Dynamic performance of cable-stayed bridge tower with multi-stage pendulum mass damper under wind excitations——I:Theory

In this paper, wind-induced vibration control of a single column tower of a cable-stayed bridge with a multi- stage pendulum mass damper （MSPMD） is investigated. Special attention is given to overcoming space limitations for installing the control device in the tower and the effect of varying natural frequency of the towers during construction. First, the finite element model of the bridge during its construction and the basic equation of motion of the MSPMD are introduced. The equation of motion of the bridge with the MSPMD under along-wind excitation is then established. Finally, a numerical simulation and parametric study are conducted to assess the effectiveness of the control system for reducing the wind-induced vibration of the bridge towers during construction. The numerical simulation results show that the MSPMD is practical and effective for reducing the along-wind response of the single column tower, can be installed in a small area of the tower, and complies with the time-variant characteristics of the bridge during its entire construction stage.

Dynamic performance of cable-stayed bridge tower with multi-stage pendulum mass damper under wind excitations—Ⅱ: Experiment

The possibility of using a multi-stage pendulum mass damper （MSPMD） to control wind-induced vibration of a single column tower of a cable-stayed bridge during construction was studied theoretically in part I of this work. In this paper, the performance of the MSPMD for reducing bridge tower vibration is studied experimentally. A MSPMD model and a tower model of the bridge with geometry scaling of 1：100 were designed and manufactured. Calibration of the MSPMD model with different wire lengths is conducted to verify the analytical model of the damper. A series of tests for the uncontrolled freestanding tower, tower with cables, and tower with MSPMD model are then performed under harmonic and white noise excitations. The experimental results show that the responses of the tower model significantly decrease with the installation of the MSPMD model, which demonstrates the effectiveness of the M SPMD to mitigate the vibration of the bridge tower.

Shake table experimental study of cable-stayed bridges with two different design strategies of H-shaped towers

As one of the main load-carrying components of cable-stayed bridges,bridge towers are typically required to remain elastic even when subjected to severe ground motions with a 2%-3%probability of exceedance in 50 years.To fulfill this special requirement imposed by current seismic design codes,reinforcement ratios in the bridge towers have to be kept significantly higher than if limited ductility behavior of the tower is allowed.In addition,since the foundation capacity is closely related to the moment and shear capacities of the bridge tower,a large increase in bridge construction cost for elastically designed cable-stayed bridge is inevitable.To further investigate the possibility of limited ductility bridge tower design strategies,a new 1/20-scale cable-stayed bridge model with H-shaped bridge towers designed according to strong strut-weak tower column design was tested.The shake table experimental results are compared with a previous strong tower column-weak strut designed full bridge model.A comparison of the results show that ductility design with plastic hinges located on tower columns,i.e.,strong strut-weak tower column design,is another effective seismic design strategy that results in only small residual displacement at the top of the tower column,even under very severe earthquake excitations.

朝天门大桥关键临时结构的施工与监控

重庆朝天门大桥为世界最大的公轨两用钢桁架拱桥,主桁拱采用平衡悬臂拼装法施工,施工阶段中最大悬臂长度276m。为解决大悬臂施工难题,朝天门大桥建设采用新颖的带铰斜拉扣挂系统和临时系杆。通过对斜拉扣挂系统、临时系杆的施工及监控,并对索力、应力、位移进行动态监测,结果表明:主桁拱、斜拉扣挂系统和临时系杆线型和应力均处于安全受控状态。朝天门大桥已于2009年4月底建成通车,对大跨度临时结构的施工与监控具有借鉴意义。

General design of Sutong Bridge

The main span of Sutong Bridge is a double-pylon,double-plane cable-stayed bridge with steel box girder,which has the world's longest central span of 1 088 m within cable-stayed bridges.To overcome problems caused by severe meteorological conditions,perplexing hydrological conditions,deep buried bedrock and higher navigation level,many new technics and methods were created.Keys including structural system,steel box girder,stayed cable,tower,pier,tower foundation,collision avoidance system,wind-resistance,seismic-resistance,structural nonlinear response and structural static stability were presented individually in this paper.

Seismic design of high-rise towers for cable-stayed bridges under strong earthquakes

This paper presents the first of a series of studies on the seismic design of high-rise towers for cablestayed bridges under strong earthquakes.One practical cable-stayed bridge with a 730 m long main span and two high-rise towers over 200 m in height was selected for this study.The preliminary results show that compared with piers,the tower is more vulnerable to pulse-like earthquakes,and it may develop plasticity at certain locations.In addition,viscous dampers may not have the same effect during pulse-like earthquakes as they do under site-specific earthquakes.Hence,reoptimization of damper parameters or reconsideration of other energy dissipation devices will be needed if strong earthquakes are likely to occur.