This paper proposes a stable gain and a compact Antipodal Vivaldi Antenna(AVA)for a 38GHz band of 5G communication.A novel compact AVA is designed to provide constant gain,high front to back ratio(FBR),and very high e...This paper proposes a stable gain and a compact Antipodal Vivaldi Antenna(AVA)for a 38GHz band of 5G communication.A novel compact AVA is designed to provide constant gain,high front to back ratio(FBR),and very high efficiency.The performance of the proposed AVA is enhanced with the help of a dielectric lens(DL)and corrugations.A rectangular-shaped DL is incorporated in conventional AVA(CAVA)to enhance its gain up to 1 dBi and the bandwidth by 1.8 GHz.Next,the rectangular corrugations are implemented in CAVA with lens(CAVA-L)to further improve the gain and bandwidth.The proposed AVA with lens and corrugations(AVA-LC)gives a constant and high gain of 8.2 to 9 dBi.The designed AVA-LC operates from 34 to 45GHz frequency which covers 38GHz(37.5 to 43.5 GHz)band of 5G applications.Further,the presented AVA-LC mitigates the back lobe and sidelobe levels,resulting in FBR and efficiency improvement.The FBR is in the range of 12.2 to 22 dB,and efficiency is 99%,almost constant.The AVA-LC is fabricated on Roger’s RT/duroid 5880 substrate,and it is tested to verify the simulated results.The proposed compact AVA-LC with high gain,an improved FBR,excellent efficiency,and stable radiation patterns is suitable for the 38GHz band of 5G devices.展开更多
This paper studies the consensus control of multiagent systems with binary-valued observations.An algorithm alternating estimation and control is proposed.Each agent estimates the states of its neighbors based on a pr...This paper studies the consensus control of multiagent systems with binary-valued observations.An algorithm alternating estimation and control is proposed.Each agent estimates the states of its neighbors based on a projected empirical measure method for a holding time.Based on the estimates,each agent designs the consensus control with a constant gain at some skipping time.The states of the system are updated by the designed control,and the estimation and control design will be repeated.For the estimation,the projected empirical measure method is proposed for the binary-valued observations.The algorithm can ensure the uniform boundedness of the estimates and the mean square error of the estimation is proved to be at the order of the reciprocal of the holding time(the same order as that in the case of accurate outputs).For the consensus control,a constant gain is designed instead of the stochastic approximation based gain in the existing literature for binary-valued observations.And,there is no need to make modification for control since the uniform boundedness of the estimates ensures the uniform boundedness of the agents’states.Finally,the systems updated by the designed control are proved to achieve consensus and the consensus speed is faster than that in the existing literature.Simulations are given to demonstrate the theoretical results.展开更多
A novel general-purpose low-voltage rail-to-rail CMOS （ complementary metal-oxide-semiconductor transistor ） operational amplifier （op-amp）is introduced, which obtains constant transconductance, slew rate and cons...A novel general-purpose low-voltage rail-to-rail CMOS （ complementary metal-oxide-semiconductor transistor ） operational amplifier （op-amp）is introduced, which obtains constant transconductance, slew rate and constant high gain over the entire input common mode voltage range. The proposed scheme has the potential for applications in deep submicrometer technology, as the operation of the circuit does not exclusively rely on the square-law or the linear-law of transistors. The scheme is compact and suitable for applications as VLSI cell. The rail-to- rail op-amp has been implemented in DPDM 0. 6 μm mixedsignal process. The simulations show that in the entire range of input common mode voltage, the variations in transconductance, SR and gain are 1%, 2. 3%, 1.36 dB, respectively. Based on this, the layout and tape-out are carded out. The area of layout is 0. 072 mm^2. The test results are basically consistent with the circuit simulation.展开更多
This paper presents the analytical design and high performance of step-constant tapered slot antenna (STSA) for ultra-wideband application. The return loss, radiation pattern, antenna gain, and level of cross polariza...This paper presents the analytical design and high performance of step-constant tapered slot antenna (STSA) for ultra-wideband application. The return loss, radiation pattern, antenna gain, and level of cross polarization of this antenna are presented and analyzed. Utilizing Rogers (RO3006) substrate having a relative permittivity of 6.15, the proposed antenna provides the ultra-wideband (UWB) from 3.1 GHz to 10.6 GHz. It is observed that the return loss and gain are increased with increasing the step size. It has been observed from the simulation results incorporating CST microwave studio commercial software version 2015, the optimum return loss, directivity and gain are ?43 dB, 10.52 dBi and 10.20 dB, respectively, for 15 step size. Therefore, the newly proposed antenna will be a decent candidate for ultra-wideband application.展开更多
为实现感应电能传输(Inductive Power Transfer,IPT)系统在变负载条件下的恒流/恒压高效输出,提出一种基于频率切换的LCC-S型IPT系统参数配置及优化方法。从LCC-S补偿拓扑入手,分别得到系统恒流或恒压零相位角(Zero Phase Angle,ZPA)输...为实现感应电能传输(Inductive Power Transfer,IPT)系统在变负载条件下的恒流/恒压高效输出,提出一种基于频率切换的LCC-S型IPT系统参数配置及优化方法。从LCC-S补偿拓扑入手,分别得到系统恒流或恒压零相位角(Zero Phase Angle,ZPA)输出的条件方程,并推导了电流增益、电压增益与系统参数之间的定量关系;进一步通过定义系统的输出增益比,分析了恒流/恒压模式下输出增益、负载电阻与整体效率的关系;在此基础上,通过选取最佳的输出增益值,使得系统整体效率达到了全局最大化。仿真结果表明,负载电阻在3~300Ω的变化范围内包括恒流/恒压模式切换瞬间都能保持稳定的输出,并且恒流/恒压模式下均能实现ZPA运行,同时系统整体效率都维持在90%以上。展开更多
基金This research was funded by Princess Nourah bint Abdulrahman University Researchers Supporting Project number(PNURSP2022R79)Princess Nourah bint Abdulrahman University,Riyadh,Saudi Arabia,S.Urooj,www.pnu.edu.sa.
