A series of Co/γ-Al_2O_3 catalysts were prepared with the impregnation method and characterized by means of the BET specific surface area, X-ray diffraction(XRD), thermogravimetric analysis(TGA) and Laser Raman spect...A series of Co/γ-Al_2O_3 catalysts were prepared with the impregnation method and characterized by means of the BET specific surface area, X-ray diffraction(XRD), thermogravimetric analysis(TGA) and Laser Raman spectroscopy. The Co/γ-Al_2O_3 catalysts were activated by using H_2, 20%CH_4/H_2 or CH_4, respectively. There was no obvious difference between the activities of the Co/γ-Al_2O_3 catalyst activated by using the different activation methods for methane dry reforming. The catalytic properties of the Co/γ-Al_2O_3 catalysts with different Co loadings were also investigated. The optimized Co loading for the Co/γ-Al_2O_3 catalyst pretreated with 20% CH_4/H_2 is around 12%(mass fraction).展开更多
The activity and thermal stability of Pd/Al2O3 and Pd/（Al2O3＋MOx） （M=Ca, La, Ce） palladium catalysts in the reaction of complete oxidation of methane are presented in this study. The catalyst supports were prepar...The activity and thermal stability of Pd/Al2O3 and Pd/（Al2O3＋MOx） （M=Ca, La, Ce） palladium catalysts in the reaction of complete oxidation of methane are presented in this study. The catalyst supports were prepared by sol-gel method and they were dried either conventionally or with supercritical carbon dioxide. Then they were impregnated with palladium nitrate solution. The catalysts with unmodified alumina had a high surface area. The activity and thermal stability of the aluminasupported catalyst was also very high. The introduction of calcium, lanthanum, or cerium oxide into alumina support caused a decrease of the surface area in the way dependent on the support precursor drying method. These modifiers decreased the activity of palladium catalysts, and they required higher temperatures for the complete oxidation of methane than unmodified Pd/Al2O3. The improvement of the palladium activity by lanthanum and cerium support modifier was observed only at low temperatures of the reaction.展开更多
One-step synthesis of n-butanol from bimolecular condensation of ethanol was firstlyachieved over nickel supported gamma alumina catalyst. A mechanism of dehydration path for thegrowth of carbon chain by eliminating a...One-step synthesis of n-butanol from bimolecular condensation of ethanol was firstlyachieved over nickel supported gamma alumina catalyst. A mechanism of dehydration path for thegrowth of carbon chain by eliminating a hydroxy group from one ethanol molecule with a α-H ofother ethanol molecule rather than aldol condensation was verified.展开更多
Two types of small iron clusters supported on γ-Al2O3-RT（dehydroxylated at room temperature） and γ-Al2O3-800 （dehydroxylated at 800 ℃） were prepared by solvated metal atom impregnation （SMAI） techniques. The ...Two types of small iron clusters supported on γ-Al2O3-RT（dehydroxylated at room temperature） and γ-Al2O3-800 （dehydroxylated at 800 ℃） were prepared by solvated metal atom impregnation （SMAI） techniques. The iron atom precursor complex, bis（toluene）iron（0） formed in the metal atom reactor, was impregnated into γ-Al2O3 having different concentrations of surface hydroxyl groups to study the effect of surface hydroxylation on the crucial stage of iron cluster formation. Catalysts prepared in this way were characterized by TEM, Mǒssbauer, and chemisorption measurements, and the results show that higher concentration of surface hydroxyl groups of γ-Al2O3-RT favors the formation of more positively charged supported iron cluster Fen/γ-Al2O3-RT, and the lower concentration of surface hydroxyl groups of γ-Al2O3-800 favors the formation of basically neutral supported iron cluster Fen/γ-Al2O3-800. The measured results also indicate that the higher concentration of surface hydroxyl groups causes the rapid decomposition of precursor complex, bis（toluene）iron（0）, and favors the formation of relatively large iron cluster. Consequently, these two types of catalysts show different catalytic properties in Fischer-Tropsch reaction. The catalytic pattern of Fen/γ-Al2O3-RT in F-T reaction is similar to that of the unreduced γ-Fe2O3 and that of Fen/γ-Al2O3-800 is similar to that of the reduced α-Fe2O3.展开更多
Supported manganese oxide catalysts were prepared by incipient wetness impregnation method for methane catalytic combustion, and effects of the support （Al2O3, SiO2 and TiO2） and Mn loading were investigated. These ...Supported manganese oxide catalysts were prepared by incipient wetness impregnation method for methane catalytic combustion, and effects of the support （Al2O3, SiO2 and TiO2） and Mn loading were investigated. These catalysts were characterized with N2 adsorption, X-ray diffraction, X-ray photoelectron spectroscopy and temperature-programmed reduction techniques. Methane conversion varied in a large range depending on supports or Mn loading. Al2O3 supported 15% Mn catalyst exhibited better activity toward methane catalytic oxidation. The manganese state and oxygen species played an important role in the catalytic performance,展开更多
Silica, alumina, and activated carbon supported iron-cobalt catalysts were prepared by incipient wetness impregnation. These catalysts have been characterized by BET, X-ray diffraction （XRD）, and temperature-program...Silica, alumina, and activated carbon supported iron-cobalt catalysts were prepared by incipient wetness impregnation. These catalysts have been characterized by BET, X-ray diffraction （XRD）, and temperature-programmed reduction （TPR）. Activity and selectivity of iron-cobalt supported on different carriers for CO hydrogenation were studied under the conditions of 1.5 MPa, 493 K, 630 h^-1, and H2/CO ratio of 1.6. The results indicate that the activity, C4 olefin/（C4 olefin＋C4 paraffin） ratio, and C5 olefin/（C5 olefin＋C5 paraffin） decrease in the order of Fe-Co/SiO2, Fe-Co/AC1, Fe-Co/Al2O3 and Fe- Co/AC2. The activity of Fe-Co/SiO2 reached a maximum. The results of TPR show that the Fe-Co/SiO2 catalyst is to some extent different. XRD patterns show that the Fe-Co/SiO2 catalyst differs significantly from the others; it has two diffraction peaks. The active spinel phase is correlated with the supports.展开更多
文摘A series of Co/γ-Al_2O_3 catalysts were prepared with the impregnation method and characterized by means of the BET specific surface area, X-ray diffraction(XRD), thermogravimetric analysis(TGA) and Laser Raman spectroscopy. The Co/γ-Al_2O_3 catalysts were activated by using H_2, 20%CH_4/H_2 or CH_4, respectively. There was no obvious difference between the activities of the Co/γ-Al_2O_3 catalyst activated by using the different activation methods for methane dry reforming. The catalytic properties of the Co/γ-Al_2O_3 catalysts with different Co loadings were also investigated. The optimized Co loading for the Co/γ-Al_2O_3 catalyst pretreated with 20% CH_4/H_2 is around 12%(mass fraction).
