Electrocoagulation of pulp and paper industry effluent with SS-304 electrode has been carried out under varying process variable such as pH, current density, time and dose of electrolyte to find out the optimum condit...Electrocoagulation of pulp and paper industry effluent with SS-304 electrode has been carried out under varying process variable such as pH, current density, time and dose of electrolyte to find out the optimum conditions. Maximum reduction efficiency of Chemical Oxygen Demand (COD) 82% and color more than 99% from pulp and paper industry wastewater at the following conditions pH = 7, current density = 24.80 mA/cm2 time = 40 min and dose of electrolytes = 1.0 g/L. Moreover, effects of electrolytes dosage on electricity consumption were observed and found to be that NaCl is better in comparison of Na2SO4 in respect of lower down the electricity consumption. But application of NaCl causes the formation of hazardous compounds as secondary pollutants within treated water. Therefore, Na2SO4 could be a potent replacement of NaCl to enhance the conductivity of paper industry effluent treated by EC process. The treated water has been compared with standard of Central Pollution control board (CPCB) and World Health organization, and found to be suitable for the reuse in irrigation.展开更多
The study area is located in Duhok and Sulaimania province in Kurdistan region, lraq. Study soils developed from parent material that has derived from limestone. Randomize, composed and disturbed surface soil samples ...The study area is located in Duhok and Sulaimania province in Kurdistan region, lraq. Study soils developed from parent material that has derived from limestone. Randomize, composed and disturbed surface soil samples were collected. The bulk soils were air dried, crushed and passed through 2 mm sieve. Standard methods were used for chemical, physical, geotechnical and mineralogical analyses of soil samples. The results indicated that the study soils texture were clay to loam clay, this texture was considered as suitable for ceramic and pottery industries as a result of increasing clay contents that ranged between 301 g/kg and 676 g/kg. Soil consistence depending on geotechnical properties increased the ability of study soils for resistance rapture and deformation. Existence the high amount of cementing agents in study soils such as organic matter, iron oxides and particularly total carbonate （247.2-308.8 g/kg） act to reduce the bad effect of the smectite minerals group （high shrinkage） in soils of study locations through increasing the resistance of these soils for rupture and deformation. The existing of Kaolinite, palygorskite and chlorite allows clay to be dried in ceramic and pottery industries without cracking from shrinkage. Study soils were different in their colors as a result of existence, different pigmentation materials that led to coloring soils with different colors in turn caused coloring of pottery and ceramic materials. Since, there are no available academic studies or researches about this subject in Kurdistan region in addition the clay pottery and ceramic sector still has a good market at the same time using this type of soils for arts, therefore, this study was conducted.展开更多
文摘Electrocoagulation of pulp and paper industry effluent with SS-304 electrode has been carried out under varying process variable such as pH, current density, time and dose of electrolyte to find out the optimum conditions. Maximum reduction efficiency of Chemical Oxygen Demand (COD) 82% and color more than 99% from pulp and paper industry wastewater at the following conditions pH = 7, current density = 24.80 mA/cm2 time = 40 min and dose of electrolytes = 1.0 g/L. Moreover, effects of electrolytes dosage on electricity consumption were observed and found to be that NaCl is better in comparison of Na2SO4 in respect of lower down the electricity consumption. But application of NaCl causes the formation of hazardous compounds as secondary pollutants within treated water. Therefore, Na2SO4 could be a potent replacement of NaCl to enhance the conductivity of paper industry effluent treated by EC process. The treated water has been compared with standard of Central Pollution control board (CPCB) and World Health organization, and found to be suitable for the reuse in irrigation.
文摘The study area is located in Duhok and Sulaimania province in Kurdistan region, lraq. Study soils developed from parent material that has derived from limestone. Randomize, composed and disturbed surface soil samples were collected. The bulk soils were air dried, crushed and passed through 2 mm sieve. Standard methods were used for chemical, physical, geotechnical and mineralogical analyses of soil samples. The results indicated that the study soils texture were clay to loam clay, this texture was considered as suitable for ceramic and pottery industries as a result of increasing clay contents that ranged between 301 g/kg and 676 g/kg. Soil consistence depending on geotechnical properties increased the ability of study soils for resistance rapture and deformation. Existence the high amount of cementing agents in study soils such as organic matter, iron oxides and particularly total carbonate （247.2-308.8 g/kg） act to reduce the bad effect of the smectite minerals group （high shrinkage） in soils of study locations through increasing the resistance of these soils for rupture and deformation. The existing of Kaolinite, palygorskite and chlorite allows clay to be dried in ceramic and pottery industries without cracking from shrinkage. Study soils were different in their colors as a result of existence, different pigmentation materials that led to coloring soils with different colors in turn caused coloring of pottery and ceramic materials. Since, there are no available academic studies or researches about this subject in Kurdistan region in addition the clay pottery and ceramic sector still has a good market at the same time using this type of soils for arts, therefore, this study was conducted.
