Methane (CH4) and carbon dioxide (C02) surface emissions from Polesgo's landfill (Ouagadougou, Burkina Faso) were measured using the static chamber technique in 2017 and 2018. The Polesgo's landfill was compos...Methane (CH4) and carbon dioxide (C02) surface emissions from Polesgo's landfill (Ouagadougou, Burkina Faso) were measured using the static chamber technique in 2017 and 2018. The Polesgo's landfill was composed of four zones: Phase I, II, Phase III, and SP. The surface of Phase I was fully covered and its conditions are better for surface emission measurements. As results concerning the Phase I zone, the geospatial means flux rates of CH4 (657 mg m-2 h l in 2017 and 1210 mg m 2 h_, in 2018, respectively) are measured higher than the tolerable value reported in literature. The emitted CH4 or C 02 have permitted to locate higher surface emissions which are related to the cover state. The calculated gas collection efficiency (27.4% in 2017 and 23.0% in 2018) is low compared to those reported for landfills integrating landfill gas (LFG) extraction system. The carbon footprint calculations (24,966 tC02-eq 2017 and 40,025 tC02-eq in 2018, respectively) shown that Polesgo's landfill is a significant source of greenhouse gases (GHG) and its important potential for organic recovery can contribute to reduce the carbon footprint.展开更多
In this paper,transient electromagnetic method was used to carry out the feasibility study on the detection and recognition of chamber blasting misfire.Firstly,an electromagnetic background field was established in th...In this paper,transient electromagnetic method was used to carry out the feasibility study on the detection and recognition of chamber blasting misfire.Firstly,an electromagnetic background field was established in the test;secondly,a benign conductor was preset in the chamber,and then the background field was eliminated after the electromagnetic field was measured;thirdly,the transient electromagnetic field was measured again after blasting;at last,the chamber blasting misfire was detected and recognized by comparing the change of eddy current field of the preset benign conductor before and after blasting.The test results showed that:When the buried depth of aluminum box target was no more than 30 m,transient electromagnetic method can clearly identify the position of the aluminum box;when the buried depth of aluminum box was more than30 m,the buried depth and position of the aluminum box was not sure due to the unknown level of secondary eddy current field generated by aluminum box.展开更多
[目的]气候变化新形势下,进一步筛选适宜西北地区抗寒、抗抽干葡萄砧木品种,可为葡萄免埋土栽培推广提供理论依据和技术支撑。[方法]本文以41Bmgt、Riparia、420Bmgt、101-14、196-17、44-53ma、110R、Rupestris du Lot、SO4、161-490、...[目的]气候变化新形势下,进一步筛选适宜西北地区抗寒、抗抽干葡萄砧木品种,可为葡萄免埋土栽培推广提供理论依据和技术支撑。[方法]本文以41Bmgt、Riparia、420Bmgt、101-14、196-17、44-53ma、110R、Rupestris du Lot、SO4、161-490、1103P、5BB、3309、Leon Millt共14种13年生葡萄砧木为试材,通过测定离体一年生枝条累计失水速率,结合田间调查葡萄砧木存活率和离体一年生枝条抽干率,以此来评价不同葡萄砧木品种抗抽干能力;结合前人研究及砧木品种特性,采用高低温交变试验箱模拟低温的方法,设置4(对照)、-15、-20、-25和-30℃一系列温度梯度水平,测定不同葡萄砧木一年生枝条相对电导率、丙二醛、游离脯氨酸、可溶性糖及可溶性蛋白5个生理生化指标,利用隶属函数法进行综合评价不同葡萄砧木的抗寒性。[结果]不同葡萄砧木的抗抽干能力由强到弱依次为:3309>161-490>196-17>Leon Millt>420Bmgt>44-53ma>Riparia>110R>1103P>SO4>101-14>41Bmgt>5BB>Rupestris du Lot;随着处理温度的降低,不同葡萄砧木枝条的抗寒指标总体呈现上升趋势,但不同品种之间存在差异。根据隶属函数的综合分析,结果显示各葡萄砧木的抗寒性由强到弱依次为:SO4>196-17>Leon Millt>5BB>Riparia>44-53ma>420Bmgt>1103P>3309>110R>Rupestris du Lot>101-14>41Bmgt>161-490。[结论]Riparia、196-17、44-53ma和Leon Millt具有较强的抗抽干能力和抗寒性,可作为我国西北地区免埋土葡萄砧木使用。展开更多
In order to exactly provide scientific basis for pressure dynamic balance control of working chamber of earth pressure balance shield (EPBS),study on optimal arrangement of pressure measurement points in working chamb...In order to exactly provide scientific basis for pressure dynamic balance control of working chamber of earth pressure balance shield (EPBS),study on optimal arrangement of pressure measurement points in working chamber was conducted. Based on mathematical description of optimal arrangement for pressure measurement points,fuzzy clustering analysis and discriminant analysis were used to divide pressure regions of nodes on bulkhead. Finally,the selection method of optimal measurement points was proposed,and by selecting d6.28 m EPBS as study object,the case study was conducted. By contrast,based on optimal arrangement scheme of pressure measurement points,through adopting weighted algorithm,the absolute error mean of equivalent pressure of working chamber is the smallest. In addition,pressure curve of optimal arrangement points presents parabola,and it can show the state of pressure distribution on bulkhead truly. It is concluded that the optimal arrangement method of pressure measurement points in working chamber is effective and feasible,and the method can provide basis for realizing high precision pressure control of EPBS.展开更多
