Experimental study of C-band microwave scattering characteristics during the emulsification process of oil spills

In this study,oil spill experiments were performed in a water tank to determine changes in the surface scattering characteristics during the emulsification of oil spills.A C-band fully-polarimetric microwave scatterometer and a vector network analyzer were used to observe films of the following oils:crude oil with an asphalt content below3%that is prone to emulsification(type A),fresh crude oil extracted from an oilfield(type B),and industrial crude oil that was dehydrated and purified(type C).The difference in the backscatter results between the emulsified oil film and the calm water surface under C-band microwaves and the influence of the emulsification of the oil film on the backscatter were analyzed in detail.The results demonstrate that under a low-wind and no-waves condition(the maximum wave height was below than 3 mm),the emulsification of crude oil could modulated the backscatter through changes in the surface roughness and the dielectric constant,where the surface roughness had the dominant effect.The surface backscatters of the type B oil were greater than that of the type C oil in both the emulsified and non-emulsified states.In the non-emulsified state,the average differences in the backscatter between the type B and C oils were 2.19 dB,2.63 dB,and 2.21 dB for the polarization modes of VV,HH,and HV/VH,respectively.Smaller corresponding average differences of 0.98 dB,1.49 dB,and 1.5 dB were found for the emulsified state with a 20%moisture constant for the oil film.The results demonstrated that the surface roughness of the different oil films could vary due to the differences in the oil compositions and the oil film properties,which in turn affect the backscatter of the oil film surface.

Control Factors and Diversities of Phase State of Oil and Gas Pools in the Kuqa Petroleum System

Based on the analysis of the hydrocarbon geochemical characteristics in the Kuqa petroleum system of the Tarim Basin, this study discusses the causes and controlling factors of the phase diversities and their differences in geochemical features. According to the characteristics and differences in oil and gas phase, the petroleum system can be divided into five categories： oil reservoir, wet gas reservoir, condensate gas-rich reservoir, condensate gas-poor reservoir and dry gas reservoir. The causes for the diversities in oil and gas phases include diversities of the sources of parent material, maturity of natural gas and the process of hydrocarbon accumulation of different hydrocarbon phases. On the whole, the Jurassic and Triassic terrestrial source rocks are the main sources for the hydrocarbon in the Kuqa Depression. The small differences in parent material may cause diversities in oil and gas amount, but the impact is small. The differences in oil and gas phase are mainly affected by maturity and the accumulation process, which closely relates with each other. Oil and gas at different thermal evolution stage can be captured in different accumulation process.