Chitosan derived from crab shells, was used to prepare the graft polymer in aqueous solution with acrylamide （AM） and methacrylatoethyl trimethyl ammonium chloride （DMC） as raw materials and ceric ammonium nitrate...Chitosan derived from crab shells, was used to prepare the graft polymer in aqueous solution with acrylamide （AM） and methacrylatoethyl trimethyl ammonium chloride （DMC） as raw materials and ceric ammonium nitrate （CAN） as initiator. The flocculation ability of the resulting polymer （PCAD） was studied in waste water treatment experiments. Its properties were determined on the basis of the transmittance of waste water after flocculation. The effects of ehitosan and DMC content on PCAD＇s flocculation ability were studied. Floeculation experiments were also undertaken under various pH conditions. According to the experimental data, the flocculation ability could be improved when chitosan content decreased in the raw material, but the monomer conversion would decrease obviously. When the ehitosan＇s content was more than 65%, AM and DMC groups were less on each chitosan molecule. So PCAD＇s flocculation ability was poor. Similarly, high content of DMC would result in low monomer conversion and high flocculation ability. PCAD molecules with more DMC group had more positive charges. It was favorable to flocculation. However, monomer conversion would decrease with the increase of DMC content. The suitable conditions were that chitosan and DMC contents were 65% and 15-20%, respectively. The experiment data showed that PCAD had good flocculation ability under weak acidic condition. Its ability would be weakened by strong acidic or alkaline condition. The flocculation efficiency was the best at pH of 5.5 when PCAD＇s dosage was 8mg-Lk Compared with cationic polymer （the copolymer of AM and DMC, PAD）, PCAD showed better flocculation ability under acid and neutral conditions, but worse ability under alkaline condition.展开更多
The N alkyl chitosans were prepared from chitosan through Schiff base formation and hydrogenation. The adsorption properties of N alkyl chitosans, bearing the same substitution degree but different carbon chain length...The N alkyl chitosans were prepared from chitosan through Schiff base formation and hydrogenation. The adsorption properties of N alkyl chitosans, bearing the same substitution degree but different carbon chain length and vice versa for Cu(Ⅱ), Hg(Ⅱ) and Pb(Ⅱ) have been investigated. It is found that chitosan derivatives of the same carbon chain length show the highest adsorption capacity for tested ions, when their substitution degree is ranged in 0 35～0 39. And among the chitosan derivatives bearing the same substitution degree, N pentyl chitosan shows the highest adsorption capacity towards mentioned ions.展开更多
基金supported by Young Scientist Foundation (2008BS09001) from the Department of Science and Technology of Shandong Province
文摘Chitosan derived from crab shells, was used to prepare the graft polymer in aqueous solution with acrylamide （AM） and methacrylatoethyl trimethyl ammonium chloride （DMC） as raw materials and ceric ammonium nitrate （CAN） as initiator. The flocculation ability of the resulting polymer （PCAD） was studied in waste water treatment experiments. Its properties were determined on the basis of the transmittance of waste water after flocculation. The effects of ehitosan and DMC content on PCAD＇s flocculation ability were studied. Floeculation experiments were also undertaken under various pH conditions. According to the experimental data, the flocculation ability could be improved when chitosan content decreased in the raw material, but the monomer conversion would decrease obviously. When the ehitosan＇s content was more than 65%, AM and DMC groups were less on each chitosan molecule. So PCAD＇s flocculation ability was poor. Similarly, high content of DMC would result in low monomer conversion and high flocculation ability. PCAD molecules with more DMC group had more positive charges. It was favorable to flocculation. However, monomer conversion would decrease with the increase of DMC content. The suitable conditions were that chitosan and DMC contents were 65% and 15-20%, respectively. The experiment data showed that PCAD had good flocculation ability under weak acidic condition. Its ability would be weakened by strong acidic or alkaline condition. The flocculation efficiency was the best at pH of 5.5 when PCAD＇s dosage was 8mg-Lk Compared with cationic polymer （the copolymer of AM and DMC, PAD）, PCAD showed better flocculation ability under acid and neutral conditions, but worse ability under alkaline condition.
文摘The N alkyl chitosans were prepared from chitosan through Schiff base formation and hydrogenation. The adsorption properties of N alkyl chitosans, bearing the same substitution degree but different carbon chain length and vice versa for Cu(Ⅱ), Hg(Ⅱ) and Pb(Ⅱ) have been investigated. It is found that chitosan derivatives of the same carbon chain length show the highest adsorption capacity for tested ions, when their substitution degree is ranged in 0 35～0 39. And among the chitosan derivatives bearing the same substitution degree, N pentyl chitosan shows the highest adsorption capacity towards mentioned ions.