Current output dose measurement in CT is based on (CTDI). The conventional methodology of CT dosimetric performance characterization is not appropriate to modern CT scanners with helical scanning modes, dose modulatio...Current output dose measurement in CT is based on (CTDI). The conventional methodology of CT dosimetric performance characterization is not appropriate to modern CT scanners with helical scanning modes, dose modulation, array detectors and multiple slice planes or cone-beam irradiation geometries. AAPM TG 111 report recognizes the shortfall of the CTDI methods and recommends a new technique that more accurately characterizes the dose profile from modern CT scanners, which utilizes a short conventional ion chamber rather than a pencil chamber. We developed and characterize a in-house phantom design using a three separate anatomical regions of clinical scan sequences (Head, chest and abdomen), and determined the equilibrium dose in our dose equilibrium phantom, measured if the attenuation of the beam is the equal to that of CTDI Perspex phantom and compare CTDI dose estimations using a standard pencil chamber to the dose equilibrium phantom measurements. This methodology allows measurements of the accumulated dose for any clinical scan length and allowing measurement of the equilibrium dose. Using the new methodology, we determined that the CTDI approach can underestimate the dose by 25% to 35% and all of our dose values from the water phantom and farmer chamber were independently verified with TLD measurements.展开更多
文摘Methane (CH4) and carbon dioxide (C02) surface emissions from Polesgo's landfill (Ouagadougou, Burkina Faso) were measured using the static chamber technique in 2017 and 2018. The Polesgo's landfill was composed of four zones: Phase I, II, Phase III, and SP. The surface of Phase I was fully covered and its conditions are better for surface emission measurements. As results concerning the Phase I zone, the geospatial means flux rates of CH4 (657 mg m-2 h l in 2017 and 1210 mg m 2 h_, in 2018, respectively) are measured higher than the tolerable value reported in literature. The emitted CH4 or C 02 have permitted to locate higher surface emissions which are related to the cover state. The calculated gas collection efficiency (27.4% in 2017 and 23.0% in 2018) is low compared to those reported for landfills integrating landfill gas (LFG) extraction system. The carbon footprint calculations (24,966 tC02-eq 2017 and 40,025 tC02-eq in 2018, respectively) shown that Polesgo's landfill is a significant source of greenhouse gases (GHG) and its important potential for organic recovery can contribute to reduce the carbon footprint.
文摘In this paper,transient electromagnetic method was used to carry out the feasibility study on the detection and recognition of chamber blasting misfire.Firstly,an electromagnetic background field was established in the test;secondly,a benign conductor was preset in the chamber,and then the background field was eliminated after the electromagnetic field was measured;thirdly,the transient electromagnetic field was measured again after blasting;at last,the chamber blasting misfire was detected and recognized by comparing the change of eddy current field of the preset benign conductor before and after blasting.The test results showed that:When the buried depth of aluminum box target was no more than 30 m,transient electromagnetic method can clearly identify the position of the aluminum box;when the buried depth of aluminum box was more than30 m,the buried depth and position of the aluminum box was not sure due to the unknown level of secondary eddy current field generated by aluminum box.
