0 with a amount of Pd+2.The specific surface area of the catalysts gradually decreases as the loading increases.The activation energy of ethyl acetate calculated by Arrhenius equation is 113 kJ mol 1.With 1%Pd loading and the concentration ratio of ozone to ethyl acetate is 3:1,catalytic ozonation performance is maximized and the conversion rate of ethyl acetate reached to 60%in 3050℃Cat 15,00030,000 h^1.
基金This work was supported by the National High Technology Research and Development Program of China under grant No.2002AA324060by the China Postdoctoral Science Foundation under grant 2003033139.
文摘Concrete containing short carbon-coated-nylon fibers (0.4-2.0 vol. pct) exhibited quasi-ductile response by developing a large damage zone prior to fracture localization. In the damage zone, the material was microcracked but continued to local strain-harden. The carbon-coated-nylon-fiber-reinforced concrete composites (NFRC) were found to be an intrinsically smart concrete that could sense elastic and inelastic deformation, as well as fracture. The fibers served to bridge the cracks and the carbon coating gave the conduction path. The signal provided came from the change in electrical resistance, which was reversible for elastic deformation and irreversible for inelastic deformation and fracture. The resistance decrease was due to the reduction of surface touch resistance between fiber and matrix and the crack closure. The resistance irreversible increase resulted from the crack opening and breakage of the carbon coating on nylon fiber.
文摘Acetalizatioin on the blend fibers of poly(vinyl alcohol) (PVA) and soybean protein (SP) was studied by using dialdehydes as cross-linking agents. The optimal acetalization conditions were determined by Latin square experiment, where the modified fibers with good mechanical properties can be achieved by treating in 41 g/L dialdehyde solution at 67 ℃ for 9 min. The cross-linking reactions of PVA and SP with dialdehydes were confirmed by Fourier transform infrared (FTIR) spectroscopy. Tensile test and boiling water shrinkage measurements showed that the physical properties of PVA/SP fibers crosslinked by dialdehydes were improved comparing with those formalized fibers.
文摘尼龙6(PA6)树脂具有优异的性能,其连续纤维复合材料在汽车、航空航天领域具有广泛应用。但是PA6树脂熔融后黏度较高,不易对连续纤维充分浸渍,并且连续纤维与PA6的复合材料界面黏附性较差,限制了其复合材料的性能和应用。针对这些问题,文中对连续玻璃纤维增强尼龙6(CGF/PA6)复合材料开展了研究。首先,采用阴离子开环聚合制备PA6,确定了其最佳制备工艺;其次,用硅烷偶联剂KH550(AP)对连续玻璃纤维(CGF)进行改性,并对其进行了红外光谱表征;最后,通过原位聚合法制备了CGF/PA6复合材料,研究了AP改性对CGF/PA6复合材料力学性能的影响,并对CGF/PA6复合材料的拉伸断口进行了扫描电镜分析。结果表明,AP被键合到了CGF表面,AP改性可以增强CGF/PA6复合材料的界面黏附性,从而使CGF/PA6复合材料的拉伸强度得到改善,当AP用量为2%时,CGF/PA6复合材料的拉伸强度高达88.52 MPa,此时,复合材料的断裂伸长率最低,为4.90%。CGF/PA6复合材料的冲击强度变化不大,均在50 k J/m2左右,说明复合材料的韧性受CGF表面改性影响较小。
