Liquid Level Measurement in Oil Tanks Based on Double-differential Pressure Technique

The system principle and configuration of the double differential pressure method for measuring oil tank level are presented. The fundamental method and circuit of fiber optic transmission are analyzed .The accuracy and security of level measurement in the oil tanks have been greatly improved.

Atmospheric NO_2 Concentration Measurements Using Differential Absorption Lidar Technique

Using the Differential Absorption Lidar (DIAL) technique, two types of approaches, namely, reflection from retroreflector / topographic target and backscatter from atmosphere, are available for studying remotely the atmospheric NO, concentration. The Argon ion lidar system at the Indian Institute of Tropical Meteorology (IITM), Pune, India has been used for the measurements by following both the path-averaged and range-resolved approaches. For the former, a topographic target (hill) is used for determining path-averaged surface concentration. In the latter, spectral properties of atmospheric attenuation is used for making range-resolved measurements in the surface layer. The results of the observations collected by following both approaches are presented. The average surface NO2 concentration was found to vary between 0.01 and 0.105 ppm and the range-resolved measurements exhibited higher values suggesting treatment of the lidar data for scattering and extinction effects due to atmospheric aerosols and air molecules, and atmospheric turbulence. Certain modifications that are suggested to the experimental set-up, data acquisition and analysis to improve the measurements are briefly described.

Static response of functionally graded multilayered two-dimensional quasicrystal plates with mixed boundary conditions

The unusual properties of quasicrystals(QCs)have attracted tremendous attention from researchers.In this paper,a semi-analytical solution is presented for the static response of a functionally graded(FG)multilayered two-dimensional(2 D)decagonal QC rectangular plate with mixed boundary conditions.Based on the elastic theory of FG 2 D QCs,the state-space method is used to derive the state equations composed of partial differential along the thickness direction.Besides,the Fourier series expansion and the differential quadrature technique are utilized to simulate the simply supported boundary conditions and the mixed boundary conditions,respectively.Then,the propagator matrix which connects the field variables at the upper interface to those at the lower interface of any homogeneous layer can be derived based on the state equations.Combined with the interface continuity condition,the static response can be obtained by imposing the sinusoidal load on the top surfaces of laminates.Finally,the numerical examples are presented to verify the effectiveness of this method,and the results are very useful for the design and understanding of the characterization of FG QC materials in their applications to multilayered systems.

Analysis of RDSS positioning accuracy based on RNSS wide area differential technique

The BeiDou Navigation Satellite System(BDS) provides Radio Navigation Service System(RNSS) as well as Radio Determination Service System(RDSS).RDSS users can obtain positioning by responding the Master Control Center(MCC) inquiries to signal transmitted via GEO satellite transponder.The positioning result can be calculated with elevation constraint by MCC.The primary error sources affecting the RDSS positioning accuracy are the RDSS signal transceiver delay,atmospheric trans-mission delay and GEO satellite position error.During GEO orbit maneuver,poor orbit forecast accuracy significantly impacts RDSS services.A real-time 3-D orbital correction method based on wide-area differential technique is raised to correct the orbital error.Results from the observation shows that the method can successfully improve positioning precision during orbital maneuver,independent from the RDSS reference station.This improvement can reach 50% in maximum.Accurate calibration of the RDSS signal transceiver delay precision and digital elevation map may have a critical role in high precise RDSS positioning services.

A new differential absorption lidar for NO_2 measurements using Raman-shifted technique

Based on Raman-shifted wavelengths of D2 and CHr pumped by third harmonic of Nd:YAG laser, a differential absorption lidar was presented in this paper and had been constructed for probing environmental NO2 concentration. NO2 experimental measurements were carried out at Anhui Institute of Optics and Fine Mechanics in Hefei. Some NO2 measurement results were given and discussed.

A Novel Technique of Measuring SOA Differential Carrier Lifetime and a -Factor Using SOA Optical Modulation Response

We demonstrate a new technique of measuring differential carrier lifetime and linewidth enhancement factor in a semiconductor optical amplifier. In our method, the optical responses and fiber transfer functions of a self-gain modulated SOA are measured and, from these, values of carrier lifetimes and linewidth enhancement factors are determined for various SOA input optical powers.

Exponential Stability of Impulsive Neutral Stochastic Functional Differential Equations with Markovian Switching

The aim of this paper is to the discussion of the exponential stability of a class of impulsive neutral stochastic functional differential equations with Markovian switching.Under the influence of impulsive disturbance,the solution for the system is discontinuous.By using the Razumikhin technique and stochastic analysis approaches,as well as combining the idea of mathematical induction and classification discussion,some sufficient conditions for the pth moment exponential stability and almost exponential stability of the systems are obtained.The stability conclusion is full time-delay.The results show that impulse,the point distance of impulse and Markovain switching affect the stability for the system.Finally,two examples are provided to illustrate the effectiveness of the results proposed.

Principle demonstration of fine pointing control system for inter-satellite laser communication

Due to high data rates and reliability,inter-satellite laser communication has developed rapidly in these days.However,the stability of the laser beam pointing is still a key technique which needs to be solved;otherwise,the beam pointing jitter noise would reduce the communication quality or,even worse,would make the inter-satellite laser communication impossible.For this purpose,a bench-top of the fine beam pointing control system has been built and tested for inter-satellite laser communication.The pointing offset of more than 100rad is produced by the steering mirror.With beam pointing control system turned on,the offset could be rapidly suppressed to lower than 100 nrad in less than 0.5 s.Moreover,the pointing stability can be kept at 40 nrad for yaw motion and 62 nrad for pitch motion,when the received beam jitter is set at 20rad.