A variable-bit-rate characteristic waveform interpolation (VBR-CWI) speech codec with about 1.8 kbit/s average bit rate which integrates phonetic classification into characteristic waveform (CW) decomposition is p...A variable-bit-rate characteristic waveform interpolation (VBR-CWI) speech codec with about 1.8 kbit/s average bit rate which integrates phonetic classification into characteristic waveform (CW) decomposition is proposed. Each input frame is classified into one of 4 phonetic classes. Non-speech frames are represented with Bark-band noise model. The extracted CWs become rapidly evolving waveforms (REWs) or slowly evolving waveforms (SEWs) in the cases of unvoiced or stationary voiced frames respectively, while mixed voiced frames use the same CW decomposition as that in the conventional CWI. Experimental results show that the proposed codec can eliminate most buzzy and noisy artifacts existing in the fixed-bit-rate characteristic waveform interpolation (FBR-CWI) speech codec, the average bit rate can be much lower, and its reconstructed speech quality is much better than FS 1 016 CELP at 4.8 kbit/s and similar to G. 723.1 ACELP at 5.3 kbit/s.展开更多
Large property contrasts between materials in a fault zone and the surrounding rock are often produced by repeating earthquakes. Fault zones are usually characterized by fluid concentration, clay-rich fault gouge, inc...Large property contrasts between materials in a fault zone and the surrounding rock are often produced by repeating earthquakes. Fault zones are usually characterized by fluid concentration, clay-rich fault gouge, increased porosity, and dilatant cracks. Thus, fault zones are thought to have reduced seismic velocities than the surrounding rocks. In this article, we first investigated the synthetic waveforms at a linear array across a vertical fault zone by using 3D finite difference simulation. Synthetic waveforms show that when sources are close to, inside, or below the fault zone, both arrival times and waveforms of P-and S-waves vary systematically across the fault zone due to reflections and transmissions from boundaries of the low-velocity fault zone. The arrival-time patterns and waveform characteristics can be used to determine the fault zone structure. Then, we applied this method to the aftershock waveform data of the 1992 Landers M7.4 and the 2008 Wenchuan (汶川) M8.0 earthquakes. Landers waveform data reveal a low-velocity zone with a width of approximately 270-370 m, and P-and S-wave velocity reductions relative to the host rock of approximately 35%-60%; Wenchuan waveform data suggest a low-velocity zone with a width of approximately 220-300 m, and P-and S-wave velocities drop relative to the host rock of approximately 55%.展开更多
文摘A variable-bit-rate characteristic waveform interpolation (VBR-CWI) speech codec with about 1.8 kbit/s average bit rate which integrates phonetic classification into characteristic waveform (CW) decomposition is proposed. Each input frame is classified into one of 4 phonetic classes. Non-speech frames are represented with Bark-band noise model. The extracted CWs become rapidly evolving waveforms (REWs) or slowly evolving waveforms (SEWs) in the cases of unvoiced or stationary voiced frames respectively, while mixed voiced frames use the same CW decomposition as that in the conventional CWI. Experimental results show that the proposed codec can eliminate most buzzy and noisy artifacts existing in the fixed-bit-rate characteristic waveform interpolation (FBR-CWI) speech codec, the average bit rate can be much lower, and its reconstructed speech quality is much better than FS 1 016 CELP at 4.8 kbit/s and similar to G. 723.1 ACELP at 5.3 kbit/s.
基金supported by the Open Fund of the Key Labo-ratory of Geo-detection (China University of Geosciences, Bei-jing),Ministry of Education (No. GDL0708)
文摘Large property contrasts between materials in a fault zone and the surrounding rock are often produced by repeating earthquakes. Fault zones are usually characterized by fluid concentration, clay-rich fault gouge, increased porosity, and dilatant cracks. Thus, fault zones are thought to have reduced seismic velocities than the surrounding rocks. In this article, we first investigated the synthetic waveforms at a linear array across a vertical fault zone by using 3D finite difference simulation. Synthetic waveforms show that when sources are close to, inside, or below the fault zone, both arrival times and waveforms of P-and S-waves vary systematically across the fault zone due to reflections and transmissions from boundaries of the low-velocity fault zone. The arrival-time patterns and waveform characteristics can be used to determine the fault zone structure. Then, we applied this method to the aftershock waveform data of the 1992 Landers M7.4 and the 2008 Wenchuan (汶川) M8.0 earthquakes. Landers waveform data reveal a low-velocity zone with a width of approximately 270-370 m, and P-and S-wave velocity reductions relative to the host rock of approximately 35%-60%; Wenchuan waveform data suggest a low-velocity zone with a width of approximately 220-300 m, and P-and S-wave velocities drop relative to the host rock of approximately 55%.