Effect of Strain and Chloride Concentration on Pitting Susceptibility for Type 304 Austenitic Stainless Steel

The effects of strain and chloride concentration on pitting susceptibility for type 304 stainless steel were studied in situ using the electrochemical technology under constant strain. The impact factor fc was brought forward to value the effect of strain on pitting. The pitting behaviors of type 304 stainless steel in various chloride concentrations under the strain levels 0%, 10%, and 30% were investigated. Potentiostatic polarization technology was used to study how the chloride concentration affected corrosion current density. The results indicated that fc increased substantially and pitting potential varied remarkably when chloride concentration was over 90 mg.L . Under the three levels of strain mentioned above, when chloride concentration was below 463 mg.L^-1,121 mg.L^-1, and 98 mg.L^-1 respectively, the pitting potential shifted towards positivity and, the passive film became more stable. When the strain was below 10%, the pitting susceptibility of type 304 stainless steel varied greatly as strain increased, whereas the susceptibility only changed a little when the strain was over 10%.

Monitoring Chloride Concentrations in Concrete Pore Solutions Using Silver/Nano-silver Chloride Sensors

Corrosion of reinforcing steel is a major cause for degradation of concrete structures,especially when exposed to chloride ions.Thus,the Silver/Nano-silver Chloride (SNSC) electrodes as sensors of chloride concentration were prepared and encapsulated carefully.The properties of the electrode were studied by emerging them in a series of concrete pore solutions with different admixed KCl contents.These SNSC sensors show that good stability in concrete pore solutions at room temperature.Polarization disposal can shorten the stabilized period of the sensors.The electrochemical tests indicate the SNSC sensors with desirable linearity and reproducibility.The response time of SNSC sensors is short enough for monitoring the chloride ions concentration in concrete structures.The good performance of SNSC sensors indicate that they could be embedded in the concrete structures in the future.

Influence of chloride ion concentration on immersion corrosion behaviour of plasma sprayed alumina coatings on AZ31B magnesium alloy

Corrosion attack of aluminium and magnesium based alloys is a major issue worldwide.The corrosion degradation of an uncoated and atmospheric plasma sprayed alumina(APS)coatings on AZ31B magnesium alloy was investigated using immersion corrosion test in NaCl solutions of different chloride ion concentrations viz.,0.01 M,0.2 M,0.6 M and 1 M.The corroded surface was characterized by an optical microscope and X-ray diffraction.The results showed that the corrosion deterioration of uncoated and coated samples were significantly influenced by chloride ion concentration.The uncoated magnesium and alumina coatings were found to offer a superior corrosion resistance in lower chloride ion concentration NaCl solutions(0.01 M and 0.2 M NaCl).On the other hand the coatings and Mg alloy substrate were found to be highly susceptible to localized damage,and could not provide an effective corrosion protection in solutions containing higher chloride concentrations(0.6 M and 1 M).It was found that the corrosion resistance of the ceramic coatings and base metal gets deteriorated with the increase in the chloride concentrations.

The Combined Impact of Magnetic Field and Chloride Ion Concentration on Corrosion Behavior of Al-Mg Alloys

The impact of magnetic field on the corrosion behavior of Al-Mg-xR_(E)/Fe alloys in NaCl solutions with concentrations of 1.5wt%,3.5wt%,and 5.5wt%were studied by microstructure observation,immersion test,and electrochemical test.The combined impacts of magnetic field and chloride ion concentration on the corrosion behavior of Al-Mg alloys with various electrode potential phases were discussed.The results indicate that Al-3.0Mg-xR_(E)/Fe alloys corrode faster and have a higher pitting corrosion potential in the NaCl solution with a higher concentration.In addition,a magnetic field can lower the pitting sensitivity and corrosion rate of Al-3.0Mg and Al-3.0Mg-0.2R_(E)/Fe alloys in NaCl solution with different concentrations.However,at a higher concentration of NaCl solution,the magnetic field has a weaker inhibiting effect on corrosion rate and pitting sensitivity.In NaCl solutions with concentrations of 1.5wt%and 3.5wt%,the corrosion rate and pitting sensitivity of Al-3.0Mg-1.0R_(E)/Fe alloys can be reduced by a magnetic field.However,in NaCl solution with the concentration of 5.5wt%,the corrosion rate of the alloys is increased by a magnetic field.

