Although the bearing capacity of plate anchors in clay has been studied extensively, the results considering the effects of offshore cyclic loading are relatively rare. In the present study, 1g model tests are carried...Although the bearing capacity of plate anchors in clay has been studied extensively, the results considering the effects of offshore cyclic loading are relatively rare. In the present study, 1g model tests are carried out to investigate the effect of cyclic loading on the bearing capacity of plate anchors in clay. The ultimate pullout capacity of plate anchors in clay decreases as the accumulated plastic shear strain grows due to the strain-softening of clay under cyclic loading. The load-displacement curves of these tests are presented and the effects of overburden stress and cyclic loading amplitude on the strain-softening behavior are discussed.展开更多
The Norwegian Public Roads Administration(NPRA) is planning for an upgrade of the E39 highway route at the westcoast of Norway. Fixed links shall replace ferries at seven fjord crossings. Wide spans and large depths a...The Norwegian Public Roads Administration(NPRA) is planning for an upgrade of the E39 highway route at the westcoast of Norway. Fixed links shall replace ferries at seven fjord crossings. Wide spans and large depths at the crossings combined with challenging subsea topography and environmental loads call for an extension of existing practice. A variety of bridge concepts are evaluated in the feasibility study. The structures will experience significant loads from deadweight, traffic and environment. Anchoring of these forces is thus one of the challenges met in the project. Large-size subsea rock anchors are considered a viable alternative. These can be used for anchoring of floating structures but also with the purpose of increasing capacity of fixed structures. This paper presents first a thorough study of factors affecting rock anchor bond capacity. Laboratory testing of rock anchors subjected to cyclic loading is thereafter presented. Finally, the paper presents a model predicting the capacity of a rock anchor segment, in terms of a ribbed bar, subjected to a cyclic load history. The research assumes a failure mode occurring in the interface between the rock anchor and the surrounding grout. The constitutive behavior of the bonding interface is investigated for anchors subjected to cyclic one-way tensile loads. The model utilizes the static bond capacity curve as a basis, defining the ultimate bond sbuand the slip s1 at τ. A limited number of input parameters are required to apply the model. The model defines the bond-slip behavior with the belonging rock anchor capacity depending on the cyclic load level(τcy/τ), the cyclic load ratio(R= τcy/τcy), and the number of load cycles(N). The constitutive model is intended to model short anchor lengths representing an incremental length of a complete rock anchor.展开更多
In order to determine the reasonable completed dead load state in earth-anchored cable-stayed bridges,a practical method is proposed. The method is based on the rigidly supported continuous beam method and the feasibl...In order to determine the reasonable completed dead load state in earth-anchored cable-stayed bridges,a practical method is proposed. The method is based on the rigidly supported continuous beam method and the feasible zone method,emphasizing on the mutual effect between the self-anchored structural parts and the earth-anchored ones. Three cable-stayed bridge models are designed with the main spans of 1 400 m,including a partially earth-anchored cable-stayed bridge,a cable-stayed-suspension bridge and a fully selfanchored cable-stayed bridge,in which the C50 concrete and Q345 steel are adopted. The partially earthanchored cable-stayed bridge and the cable-stayed-suspension bridge secure lower compressive force in the girder than the fully self-anchored cable-stayed bridge by 25 percent at least. The same is for the material consumption of the whole bridge. Furthermore,the anchor volume is more than 20% lower in the partially earthanchored cable-stayed bridge than that in the cable-stayed-suspension bridge. Consequently,the practical span of cable-stayed bridges can be accordingly extended.展开更多
强震作用下预应力框架锚索可能出现内锚段松脱、锚索拉断等震害,在锚头处设置弹簧是一种新型抗震措施,而弹簧刚度的合理选取对改善锚索受力至关重要。建立在锚头处设置弹簧预应力锚索框架的加固基岩-覆盖层边坡三维数值模型,研究边坡在...强震作用下预应力框架锚索可能出现内锚段松脱、锚索拉断等震害,在锚头处设置弹簧是一种新型抗震措施,而弹簧刚度的合理选取对改善锚索受力至关重要。建立在锚头处设置弹簧预应力锚索框架的加固基岩-覆盖层边坡三维数值模型,研究边坡在不同峰值加速度、不同持时地震波作用下响应规律,调整锚索-弹簧串联体系等效刚度大小,分析坡体永久位移和锚索轴力减载比随弹簧刚度的非线性变化特征;以控制边坡位移及锚索减载效果为目标,提出弹簧组件的合理刚度确定方法。研究表明:随弹簧刚度降低,缓冲减震作用逐渐显著;坡顶水平加速度受刚度变化影响较小,但当弹簧刚度低于临界值后边坡位移及弹簧变形量急剧增加;以边坡永久位移实际调查经验限值为首要控制条件,结合位移、弹簧峰值行程随刚度变化拟合“直-曲分界点”曲线,以共同确定弹簧刚度下限;同理,依据减载比拟合曲线轴力削减明显区段得出刚度上限,以保证一定工程经济性。针对算例模型取永久位移10 cm、拟合曲线曲率k小于0.002 k max作为直曲分界判断依据,得0.4 g~0.6g强震下弹簧刚度区间为(2.5,3.8)kN/mm,研究方法可为边坡预应力锚固工程抗震设计提供参考。展开更多
基金supported by the National Natural Science Foundation of China(51121005 and 51209033)the Natural Science Foundation of Liaoning Province,China(2013020154)the Fundamental Research Funds for the Central Universities of China (DUT14ZD206)
文摘Although the bearing capacity of plate anchors in clay has been studied extensively, the results considering the effects of offshore cyclic loading are relatively rare. In the present study, 1g model tests are carried out to investigate the effect of cyclic loading on the bearing capacity of plate anchors in clay. The ultimate pullout capacity of plate anchors in clay decreases as the accumulated plastic shear strain grows due to the strain-softening of clay under cyclic loading. The load-displacement curves of these tests are presented and the effects of overburden stress and cyclic loading amplitude on the strain-softening behavior are discussed.
