Optimization of Cavity Combination for 20 MA LTD-Based Accelerators

Based on a transmission line code, a circuit model is proposed that could serve as the basic method for the analysis of linear transformer driver （LTD）-based accelerators. By using 1 MA, 100 kV LTD cavities, the peak load current is optimized for a total of N cavities between 500 and 1200. The simulation results suggest that, with the same number of cavities, the peak current changes obviously with the types of combinations, and the maximum change can be as large as 1.2 MA. The results also show that, for the cases considered, the optimized peak current as a function of the total number of cavities agrees with the exponential associate, and the peak current for one level LTD cannot be enhanced infinitely. Furthermore, it is found that, to obtain a 20 MA peak load current, at least 1029 LTD cavities （49 in series and 21 in parallel connection） are needed. Finally, the typical parameters of the optimized design are compared to those of the existing Z accelerator.

Pressure distribution of combining center cavity slipper for axial piston pump

In order to improve lubricating characteristics of slippers in an axial piston pump, the combining center cavity slipper approach was proposed based on slipper shape and moving characteristic. The cylindrical coordinate was used in the lubricant area and mesh was made. The blockweight approach was implemented to deal with non-coincidence of mesh and shallow recess border in numerical method. The finite control volume method was applied in calculating pressure distribution. The flow conservation equation and film thickness model were resolved through Gauss-Siedel relaxation iteration. The calculation and analysis results indicate that compared to the slipper （1） slip- per pressure distribution is improved; （2） hydrodynamic pressure of the combining slipper is greatly increased; （3） inclining degree is greatly reduced; （4） negative pressure in lubricant film disappear. So the combining center cavity slipper is lubricated better.

Diode-pumped tunable laser with dual Cr：LiSAF rods

We propose and demonstrate a simple approach to lower the thermal quenching effect and improve the output power of Cr：LiSAF lasers, which is accomplished by employing two laser rods. The resonator contains two laser rods and is designed by using two ＂X＂ folding cavities in cascade. A tunable laser output of ～ 180 mW has been achieved with the pump of single-striped laser diodes. Compared with lasers using single gain rod, the laser with dual rods shows less severe thermal effect and increases the output by more than two times.

Broad-area laser diodes with on-chip combined angled cavity

Semiconductor diode lasers are widely used in a variety of applications, such as pumping, telecommunication, laser display, industrial manufacturing, and medical treatments because of their high wall-plug efficiency,

A method for designing a variable-channel high-power cavity combiner

Cavity combiners have been put forward for high power combining due to their advantages of larger combining ability, variable input channels and less power loss. For a high power cavity combiner, it is better to keep the power loss ratio in a reasonable range, because large power loss would lead to strict requirements on the cooling system. A combiner with variable input channels is convenient for outputting different power levels according to practical demands. In this paper, a method for designing a variable-channel high-power cavity combiner is proposed, based on the relation between input and output coupling coefficients obtained by analyzing the equivalent circuit of the cavity combiner. This method can put the designed cavity combiner in a matching state and keep its power loss rate in a reasonable range as the number of input channels changes. As an example, a cavity combiner with 500 MHz and variable input channels from 16 to 64 is designed, and the simulation results show that our proposed method is feasible.