We study the impact of various modulation mapping strategies and signal constellation shapes on the se- crecy rates achievable with bit-interleaved coded modulation （BICM） schemes. Transmission over an ergodic Rayle...We study the impact of various modulation mapping strategies and signal constellation shapes on the se- crecy rates achievable with bit-interleaved coded modulation （BICM） schemes. Transmission over an ergodic Rayleigh fading channel is assumed throughout this work. Various constellations and mapping techniques are considered in this work to maximize the capacity difference between the main channel and the eavesdropper channel, rather than to opti- mize the capacity of both channels. We show that in terms of achievable secrecy rate, Gray and Quasi-Gray mappings only perform Well at low SNR but outperformed by other mapping techniques when SNR increases. The proper design of signal mapping can significantly enhance the achievable secrecy rate in BICM schemes. It is indicated that the key parameter to the secrecy rate of a BICM system is the distance spectrum of Euclidean distances for mappings.展开更多
Iterative demodulation and decoding scheme is analyzed and modulation labeling is considered to be one of the crucial factors to this scheme. By analyzing the existent mapping design criterion, four aspects are found ...Iterative demodulation and decoding scheme is analyzed and modulation labeling is considered to be one of the crucial factors to this scheme. By analyzing the existent mapping design criterion, four aspects are found as the key techniques for choosing a label mapping. Based on this discovery, a novel mapping design criteflon is proposed and two label mappings are searched according to it. Simulation results show that the performance of BICM-ID using the novel mappings is better than the former ones. The extrinsic information transfer （EXIT） chart is introduced and it is used to evaluate the proposed mapping design criteria.展开更多
The demodulation and decoding solution commonly used in the bit interleaving code modulation and the LDPC coded demodulation and decoding system of the iterative decoding （BICM-ID） is to report the soft information ...The demodulation and decoding solution commonly used in the bit interleaving code modulation and the LDPC coded demodulation and decoding system of the iterative decoding （BICM-ID） is to report the soft information output from the decoder of the receiver to the demodulator as priori information for completing the decoding. However, this will give rise to the reduction of the minimum Euclidean distances between codes, so that the performances of the system decline under non-fading Gaussian channel. According to this problem, an optimized iterative demodulation decoding solution is proposed and also is analyzed using simulation. The result shows that this solution can improve the demodulation and decoding performances of LDPC coded modulation and demodulation system.展开更多
The Q-ary low-density parity-check（LDPC） coded high order partial response continuous phase modulation（PR-CPM） with double iterative loops is investigated. This scheme shows significant improvements in power and b...The Q-ary low-density parity-check（LDPC） coded high order partial response continuous phase modulation（PR-CPM） with double iterative loops is investigated. This scheme shows significant improvements in power and bandwidth efficiency, but at the expense of long iterative decoding delay and computational complexity induced by the improper match between the demodulator and the decoder. To address this issue, the convergence behavior of Q-ary LDPC coded CPM is investigated for the Q=2 and Q〉2 cases, and an optimized design method based on the extrinsic information transfer chart is proposed to improve the systematic iterative efficiency. Simulation results demonstrate that the proposed method can achieve a perfect tradeoff between iterative decoding delay and bit error rate performance to satisfy real-time applications.展开更多
Mapping design criteria of bit-interleaved coded modulation with iterative decoding (BICM-ID) with square 16QAM are analyzed. Three of the existing criteria are analyzed and compared with each other. Through the compa...Mapping design criteria of bit-interleaved coded modulation with iterative decoding (BICM-ID) with square 16QAM are analyzed. Three of the existing criteria are analyzed and compared with each other. Through the comparison, two main characters of the mapping design criteria are found. They are the harmonic mean of the minimum squared Euclidean distance and the average of Hamming distances with the nearest Euclidean distance. Based on these two characters, a novel mapping design criterion is proposed and a label mapping named mixed mapping is searched according to it. Simulation results show that mixed mapping performs better than the other mappings in BICM-ID system.展开更多
Bit-interleaved coded modulation (BICM) is suitable to bandwidth-efficient communication systems. Hybrid automatic repeat request (HARQ) can provide more reliability to high-speed wireless data transmission. A new pat...Bit-interleaved coded modulation (BICM) is suitable to bandwidth-efficient communication systems. Hybrid automatic repeat request (HARQ) can provide more reliability to high-speed wireless data transmission. A new path weight complementary convolutional (PWCC) code used in the type-Ⅱ BICM-HARQ system is proposed. The PWCC code is composed of the original code and the complimentary code. The path in trellis with large hamming weight of the complimentary code is designed to compensate for the path in trellis with small hamming weight of the original code. Hence, both of the original code and the complimentary code can achieve the performance of the good code criterion of corresponding code rate. The throughput efficiency of the BICM-HARQ system wit PWCC code is higher than repeat code system, a little higher than puncture code system in low signal-to-noise ratio (SNR) values and much higher than puncture code system, the same as repeat code system in high SNR values. These results are confirmed by the simulation.展开更多
为了研究Polar码在编码调制(CM)系统中的性能,提出了一种基于Polar码的比特交织编码调制(BICM)系统.分析了高斯白噪声(AWGN)信道中不同调制方式对系统误比特率(BER)性能的影响,并将所提系统的BER性能与基于低密度奇偶校验(LDPC)码的BIC...为了研究Polar码在编码调制(CM)系统中的性能,提出了一种基于Polar码的比特交织编码调制(BICM)系统.分析了高斯白噪声(AWGN)信道中不同调制方式对系统误比特率(BER)性能的影响,并将所提系统的BER性能与基于低密度奇偶校验(LDPC)码的BICM系统性能进行了对比.仿真结果表明,在QPSK调制下,基于Polar码的BICM系统与基于Polar码的无编码调制系统的BER曲线几乎完全重合;而在16QAM调制下,当码长较大时,基于Polar码的BICM系统较基于Polar码的无编码调制系统最大节省0.8 d B的比特信噪比.当信道编码码长为1 024、码率为0.5时,在中高比特信噪比区域上,基于Polar码的BICM系统可比基于LDPC码的BICM系统获得至少2 d B的比特信噪比增益.展开更多
文摘We study the impact of various modulation mapping strategies and signal constellation shapes on the se- crecy rates achievable with bit-interleaved coded modulation （BICM） schemes. Transmission over an ergodic Rayleigh fading channel is assumed throughout this work. Various constellations and mapping techniques are considered in this work to maximize the capacity difference between the main channel and the eavesdropper channel, rather than to opti- mize the capacity of both channels. We show that in terms of achievable secrecy rate, Gray and Quasi-Gray mappings only perform Well at low SNR but outperformed by other mapping techniques when SNR increases. The proper design of signal mapping can significantly enhance the achievable secrecy rate in BICM schemes. It is indicated that the key parameter to the secrecy rate of a BICM system is the distance spectrum of Euclidean distances for mappings.