Distribution of Terbium and Increase of Calcium Concentration in the Organs of Mice iv-Administered With Terbium Chloride

To investigate the biobeical effects of terbium (Tb), male mice were intravenously ad ministered with TbCl3 at 10, 25, or 50 mg Tb/kg. Time-course and dose-related changes in organ distributions of Tb were determined . More than 95 % of the Tb in blood was in plas ma, and the concentrations decreased rapidly. Contrary to normal pharmacokinetics, Tb con centrations in plasma were higher in the 10 mg/kg group than in the 50 mg/kg group. The concentrations after injection of 25 mg/kg were between 10 and 50 mg/kg injections. Tb was incorporated mainly in liver, lung, and spleen. In all groups more than 80% of Tb adminis tered were found in these three organs. Disappearance of Tb in these organs was very slow.Tb was also found in kidney, heart and other organs. Coincidentally, it was found that the Ca concentration was increased in organs in which Tb was incorporated. After administration of Tb (50 mg/kg) the Ca concentration, compared to the controls, was 70-fold in spleen, 20-fold in lung, and 6-fold in liver. There were highly positive correlations between Tb and Ca concentrations in organs. Excretion of Tb in urine was 0. 15 ～ 0. 3 % and that in feces was 1.7～12. 5 % for up to 7 days. These results indicate that liver, lung, and spleen are the main target organs of Tb administered intravenously, and that the increase in Ca concentrations is one of the important biological effects of Tb in target organs

Histopathological Changes in the Epidermis of the Air Breathing Catfish Heteropneustes fossilis Exposed to Sublethal Concentration of Mercuric Chloride

Histopathological alterations induced by the sublethal concentration of (0.03 ppm) mercuric chloride solution on the epidermis of the fresh-water catfish Heteropneuates fossilis have been studied. It induces slow but significant histopathological changes in the various cellular components of the epidermis. It induces vacuolization, necrosis and pycnosis of the nuclei of the epithelial cells which subsequently shed. Loosening of epithelial cells of the outermost and middle layers following degeneration of the intercellular material and widened intercellular spaces is another important alteration. Prolonged mercury treatment also causes a gradual decrease in staining intensity for sulphated glycosaminoglycans in the outer border of the most superficial layer epithelial cells. The glandular elements (club cells and mucocytes) also get affected, showing cyclic degeneration followed by regeneration.

Probabilistic Assessment of Reinforcing Steel Depassivation in Concrete under Aggressive Chloride Environments Based on Natural Exposure Data

The probability distributions of the critical threshold chloride concentration Ccr, the chloride diffusion coefficient D, and the surface chloride concentration Cs are determined based on the collected natural exposure data, and the probability estimation of reinforcement depassivation in concrete is presented using Monte-Carlo simulation. From sensitivity analysis of mean value for ccr, cs, and D on the depassivation probability of reinforcement, it is found that ccr, cs, and D respectively has the greatest, smaller, and the lowest effect on the probability of depassivation. Finally the effect of stress state of concrete on the reinforcement depassivation probability is analyzed. It is found that the influence of stress state becomes apparent as exposure time increases.

