Characteristics of gully bed scour and siltation between check dams

Check dams are the most commonly used engineering measure for debris flow control worldwide.The scour and siltation characteristics between dams are important factors affecting dam design.In this study,classical dimensional analysis of the variables that influence the development of gully bed scour and siltation was carried out.Flume experiments were conducted to examine the influence characteristics of opening width,flume slope,debris flow density,and opening rate on the characteristics of gully bed scour and siltation.The influential characteristics of variables on the dimensionless scour depth,scour length,siltation length,scour volume and siltation volume were obtained.The experiments showed that,with an increase in the relative opening from 1.5 to 2.5,scour depth increased by 7.4%,scour length decreased by 11.2%,siltation length increased by 22.0%,scour volume decreased by 4.7%and siltation volume increased by 22.0%.With an increase in flume gradient from 0.105 to 0.213,scour depth,siltation length and siltation volume increased by 40.0%,65.9%and 65.9%,respectively,and scour length decreased by 20.1%.With an increase in sediment concentration from 0.303 to 0.545,siltation length and siltation volume increased by 15.4%and 15.4%,respectively,and scour depth,scour length and scour volume decreased by 9.6%,9.1%and 17.8%,respectively.As opening rate increased from 0.08 to 0.32,siltation length and siltation volume increased by 33.3%and 33.3%,respectively,and scour depth,scour length and scour volume decreased by 5.4%,13.7%and 18.4%,respectively.The results showed that the flume gradient was the most influential factor on scour depth,scour length,siltation length and siltation volume,and the sediment concentration was the most influential factor on scour volume.Then,according to the experimental data,some empirical formulas predicting scour depth,scour length,siltation length,scour volume and siltation volume were obtained.The error between the computed values according to the formulas in this paper and the observed values was within±10%.These research results may provide a technological basis for window dam design in debris flow disaster prevention and mitigation.

Numerical Study of Flow Features Around Submerged Circular and Square Piles at Flat and Scoured Beds Using OpenFOAM

Elucidating the flow features around piles in local scouring processes is crucial for studies of local scouring mechanisms and scour depth estimates.This study details the flow turbulence characteristics of two submerged piles that are determined by solving the Navier-Stokes equations with the improved delayed detached eddy simulation model.This model is verified by comparing experimental and numerical results for hydrodynamic parameters with the literature for both square-crossing piles(SCPs)and circular-crossing piles(CCPs).Original topographies of flat and scoured beds(i.e.,the initial and equilibrium scouring stages)are based on experimental results obtained by the authors in the present paper.SCP and CCP flow features in the scouring process are discussed.The results indicate that during the scouring process,the time-averaged drag coefficient and root mean square(rms)of the lift coefficient increase linearly in the CCP test,while the rms of the lift coefficient in the SCP test decreases linearly.Moreover,the minimum pressure coefficient is always located in the upstream corners in the SCP case but moves from 72.5°to 79.5°when the scour hole is completely developed in the CCP case.Downward flow behind the pile,which is generated by separated boundary layers above the top face of the pile,can reach the sand bed and turn the separated shear layers into patches of small vortices in the near-wake regions.Thus,the high shear stress zones are mainly at the scour edges under scoured-bed conditions.