Numerical simulation of the preparation of semi-solid metal slurry with damper cooling tube method

In semi-solid forming process, preparing the slurry with rosette or globular microstructure is very important. A new approach named the damper cooling tube method （DCT）, to produce the semi-solid metal slurry, has been introduced. To optimize the technical parameters in designing the apparatus, the finite volume method was adopted to simulate the flow process. The temperature effects on the rheological properties of the slurries were also considered. The effects of the technical parameters on the slurry properties were studied in detail.

Comparison between two rheocasting processes of damper cooling tube method and low superheat casting

To produce a high quality semisolid slurry that consists of fine primary particles uniformly suspended in the liquid matrix for rheoforming, chemical refining and electromagnetic or mechanical stirring are the two methods commonly used. But these two methods either contaminate the melt or incur high cost. In this study, the damper cooling tube （DCT） method was designed to prepare semisolid slurry of A356 aluminum alloy, and was compared with the low superheat casting （LSC） method - a conventional process used to produce casting slab with equiaxed dendrite microstructure for thixoforming route. A series of comparative experiments were performed at the pouring temperatures of 650 ＆#176;C, 638 ＆#176;C and 622 ＆#176;C. Metal ographic observations of the casting samples were carried out using an optical electron microscope with image analysis software. Results show that the microstructure of semisolid slurry produced by the DCT process consists of spherical primary α-Al grains, while equiaxed grains microstructure is found in the LSC process. The lower the pouring temperature, the smal er the grain size and the rounder the grain morphology in both methods. The copious nucleation, which could be generated in the DCT, owing to the cooling and stirring effect, is the key to producing high quality semisolid slurry. DCT method could produce rounder and smal er α-Al grains, which are suitable for semisolid processing; and the equivalent grain size is no more than 60 μm when the pouring temperature is 622 ＆#176;C.

A New Structure of Cooling Wall Tube for Supercritical CO_(2)Coal-Fired Power Plants

In terms of developing supercritical CO_(2)(sCO_(2))coal-fired power plants,enhancing cooling wall performance is one of significant factors to improve system performance.In this paper,a new cooling wall tube structure is proposed to match the non-uniform heat flux(NUH)with the thermal resistance by changing the cooling wall tube eccentricity.A three-dimensional multi-physical coupling model of cooling wall is constructed to compare the novel structure to the conventional structures.The properties of fluid dynamics,thermal stress,coupled heat transfer and cooling wall deformation are analyzed.In contrast to the traditional structure,the maximum temperature and circumferential temperature difference(CTD)of the proposed structure can be reduced by 2%and 27.4%,respectively.The essential working parameters related to the performances of the cooling wall tube are discussed.The maximum temperature of the new structure is reduced by 8-13 K and the maximum thermal stress is reduced by about 10%-15%under all the simulated working conditions when the eccentricity changes from 0 to 0.2.The proposed structure can effectively reduce the maximum temperature and circumferential temperature gradient under NUH.Consequently,a novel insight is put out for the design and optimization of the cooling wall tube in coal-fired power plants.