Ethanol based foamed asphalt as potential alternative for low emission asphalt technology

Foamed asphalt typically relies on water as a foaming agent because water becomes gaseous at elevated temperatures, generating numerous tiny bubbles in the asphalt and causing spontaneous foaming. In this study, ethanol was used as a potential alternative to water as a foaming agent. Ethanol is expected to be a physical blowing agent in the same manner as water, except it requires less energy to foam due to its 78 ℃ boiling point. This study compares the performance of water and ethanol as foaming agents through the measurements of rotational viscosity, the reduction in temperature during foaming, and volatile loss. The ethanol-foamed asphalt binders were prepared at 80 ~C and 100 ~C, while the water-foamed asphalt binders were prepared at 100 ~C and 120 ~＇C. Additionally, the rolling thin film oven （RTFO） was used to generate short-term aging of the foamed asphalt binders. A rotational viscometer was used to determine the viscosity of the asphalt binders at 80 ~C, 100 ~C, 120 ~C, 140 ~C, and 160 ~C. Overall, ethanol can function in the same manner as water but requires less energy to foam. It is proven based on the smaller drop in temperature of the asphalt binder foamed using ethanol compared with that prepared with water. This is due to the lower latent heat capacity of ethanol, which requires less energy to vaporize compared with water. Through the rotational viscometer test, ethanol performs better in lowering the viscosity of asphalt binders, which is essential in allowing produc- tion processes at low temperatures, as well as a better workability and aggregate coating. Ethanol can be expelled from the foamed asphalt binders at a higher rate due to its lower boiling point and latent heat.

Ageing and performance of warm mix asphalt pavements

This paper presents results from investigating the ageing behaviour and performance of different warm mix asphalt （WMA） pavement mixtures also called energy reduced pavements. The mixtures were either prepared in the laboratory or taken directly from a mixing plant. The study compared the rutting and fatigue behaviours of unaged material in comparison to long term laboratory aged material. In order to conduct the long term ageing, a special laboratory ageing protocol with different heating, cooling and watering cycles had been developed. The investigation revealed a quite controversial rutting behavior which could not be explained with the available data. While most aged energy reduced pavements showed increased rutting for other mixtures, lower rut depths could be found. As opposed to this finding, fatigue and stiffness of all aged energy reduced pave- ment samples compared to unaged samples improved significantly. The overall results led to the conclusion that the ageing of energy reduced pavement simulated in the laboratory is not very critical regarding their mechanical performance. Therefore, it was confrmed that the application of this type of pavement provides a good solution for saving on CO2 emissions. Another advantage is that by using energy reduced pavements the road con- struction season can be significantly prolonged.