To address the problem of the weak anti-noise and macro-trend extraction abilities of the current methods for identifying radar antenna scan type,a recognition method for radar antenna scan types based on limited pene...To address the problem of the weak anti-noise and macro-trend extraction abilities of the current methods for identifying radar antenna scan type,a recognition method for radar antenna scan types based on limited penetrable visibility graph(LPVG)is proposed.Firstly,seven types of radar antenna scans are analyzed,which include the circular scan,sector scan,helical scan,raster scan,conical scan,electromechanical hybrid scan and two-dimensional electronic scan.Then,the time series of the pulse amplitude in the radar reconnaissance receiver is converted into an LPVG network,and the feature parameters are extracted.Finally,the recognition result is obtained by using a support vector machine(SVM)classifier.The experimental results show that the recognition accuracy and noise resistance of this new method are improved,where the average recognition accuracy for radar antenna type is at least 90%when the signalto-noise ratio(SNR)is 5 dB and above.展开更多
The Z-type ferrites of nominal composition Ba3Co2 Fe24O41+x wt% Bi2O3, where x=0.25, 0.5, 1.0, 1.5, 2.0, were prepared by conventional ceramic processes. The influence of Bi2O3 content on the bulk densities, microstru...The Z-type ferrites of nominal composition Ba3Co2 Fe24O41+x wt% Bi2O3, where x=0.25, 0.5, 1.0, 1.5, 2.0, were prepared by conventional ceramic processes. The influence of Bi2O3 content on the bulk densities, microstructures, magnetic and dielectric properties of Z-type ferrite samples were systematically examined so as to obtain materials with low magnetic and dielectric loss tangent over a frequency ranging from 600 to 800 MHz. The experimental results showed that addition of Bi2O3 lowered the sintering temperature(1 020 ℃) and then reduced the average grain size(<2 μm) and enhanced the resistivity(>2.68×10^8 Ω·cm) dramatically, which consequently decreased the magnetic and dielectric loss. Additionally, the low loss factors were observed at the Bi2O3 content x = 1.0, i e, tan δμ/μ’=0.013 and tan δε/ε’= 0.001 at 800 MHz, and such materials could be used for antennas miniaturization from 600 to 800 MHz.展开更多
In this article, a low-profile wideband dual-polarized planar printed dipole antenna, fed by coaxial lines, is investigated for the TD-SCDMA operation. The antenna is composed of two printed dipoles, two pairs of feed...In this article, a low-profile wideband dual-polarized planar printed dipole antenna, fed by coaxial lines, is investigated for the TD-SCDMA operation. The antenna is composed of two printed dipoles, two pairs of feeding coaxial lines and a ground. The single-polarized planar printed rectangular dipole and petal dipole, with the similar configuration, are first studied, exhibiting the potential wideband operation. Two petal dipoles are then cross-arranged to design a dual-polarized planar printed antenna, giving a lower profile and a better bandwidth covering the Chinese TD-SCDMA band (1880-2400 MHz). The dual-polarized antenna is simply excited by two pairs of coaxial feeds. Simulated and measured results show that the antenna achieves a common impedance bandwidth of 42% at both ports, good isolation of more than 25 dB, stable radiation patterns and the gain of about 7 dBi over the operating bandwidth.展开更多
基金supported by the China Postdoctoral Science Foundation(2015M572694,2016T90979).
文摘To address the problem of the weak anti-noise and macro-trend extraction abilities of the current methods for identifying radar antenna scan type,a recognition method for radar antenna scan types based on limited penetrable visibility graph(LPVG)is proposed.Firstly,seven types of radar antenna scans are analyzed,which include the circular scan,sector scan,helical scan,raster scan,conical scan,electromechanical hybrid scan and two-dimensional electronic scan.Then,the time series of the pulse amplitude in the radar reconnaissance receiver is converted into an LPVG network,and the feature parameters are extracted.Finally,the recognition result is obtained by using a support vector machine(SVM)classifier.The experimental results show that the recognition accuracy and noise resistance of this new method are improved,where the average recognition accuracy for radar antenna type is at least 90%when the signalto-noise ratio(SNR)is 5 dB and above.
基金Funded by the National Natural Science Foundation of China(No.U1435209)Wuhan Science and Technology Program(No.2014010101010018)Fundamental Research Funds for the Central Universities(No.2015ZZGH007)
文摘The Z-type ferrites of nominal composition Ba3Co2 Fe24O41+x wt% Bi2O3, where x=0.25, 0.5, 1.0, 1.5, 2.0, were prepared by conventional ceramic processes. The influence of Bi2O3 content on the bulk densities, microstructures, magnetic and dielectric properties of Z-type ferrite samples were systematically examined so as to obtain materials with low magnetic and dielectric loss tangent over a frequency ranging from 600 to 800 MHz. The experimental results showed that addition of Bi2O3 lowered the sintering temperature(1 020 ℃) and then reduced the average grain size(<2 μm) and enhanced the resistivity(>2.68×10^8 Ω·cm) dramatically, which consequently decreased the magnetic and dielectric loss. Additionally, the low loss factors were observed at the Bi2O3 content x = 1.0, i e, tan δμ/μ’=0.013 and tan δε/ε’= 0.001 at 800 MHz, and such materials could be used for antennas miniaturization from 600 to 800 MHz.
文摘In this article, a low-profile wideband dual-polarized planar printed dipole antenna, fed by coaxial lines, is investigated for the TD-SCDMA operation. The antenna is composed of two printed dipoles, two pairs of feeding coaxial lines and a ground. The single-polarized planar printed rectangular dipole and petal dipole, with the similar configuration, are first studied, exhibiting the potential wideband operation. Two petal dipoles are then cross-arranged to design a dual-polarized planar printed antenna, giving a lower profile and a better bandwidth covering the Chinese TD-SCDMA band (1880-2400 MHz). The dual-polarized antenna is simply excited by two pairs of coaxial feeds. Simulated and measured results show that the antenna achieves a common impedance bandwidth of 42% at both ports, good isolation of more than 25 dB, stable radiation patterns and the gain of about 7 dBi over the operating bandwidth.