基金Project supported by China Postdoctoral Science Foundation （20100481488）, Key Fund Project of Advanced Research of the Weapon Equipment （9140A33040512JB3401）.
文摘[目的]气候变化新形势下,进一步筛选适宜西北地区抗寒、抗抽干葡萄砧木品种,可为葡萄免埋土栽培推广提供理论依据和技术支撑。[方法]本文以41Bmgt、Riparia、420Bmgt、101-14、196-17、44-53ma、110R、Rupestris du Lot、SO4、161-490、1103P、5BB、3309、Leon Millt共14种13年生葡萄砧木为试材,通过测定离体一年生枝条累计失水速率,结合田间调查葡萄砧木存活率和离体一年生枝条抽干率,以此来评价不同葡萄砧木品种抗抽干能力;结合前人研究及砧木品种特性,采用高低温交变试验箱模拟低温的方法,设置4(对照)、-15、-20、-25和-30℃一系列温度梯度水平,测定不同葡萄砧木一年生枝条相对电导率、丙二醛、游离脯氨酸、可溶性糖及可溶性蛋白5个生理生化指标,利用隶属函数法进行综合评价不同葡萄砧木的抗寒性。[结果]不同葡萄砧木的抗抽干能力由强到弱依次为:3309>161-490>196-17>Leon Millt>420Bmgt>44-53ma>Riparia>110R>1103P>SO4>101-14>41Bmgt>5BB>Rupestris du Lot;随着处理温度的降低,不同葡萄砧木枝条的抗寒指标总体呈现上升趋势,但不同品种之间存在差异。根据隶属函数的综合分析,结果显示各葡萄砧木的抗寒性由强到弱依次为:SO4>196-17>Leon Millt>5BB>Riparia>44-53ma>420Bmgt>1103P>3309>110R>Rupestris du Lot>101-14>41Bmgt>161-490。[结论]Riparia、196-17、44-53ma和Leon Millt具有较强的抗抽干能力和抗寒性,可作为我国西北地区免埋土葡萄砧木使用。
基金Project(2007CB714006) supported by the National Basic Research Program of China
文摘In order to exactly provide scientific basis for pressure dynamic balance control of working chamber of earth pressure balance shield (EPBS),study on optimal arrangement of pressure measurement points in working chamber was conducted. Based on mathematical description of optimal arrangement for pressure measurement points,fuzzy clustering analysis and discriminant analysis were used to divide pressure regions of nodes on bulkhead. Finally,the selection method of optimal measurement points was proposed,and by selecting d6.28 m EPBS as study object,the case study was conducted. By contrast,based on optimal arrangement scheme of pressure measurement points,through adopting weighted algorithm,the absolute error mean of equivalent pressure of working chamber is the smallest. In addition,pressure curve of optimal arrangement points presents parabola,and it can show the state of pressure distribution on bulkhead truly. It is concluded that the optimal arrangement method of pressure measurement points in working chamber is effective and feasible,and the method can provide basis for realizing high precision pressure control of EPBS.
文摘Current output dose measurement in CT is based on (CTDI). The conventional methodology of CT dosimetric performance characterization is not appropriate to modern CT scanners with helical scanning modes, dose modulation, array detectors and multiple slice planes or cone-beam irradiation geometries. AAPM TG 111 report recognizes the shortfall of the CTDI methods and recommends a new technique that more accurately characterizes the dose profile from modern CT scanners, which utilizes a short conventional ion chamber rather than a pencil chamber. We developed and characterize a in-house phantom design using a three separate anatomical regions of clinical scan sequences (Head, chest and abdomen), and determined the equilibrium dose in our dose equilibrium phantom, measured if the attenuation of the beam is the equal to that of CTDI Perspex phantom and compare CTDI dose estimations using a standard pencil chamber to the dose equilibrium phantom measurements. This methodology allows measurements of the accumulated dose for any clinical scan length and allowing measurement of the equilibrium dose. Using the new methodology, we determined that the CTDI approach can underestimate the dose by 25% to 35% and all of our dose values from the water phantom and farmer chamber were independently verified with TLD measurements.
