The enrichment of copper from copper–cyanide wastewater by solvent extraction was investigated using a quaternary ammonium salt as an extractant. The influences of important parameters, e.g., organic-phase components...The enrichment of copper from copper–cyanide wastewater by solvent extraction was investigated using a quaternary ammonium salt as an extractant. The influences of important parameters, e.g., organic-phase components, aqueous pH values, temperature, inorganic anion impurities, CN/Cu molar ratio, and stripping reagents, were examined systematically, and the optimal conditions were determined. The results indicated that copper was effectively concentrated from low-concentration solutions using Aliquat 336 and that the extraction efficiency increased linearly with increasing temperature. The aqueous pH value and concentrations of inorganic anion impurities only weakly affected the extraction process when varied in appropriate ranges. The CN/Cu molar ratio affected the extraction efficiency by changing the distribution of copper–cyanide complexes. The difference in gold leaching efficiency between using raffinate and fresh water was negligible.展开更多
Whether a cationic organic polymer can remove more total cyanide （TCN） than a non-ionic organic polymer during the same flocculation system has not been reported previously. In this study, the effects of organic pol...Whether a cationic organic polymer can remove more total cyanide （TCN） than a non-ionic organic polymer during the same flocculation system has not been reported previously. In this study, the effects of organic polymers with different charge density on the removal mechanisms of TCN in coking wastewater are investigated by polyferric sulfate （PFS） with a cationic organic polymer （PFS-C） or a non-ionic polymer （PFS-N）. The coagulation experiments results show that residual concentrations of TCN （Fe（CN）6^3-） after PFS-C flocculation （TCN 〈 0.2 mg/L） are much lower than that after PFS-N precipitation. This can be attributed to the different TCN removal mechanisms of the individual organic polymers. To investigate the roles of organic polymers, physical and structural characteristics of the floes are analyzed by FT-IR, XPS, TEM and XRD. Owing to the presence of N＋ in PFS-C, Fe（CN）3- and negative flocs （Fe（CN）63- adsorbed on ferric hydroxides） can be removed via charge neutralization and electrostatic patch flocculation by the cationic organic polymer. However, non-ionic N in PFS-N barely reacts with cyanides through sweeping or bridging, which indicates that the non-ionic polymer has little influence on TCN removal.展开更多
文摘The enrichment of copper from copper–cyanide wastewater by solvent extraction was investigated using a quaternary ammonium salt as an extractant. The influences of important parameters, e.g., organic-phase components, aqueous pH values, temperature, inorganic anion impurities, CN/Cu molar ratio, and stripping reagents, were examined systematically, and the optimal conditions were determined. The results indicated that copper was effectively concentrated from low-concentration solutions using Aliquat 336 and that the extraction efficiency increased linearly with increasing temperature. The aqueous pH value and concentrations of inorganic anion impurities only weakly affected the extraction process when varied in appropriate ranges. The CN/Cu molar ratio affected the extraction efficiency by changing the distribution of copper–cyanide complexes. The difference in gold leaching efficiency between using raffinate and fresh water was negligible.
基金supported by the National Key Technologies R&D Program of China (No. 2011BAC06B09)the Special Foundation of the President of the Chinese Academy of Sciencesthe National Natural Science Foundation of China (No. 51108441)
文摘Whether a cationic organic polymer can remove more total cyanide （TCN） than a non-ionic organic polymer during the same flocculation system has not been reported previously. In this study, the effects of organic polymers with different charge density on the removal mechanisms of TCN in coking wastewater are investigated by polyferric sulfate （PFS） with a cationic organic polymer （PFS-C） or a non-ionic polymer （PFS-N）. The coagulation experiments results show that residual concentrations of TCN （Fe（CN）6^3-） after PFS-C flocculation （TCN 〈 0.2 mg/L） are much lower than that after PFS-N precipitation. This can be attributed to the different TCN removal mechanisms of the individual organic polymers. To investigate the roles of organic polymers, physical and structural characteristics of the floes are analyzed by FT-IR, XPS, TEM and XRD. Owing to the presence of N＋ in PFS-C, Fe（CN）3- and negative flocs （Fe（CN）63- adsorbed on ferric hydroxides） can be removed via charge neutralization and electrostatic patch flocculation by the cationic organic polymer. However, non-ionic N in PFS-N barely reacts with cyanides through sweeping or bridging, which indicates that the non-ionic polymer has little influence on TCN removal.