Corrosion behavior of micro-arc oxidation coating on AZ91D magnesium alloy in NaCl solutions with different concentrations

Ceramic oxide coatings were prepared on AZ91D magnesium alloys in alkaline silicate solution using micro-arc oxidation（MAO） technique.The corrosion behavior of MAO coating on AZ91D magnesium alloys in NaCl solutions with different concentrations（0.1%,0.5%,1.0%,3.5% and 5.0% in mass fraction） was evaluated by electrochemical measurements and immersion tests.The results showed that the corrosion rate of the MAO coated AZ91D increased with increasing chloride ion concentration.The main form of corrosion failure was localized corrosion for the MAO coated AZ91D immersed in higher concentration NaCl solutions（1.0%,3.5% and 5.0%）,while it was general corrosion in dilute NaCl solutions（0.1% and 0.5%）.Two different stages of the failure process of the MAO coated AZ91D could be identified：1） occurrence of the metastable pits and 2） growth of the pits.Different equivalent circuits were also proposed based on the results of electrochemical impedance spectroscopy（EIS） for the MAO coated AZ91D immersed in different concentrations of NaCl solutions for 120 h.

Salinization:the ultimate threat to temperate lakes,with particular reference to Southeastern Wisconsin(USA)

Many lakes in Southeastern Wisconsin(the metropolitan-Milwaukee area) are gradually becoming increasingly "salty".While these waterbodies would not be considered presently to be saline lakes,there has been a rapid increase in the chloride concentrations in most of these lakes over the last 30 years,with the lakes increasing from a mean chloride concentration of about 19 mg/L to over 100 mg/L in some cases.While ecological impacts can be expected when chloride values exceed 250 mg/L,the rate of increase presents a basis for concern,especially since the underlying geology of the region is based on limestone/dolomite which is deficient in chlorides.Thus,the origin of the chlorides is anthropogenic:human and industrial wastewaters(treatment of which has effected improvements in trophic status but has not affected other water-borne contaminants) and winter de-icing practices based upon large quantities of sodium chloride are major contributors to the increasing concentrations of chloride in the region's waterways.Without taking remedial measures,the rate of salinization is expected to continue to increase,resulting,ultimately,in the alteration of the freshwater systems in the region.

Effects of Organic Corrosion Inhibitor and Chloride Ion Concentration on Steel Depassivation and Repassivation in Solution

Effect of an organic corrosion inhibitor(OCI) named PCI-2014 added in chloride solution on the critical chloride concentration of mild steel depassivation and the critical OCI concentrations for repairing the steel in different chloride solution were investigated.The results show that the critical chloride concentration increases exponentially with raises of PCI-2014 concentration in the solution.Within a certain chloride ion concentration range,the critical PCI-2014 concentration for repairing the corroded steel is also increases exponentially with enhancement of chloride content in the solution.Atomic force microscopy images display the molecular particles of inhibitor are adsorbed on the steel surface and formed a protective layer.Analysis of X-ray photoelectron spectroscopy shows the chloride ions at the surface of steel are displaced by atoms or molecules of the inhibitor in chloride condition.

A discussion on evaluation criteria for crevice corrosion of various stainless steels

In this study,crevice corrosion performances of a newly developed LDSS 2002 and three commercial stainless steels(AISI 304,AISI 316L and DSS 2205)were investigated and discussed.Crevice repassivation potential(ER,CREV),which was measured by the potentiodynamic-galvanostatic-potentiodynamic(PDGS-PD)test,was applicable to crevice corrosion evaluation of 304 and 316 L stainless steels.However,much lower(ER,CREV values were obtained for DSS 2205 and LDSS 2002.These abnormal(ER,CREV values for duplex stainless steels may be related to the selective attack of the less corrosion-resistant phase,the lower corrosion potential in the crevice-like solution,and more crevice corrosion sites in the PD-GS-PD test.A critical chloride concentration of crevice corrosion(CCCCREV)measurement was introduced for crevice corrosion evaluation of various stainless steels.The derived CCCCREVwas proved to be a valid criterion for crevice corrosion evaluation of both the austenitic and duplex stainless steels.An order of crevice corrosion resistance of AISI 304≈LDSS 2002<AISI 316 L<DSS 2205 was suggested,which agreed well with the orders of pitting resistance equivalent number and critical crevice index of the less corrosion-resistant phase in each material.