Cramer-Rao bound and signal-to-noise ratio gain in distributed coherent aperture radar

This paper studies the estimation performance of the coherent processing parameter （CPP）, including time delay differences and phase synchronization errors among different apertures of the distributed coherent aperture radar （DCAR）. Firstly, three architectures of signal processing in the DCAR are introduced. Secondly, the closed-form Cramer-Rao bound （CRB） of the CPP estimation is derived and compared. Then, the closed-form CRB is verified by numerical simulations. Finally, when the next generation radar works in a fully coherent mode, the closed-form signal-to-noise ratio （SNR） gain of the three architectures is presented.

Distributed inverse synthetic aperture radar imaging of ship target with complex motion

For ship targets with complex motion,it is difficult for the traditional monostatic inverse synthetic aperture radar(ISAR)imaging to improve the cross-range resolution by increasing of accumulation time.In this paper,a distributed ISAR imaging algorithm is proposed to improve the cross-range resolution for the ship target.Multiple stations are used to observe the target in a short time,thereby the effect of incoherence caused by the complex motion of the ship can be reduced.The signal model of ship target with three-dimensional(3-D)rotation is constructed firstly.Then detailed analysis about the improvement of crossrange resolution is presented.Afterward,we propose the methods of parameters estimation to solve the problem of the overlap or gap,which will cause a loss of resolution and is necessary for subsequent processing.Besides,the compressed sensing(CS)method is applied to reconstruct the echoes with gaps.Finally,numerical simulations are presented to verify the effectiveness and the robustness of the proposed algorithm.

Apparent activation energy of mineral in open pit mine based upon the evolution of active functional groups

This study aimed to investigate the mechanism of mineral spontaneous combustion in an open pit. On the study of coal and mineral mixture in open pit mines, as well as through the specifc surface area and Search Engine Marketing (SEM) experiments, the specifc surface area and aperture characteristics of distribution of open pit coal sample and pit mineral mixture samples were analyzed. Thermal analysis experiments were used to divide the oxidation process was divided into three stages, and the thermal behavior characteristics of experimental samples were characterized. On the basis of the stage division, we explored the transfer law of the key active functional groups of the experimental samples. The apparent activation energy calculation of the key active groups, performed by combining the Achar diferential method with the Coats–Redfern integral method, microstructural and oxidation kinetic properties were revealed. The resulted showed that the mixed sample had high ash, the fxed carbon content was reduced, the specifc surface area was far lower than the raw coal, the large aperture distribution was slightly higher than the medium hole, the micropore was exceptionally low, the gas adsorption capacity was weaker than the raw coal, the pit coal sample had the exceedingly more active functional groups, easy to react with oxygen, more likely to occur naturally, and its harm was relatively large. The mixed sample contained the highest C–O–C functional group absorbance. The functional groups were mainly infuenced by the self-OH content, alkyl side chain, and fatty hydrocarbon in the sample. The main functional groups of the four-like mixture had the highest apparent activation energy, and the two reactions were higher in the low-temperature oxidation phase.

Phase synchronization processing method for alternating bistatic mode in distributed SAR

In the distributed synthetic aperture radar （SAR）, the alternating bistatic mode can perform phase reference without a synchronization link between two satellites compared with the pulsed alternate synchronization method. The key of the phase synchronization processing is to extract the oscillator phase differences from the bistatic echoes. A signal model of phase synchronization in the alternating bistatic mode is presented. The phase synchronization processing method is then studied. To reduce the phase errors introduced by SAR imaging, a sub-aperture processing method is proposed. To generalize the sub-aperture processing method, an echo-domain processing method using correlation of bistatic echoes is proposed. Finally, the residual phase errors of the both proposed processing methods are analyzed. Simulation experiments validate the proposed phase synchronization processing method and its phase error analysis results.

Detection performance analysis for MIMO radar with distributed apertures in Gaussian colored noise

This paper establishes the classic linear model of signal of the MIMO radar system with distributed apertures. Based on this model, the design principle and detection performance of MIMO radar detector is investigated under conditions of Gaussian colored noise and partially correlated observation channels. First, the research on design principle of detector shows that the clutter suppression and matched filtering can be independently implemented at each receiving aperture, which greatly reduces the difficulty in implementation of these detectors. Based on these results, a Max detector is proposed for the case where partial channels are disabled due to strong noise and stealth techniques. The second part is the performance analysis of detector. The Fishier divergence coefficient and the statistical equivalent decomposition of limit statistics are used to theoretically analyze the detection performance of AMF detector, and then the analytical expressions of the detection performance of the AMF detector is derived. Analysis results show that both the colored nature of noise and the correlation among observation channels can reduce the capability of spatial diversity of the MIMO radar system, change the target RCSs among observation channels from quick fluctuation to slow fluctuation, and degenerate the detection performance of this radar system into that of the phased array radar system at high signal-to-noise ratio.

Time and phase synchronization using clutter observations in airborne distributed coherent aperture radars

Airborne Distributed Coherent Aperture Radar(ADCAR)is one of the most promising next-generation radars to significantly improve target detection and discrimination abilities.However,time and phase synchronization among unit radars should be done before an ADCAR is intended to cohere on a potential target.To address this problem,a time and phase synchronization technique using clutter observations is proposed in this paper.Clutter returns from different azimuths and elevations on the surface of the earth are employed to calibrate system uncertainties.Two stages are mainly considered:a scene registration among range-Doppler units from different transmit/receive pairs is performed to enhance the clutter coherence in the first stage,followed by a joint estimation of those synchronization errors in the second stage.To relieve the computational burden,a novel Separable and Sequential Estimation(SSE)method is provided to separate the unknowns at the sacrifice of a range-Doppler unit.Moreover,performance analyses including the clutter coherence ability,estimation lower bound,and signal coherence loss are also performed.Finally,simulation results indicate that ADCAR time and phase synchronization is realized by using our methods.

Nonuniform Three-dimensional Configuration Distributed SAR Signal Reconstruction Clutter Suppression

This paper deals with the problem of clutter suppression in spaceborne distributed synthetic aperture radar （D-SAR） with nonuniform three-dimensional （3D） configuration geometry. In order to make a breakthrough of the configuration limitation of the traditional space time adaptive processing （STAP） based on uniform array and improve the inhomogeneous clutter suppres- sion performance, this paper considers signal reconstrtiction technique using array interpolation to process the D-SAR signal. An array interpolation signal reconstruction method based on pitching-partition is derived then a signal reconstruction 3D-STAP clutter suppression method applied to nonuniform 3D configuration is proposed. In particular, the proposed method is compared with conventional methods and the performance analysis is carried out based on simulations. The improvement factor （IF） for clutter suppression is imported and reported as a benchmark on the clutter suppression effect.