基金sponsored by the Norwegian Public Roads Administration(NPRA)
文摘The Norwegian Public Roads Administration(NPRA) is planning for an upgrade of the E39 highway route at the westcoast of Norway. Fixed links shall replace ferries at seven fjord crossings. Wide spans and large depths at the crossings combined with challenging subsea topography and environmental loads call for an extension of existing practice. A variety of bridge concepts are evaluated in the feasibility study. The structures will experience significant loads from deadweight, traffic and environment. Anchoring of these forces is thus one of the challenges met in the project. Large-size subsea rock anchors are considered a viable alternative. These can be used for anchoring of floating structures but also with the purpose of increasing capacity of fixed structures. This paper presents first a thorough study of factors affecting rock anchor bond capacity. Laboratory testing of rock anchors subjected to cyclic loading is thereafter presented. Finally, the paper presents a model predicting the capacity of a rock anchor segment, in terms of a ribbed bar, subjected to a cyclic load history. The research assumes a failure mode occurring in the interface between the rock anchor and the surrounding grout. The constitutive behavior of the bonding interface is investigated for anchors subjected to cyclic one-way tensile loads. The model utilizes the static bond capacity curve as a basis, defining the ultimate bond sbuand the slip s1 at τ. A limited number of input parameters are required to apply the model. The model defines the bond-slip behavior with the belonging rock anchor capacity depending on the cyclic load level(τcy/τ), the cyclic load ratio(R= τcy/τcy), and the number of load cycles(N). The constitutive model is intended to model short anchor lengths representing an incremental length of a complete rock anchor.
基金Sponsored by the National Basic Research Program of China(Grant No.2013CB036303)the National Natural Science Foundation of China(Grant No.51008223)
文摘In order to determine the reasonable completed dead load state in earth-anchored cable-stayed bridges,a practical method is proposed. The method is based on the rigidly supported continuous beam method and the feasible zone method,emphasizing on the mutual effect between the self-anchored structural parts and the earth-anchored ones. Three cable-stayed bridge models are designed with the main spans of 1 400 m,including a partially earth-anchored cable-stayed bridge,a cable-stayed-suspension bridge and a fully selfanchored cable-stayed bridge,in which the C50 concrete and Q345 steel are adopted. The partially earthanchored cable-stayed bridge and the cable-stayed-suspension bridge secure lower compressive force in the girder than the fully self-anchored cable-stayed bridge by 25 percent at least. The same is for the material consumption of the whole bridge. Furthermore,the anchor volume is more than 20% lower in the partially earthanchored cable-stayed bridge than that in the cable-stayed-suspension bridge. Consequently,the practical span of cable-stayed bridges can be accordingly extended.
文摘强震作用下预应力框架锚索可能出现内锚段松脱、锚索拉断等震害,在锚头处设置弹簧是一种新型抗震措施,而弹簧刚度的合理选取对改善锚索受力至关重要。建立在锚头处设置弹簧预应力锚索框架的加固基岩-覆盖层边坡三维数值模型,研究边坡在不同峰值加速度、不同持时地震波作用下响应规律,调整锚索-弹簧串联体系等效刚度大小,分析坡体永久位移和锚索轴力减载比随弹簧刚度的非线性变化特征;以控制边坡位移及锚索减载效果为目标,提出弹簧组件的合理刚度确定方法。研究表明:随弹簧刚度降低,缓冲减震作用逐渐显著;坡顶水平加速度受刚度变化影响较小,但当弹簧刚度低于临界值后边坡位移及弹簧变形量急剧增加;以边坡永久位移实际调查经验限值为首要控制条件,结合位移、弹簧峰值行程随刚度变化拟合“直-曲分界点”曲线,以共同确定弹簧刚度下限;同理,依据减载比拟合曲线轴力削减明显区段得出刚度上限,以保证一定工程经济性。针对算例模型取永久位移10 cm、拟合曲线曲率k小于0.002 k max作为直曲分界判断依据,得0.4 g~0.6g强震下弹簧刚度区间为(2.5,3.8)kN/mm,研究方法可为边坡预应力锚固工程抗震设计提供参考。