文摘Iterative demodulation and decoding scheme is analyzed and modulation labeling is considered to be one of the crucial factors to this scheme. By analyzing the existent mapping design criterion, four aspects are found as the key techniques for choosing a label mapping. Based on this discovery, a novel mapping design criteflon is proposed and two label mappings are searched according to it. Simulation results show that the performance of BICM-ID using the novel mappings is better than the former ones. The extrinsic information transfer （EXIT） chart is introduced and it is used to evaluate the proposed mapping design criteria.
文摘The demodulation and decoding solution commonly used in the bit interleaving code modulation and the LDPC coded demodulation and decoding system of the iterative decoding （BICM-ID） is to report the soft information output from the decoder of the receiver to the demodulator as priori information for completing the decoding. However, this will give rise to the reduction of the minimum Euclidean distances between codes, so that the performances of the system decline under non-fading Gaussian channel. According to this problem, an optimized iterative demodulation decoding solution is proposed and also is analyzed using simulation. The result shows that this solution can improve the demodulation and decoding performances of LDPC coded modulation and demodulation system.
基金supported by the National Natural Science Foundation of China(61403093)the Science Foundation of Heilongjiang Province of China for Returned Scholars(LC2013C22)the Assisted Project by Heilongjiang Province of China Postdoctoral Funds for Scientific Research Initiation(LBH-Q14048)
文摘The Q-ary low-density parity-check（LDPC） coded high order partial response continuous phase modulation（PR-CPM） with double iterative loops is investigated. This scheme shows significant improvements in power and bandwidth efficiency, but at the expense of long iterative decoding delay and computational complexity induced by the improper match between the demodulator and the decoder. To address this issue, the convergence behavior of Q-ary LDPC coded CPM is investigated for the Q=2 and Q〉2 cases, and an optimized design method based on the extrinsic information transfer chart is proposed to improve the systematic iterative efficiency. Simulation results demonstrate that the proposed method can achieve a perfect tradeoff between iterative decoding delay and bit error rate performance to satisfy real-time applications.
文摘Mapping design criteria of bit-interleaved coded modulation with iterative decoding (BICM-ID) with square 16QAM are analyzed. Three of the existing criteria are analyzed and compared with each other. Through the comparison, two main characters of the mapping design criteria are found. They are the harmonic mean of the minimum squared Euclidean distance and the average of Hamming distances with the nearest Euclidean distance. Based on these two characters, a novel mapping design criterion is proposed and a label mapping named mixed mapping is searched according to it. Simulation results show that mixed mapping performs better than the other mappings in BICM-ID system.
基金the National Natural Science Foundation of China(Nos. 60302006 and 60462002)
文摘Bit-interleaved coded modulation (BICM) is suitable to bandwidth-efficient communication systems. Hybrid automatic repeat request (HARQ) can provide more reliability to high-speed wireless data transmission. A new path weight complementary convolutional (PWCC) code used in the type-Ⅱ BICM-HARQ system is proposed. The PWCC code is composed of the original code and the complimentary code. The path in trellis with large hamming weight of the complimentary code is designed to compensate for the path in trellis with small hamming weight of the original code. Hence, both of the original code and the complimentary code can achieve the performance of the good code criterion of corresponding code rate. The throughput efficiency of the BICM-HARQ system wit PWCC code is higher than repeat code system, a little higher than puncture code system in low signal-to-noise ratio (SNR) values and much higher than puncture code system, the same as repeat code system in high SNR values. These results are confirmed by the simulation.
文摘为了研究Polar码在编码调制(CM)系统中的性能,提出了一种基于Polar码的比特交织编码调制(BICM)系统.分析了高斯白噪声(AWGN)信道中不同调制方式对系统误比特率(BER)性能的影响,并将所提系统的BER性能与基于低密度奇偶校验(LDPC)码的BICM系统性能进行了对比.仿真结果表明,在QPSK调制下,基于Polar码的BICM系统与基于Polar码的无编码调制系统的BER曲线几乎完全重合;而在16QAM调制下,当码长较大时,基于Polar码的BICM系统较基于Polar码的无编码调制系统最大节省0.8 d B的比特信噪比.当信道编码码长为1 024、码率为0.5时,在中高比特信噪比区域上,基于Polar码的BICM系统可比基于LDPC码的BICM系统获得至少2 d B的比特信噪比增益.
