This paper presented an automatic gain control （AGC） circuit suitable for FM/cw ladar. The proposed architecture was based on two-stage variable gain amplifier （VGA） chain with a novel DC offset canceller circuit,...This paper presented an automatic gain control （AGC） circuit suitable for FM/cw ladar. The proposed architecture was based on two-stage variable gain amplifier （VGA） chain with a novel DC offset canceller circuit, which contained an improved Gilbert cell and a Gm-C feedback loop. To keep the VGA with a linearity in dB characteristic, an improved exponential gain control circuit was introduced. The AGC was implemented in 0.18 gm standard CMOS process. Simulation and measurement results verified that its gain ranged from -20 dB to 30 dB, and band- width ranged from 100 kHz to 10 MHz. Its power consumption was 19.8 mW under a voltage supply of 3.3 V.展开更多
High signal-to-noise ratio can be achieved with the electron multiplying charge-coupled-device（EMCCD） applied in the Shack–Hartmann wavefront sensor（S–H WFS） in adaptive optics（AO）.However,when the brightness ...High signal-to-noise ratio can be achieved with the electron multiplying charge-coupled-device（EMCCD） applied in the Shack–Hartmann wavefront sensor（S–H WFS） in adaptive optics（AO）.However,when the brightness of the target changes in a large scale,the fixed electron multiplying（EM） gain will not be suited to the sensing limitation.Therefore an auto-gain-control method based on the brightness of light-spots array in S–H WFS is proposed in this paper.The control value is the average of the maximum signals of every light spot in an array,which has been demonstrated to be kept stable even under the influence of some noise and turbulence,and sensitive enough to the change of target brightness.A goal value is needed in the control process and it is predetermined based on the characters of EMCCD.Simulations and experiments have demonstrated that this auto-gain-control method is valid and robust,the sensing SNR reaches the maximum for the corresponding signal level,and especially is greatly improved for those dim targets from 6 to 4 magnitude in the visual band.展开更多
In order to effectively control the working state of the gyroscope in drive mode, the drive characteristics of the micro electromechanical system （MEMS） gyroscope are analyzed in principle. A novel drive circuit for...In order to effectively control the working state of the gyroscope in drive mode, the drive characteristics of the micro electromechanical system （MEMS） gyroscope are analyzed in principle. A novel drive circuit for the MEMS gyroscope in digital closed-loop control is proposed, which utilizes a digital phase-locked loop （PLL） in frequency control and an automatic gain control （AGC） method in amplitude control. A digital processing circuit with a field programmable gate array （FPGA） is designed and the experiments are carried out. The results indicate that when the temperature changes, the drive frequency can automatically track the resonant frequency of gyroscope in drive mode and that of the oscillating amplitude holds at a set value. And at room temperature, the relative deviation of the drive frequency is 0.624 ×10^-6 and the oscillating amplitude is 8.0 ×10^-6, which are 0. 094% and 18. 39% of the analog control program, respectively. Therefore, the control solution of the digital PLL in frequency and the AGC in amplitude is feasible.展开更多
基金Supported by the National Science and Technology Major Project of the Ministry of Science and Technology of China(No.2012ZX03004008)
文摘This paper presented an automatic gain control （AGC） circuit suitable for FM/cw ladar. The proposed architecture was based on two-stage variable gain amplifier （VGA） chain with a novel DC offset canceller circuit, which contained an improved Gilbert cell and a Gm-C feedback loop. To keep the VGA with a linearity in dB characteristic, an improved exponential gain control circuit was introduced. The AGC was implemented in 0.18 gm standard CMOS process. Simulation and measurement results verified that its gain ranged from -20 dB to 30 dB, and band- width ranged from 100 kHz to 10 MHz. Its power consumption was 19.8 mW under a voltage supply of 3.3 V.
基金Project supported by the National Natural Science Foundation of China(Grant Nos.11174274,61205021,and 61405194)the State Key Laboratory of Applied Optics,Changchun Institute of Optics,Fine Mechanics and Physics,Chinese Academy of Sciences
文摘High signal-to-noise ratio can be achieved with the electron multiplying charge-coupled-device（EMCCD） applied in the Shack–Hartmann wavefront sensor（S–H WFS） in adaptive optics（AO）.However,when the brightness of the target changes in a large scale,the fixed electron multiplying（EM） gain will not be suited to the sensing limitation.Therefore an auto-gain-control method based on the brightness of light-spots array in S–H WFS is proposed in this paper.The control value is the average of the maximum signals of every light spot in an array,which has been demonstrated to be kept stable even under the influence of some noise and turbulence,and sensitive enough to the change of target brightness.A goal value is needed in the control process and it is predetermined based on the characters of EMCCD.Simulations and experiments have demonstrated that this auto-gain-control method is valid and robust,the sensing SNR reaches the maximum for the corresponding signal level,and especially is greatly improved for those dim targets from 6 to 4 magnitude in the visual band.
基金The National Natural Science Foundation of China(No. 60974116 )the Research Fund of Aeronautics Science (No.20090869007)Specialized Research Fund for the Doctoral Program of Higher Education (No. 200902861063)
文摘In order to effectively control the working state of the gyroscope in drive mode, the drive characteristics of the micro electromechanical system （MEMS） gyroscope are analyzed in principle. A novel drive circuit for the MEMS gyroscope in digital closed-loop control is proposed, which utilizes a digital phase-locked loop （PLL） in frequency control and an automatic gain control （AGC） method in amplitude control. A digital processing circuit with a field programmable gate array （FPGA） is designed and the experiments are carried out. The results indicate that when the temperature changes, the drive frequency can automatically track the resonant frequency of gyroscope in drive mode and that of the oscillating amplitude holds at a set value. And at room temperature, the relative deviation of the drive frequency is 0.624 ×10^-6 and the oscillating amplitude is 8.0 ×10^-6, which are 0. 094% and 18. 39% of the analog control program, respectively. Therefore, the control solution of the digital PLL in frequency and the AGC in amplitude is feasible.