文摘This paper proposes a stable gain and a compact Antipodal Vivaldi Antenna(AVA)for a 38GHz band of 5G communication.A novel compact AVA is designed to provide constant gain,high front to back ratio(FBR),and very high efficiency.The performance of the proposed AVA is enhanced with the help of a dielectric lens(DL)and corrugations.A rectangular-shaped DL is incorporated in conventional AVA(CAVA)to enhance its gain up to 1 dBi and the bandwidth by 1.8 GHz.Next,the rectangular corrugations are implemented in CAVA with lens(CAVA-L)to further improve the gain and bandwidth.The proposed AVA with lens and corrugations(AVA-LC)gives a constant and high gain of 8.2 to 9 dBi.The designed AVA-LC operates from 34 to 45GHz frequency which covers 38GHz(37.5 to 43.5 GHz)band of 5G applications.Further,the presented AVA-LC mitigates the back lobe and sidelobe levels,resulting in FBR and efficiency improvement.The FBR is in the range of 12.2 to 22 dB,and efficiency is 99%,almost constant.The AVA-LC is fabricated on Roger’s RT/duroid 5880 substrate,and it is tested to verify the simulated results.The proposed compact AVA-LC with high gain,an improved FBR,excellent efficiency,and stable radiation patterns is suitable for the 38GHz band of 5G devices.
基金supported by the National Natural Science Foundation of China(61803370,61622309)the China Postdoctoral Science Foundation(2018M630216)the National Key Research and Development Program of China(2016YFB0901902)
文摘This paper studies the consensus control of multiagent systems with binary-valued observations.An algorithm alternating estimation and control is proposed.Each agent estimates the states of its neighbors based on a projected empirical measure method for a holding time.Based on the estimates,each agent designs the consensus control with a constant gain at some skipping time.The states of the system are updated by the designed control,and the estimation and control design will be repeated.For the estimation,the projected empirical measure method is proposed for the binary-valued observations.The algorithm can ensure the uniform boundedness of the estimates and the mean square error of the estimation is proved to be at the order of the reciprocal of the holding time(the same order as that in the case of accurate outputs).For the consensus control,a constant gain is designed instead of the stochastic approximation based gain in the existing literature for binary-valued observations.And,there is no need to make modification for control since the uniform boundedness of the estimates ensures the uniform boundedness of the agents’states.Finally,the systems updated by the designed control are proved to achieve consensus and the consensus speed is faster than that in the existing literature.Simulations are given to demonstrate the theoretical results.
文摘A novel general-purpose low-voltage rail-to-rail CMOS （ complementary metal-oxide-semiconductor transistor ） operational amplifier （op-amp）is introduced, which obtains constant transconductance, slew rate and constant high gain over the entire input common mode voltage range. The proposed scheme has the potential for applications in deep submicrometer technology, as the operation of the circuit does not exclusively rely on the square-law or the linear-law of transistors. The scheme is compact and suitable for applications as VLSI cell. The rail-to- rail op-amp has been implemented in DPDM 0. 6 μm mixedsignal process. The simulations show that in the entire range of input common mode voltage, the variations in transconductance, SR and gain are 1%, 2. 3%, 1.36 dB, respectively. Based on this, the layout and tape-out are carded out. The area of layout is 0. 072 mm^2. The test results are basically consistent with the circuit simulation.
文摘This paper presents the analytical design and high performance of step-constant tapered slot antenna (STSA) for ultra-wideband application. The return loss, radiation pattern, antenna gain, and level of cross polarization of this antenna are presented and analyzed. Utilizing Rogers (RO3006) substrate having a relative permittivity of 6.15, the proposed antenna provides the ultra-wideband (UWB) from 3.1 GHz to 10.6 GHz. It is observed that the return loss and gain are increased with increasing the step size. It has been observed from the simulation results incorporating CST microwave studio commercial software version 2015, the optimum return loss, directivity and gain are ?43 dB, 10.52 dBi and 10.20 dB, respectively, for 15 step size. Therefore, the newly proposed antenna will be a decent candidate for ultra-wideband application.
文摘为实现感应电能传输(Inductive Power Transfer,IPT)系统在变负载条件下的恒流/恒压高效输出,提出一种基于频率切换的LCC-S型IPT系统参数配置及优化方法。从LCC-S补偿拓扑入手,分别得到系统恒流或恒压零相位角(Zero Phase Angle,ZPA)输出的条件方程,并推导了电流增益、电压增益与系统参数之间的定量关系;进一步通过定义系统的输出增益比,分析了恒流/恒压模式下输出增益、负载电阻与整体效率的关系;在此基础上,通过选取最佳的输出增益值,使得系统整体效率达到了全局最大化。仿真结果表明,负载电阻在3~300Ω的变化范围内包括恒流/恒压模式切换瞬间都能保持稳定的输出,并且恒流/恒压模式下均能实现ZPA运行,同时系统整体效率都维持在90%以上。