文摘The activity and thermal stability of Pd/Al2O3 and Pd/（Al2O3＋MOx） （M=Ca, La, Ce） palladium catalysts in the reaction of complete oxidation of methane are presented in this study. The catalyst supports were prepared by sol-gel method and they were dried either conventionally or with supercritical carbon dioxide. Then they were impregnated with palladium nitrate solution. The catalysts with unmodified alumina had a high surface area. The activity and thermal stability of the aluminasupported catalyst was also very high. The introduction of calcium, lanthanum, or cerium oxide into alumina support caused a decrease of the surface area in the way dependent on the support precursor drying method. These modifiers decreased the activity of palladium catalysts, and they required higher temperatures for the complete oxidation of methane than unmodified Pd/Al2O3. The improvement of the palladium activity by lanthanum and cerium support modifier was observed only at low temperatures of the reaction.
文摘One-step synthesis of n-butanol from bimolecular condensation of ethanol was firstlyachieved over nickel supported gamma alumina catalyst. A mechanism of dehydration path for thegrowth of carbon chain by eliminating a hydroxy group from one ethanol molecule with a α-H ofother ethanol molecule rather than aldol condensation was verified.
文摘Two types of small iron clusters supported on γ-Al2O3-RT（dehydroxylated at room temperature） and γ-Al2O3-800 （dehydroxylated at 800 ℃） were prepared by solvated metal atom impregnation （SMAI） techniques. The iron atom precursor complex, bis（toluene）iron（0） formed in the metal atom reactor, was impregnated into γ-Al2O3 having different concentrations of surface hydroxyl groups to study the effect of surface hydroxylation on the crucial stage of iron cluster formation. Catalysts prepared in this way were characterized by TEM, Mǒssbauer, and chemisorption measurements, and the results show that higher concentration of surface hydroxyl groups of γ-Al2O3-RT favors the formation of more positively charged supported iron cluster Fen/γ-Al2O3-RT, and the lower concentration of surface hydroxyl groups of γ-Al2O3-800 favors the formation of basically neutral supported iron cluster Fen/γ-Al2O3-800. The measured results also indicate that the higher concentration of surface hydroxyl groups causes the rapid decomposition of precursor complex, bis（toluene）iron（0）, and favors the formation of relatively large iron cluster. Consequently, these two types of catalysts show different catalytic properties in Fischer-Tropsch reaction. The catalytic pattern of Fen/γ-Al2O3-RT in F-T reaction is similar to that of the unreduced γ-Fe2O3 and that of Fen/γ-Al2O3-800 is similar to that of the reduced α-Fe2O3.
基金supported by the New Century Excellent Talent Project of China (NCET-05-0783).
文摘Supported manganese oxide catalysts were prepared by incipient wetness impregnation method for methane catalytic combustion, and effects of the support （Al2O3, SiO2 and TiO2） and Mn loading were investigated. These catalysts were characterized with N2 adsorption, X-ray diffraction, X-ray photoelectron spectroscopy and temperature-programmed reduction techniques. Methane conversion varied in a large range depending on supports or Mn loading. Al2O3 supported 15% Mn catalyst exhibited better activity toward methane catalytic oxidation. The manganese state and oxygen species played an important role in the catalytic performance,
文摘Silica, alumina, and activated carbon supported iron-cobalt catalysts were prepared by incipient wetness impregnation. These catalysts have been characterized by BET, X-ray diffraction （XRD）, and temperature-programmed reduction （TPR）. Activity and selectivity of iron-cobalt supported on different carriers for CO hydrogenation were studied under the conditions of 1.5 MPa, 493 K, 630 h^-1, and H2/CO ratio of 1.6. The results indicate that the activity, C4 olefin/（C4 olefin＋C4 paraffin） ratio, and C5 olefin/（C5 olefin＋C5 paraffin） decrease in the order of Fe-Co/SiO2, Fe-Co/AC1, Fe-Co/Al2O3 and Fe- Co/AC2. The activity of Fe-Co/SiO2 reached a maximum. The results of TPR show that the Fe-Co/SiO2 catalyst is to some extent different. XRD patterns show that the Fe-Co/SiO2 catalyst differs significantly from the others; it has two diffraction peaks. The active spinel phase is correlated with the supports.
