To improve the resource utilization ratio and shorten the recovery time of the shared path protection with differentiated reliability （SPP-DiR） algorithm, an algorithm called dynamic shared segment protection with d...To improve the resource utilization ratio and shorten the recovery time of the shared path protection with differentiated reliability （SPP-DiR） algorithm, an algorithm called dynamic shared segment protection with differentiated reliability （DSSP-DiR） is proposed for survivable GMPLS networks. In the proposed algorithm, a primary path is dynamically divided into several segments according to the differentiated reliability requirements of the customers. In the SPP-DiR algorithm, the whole primary path should be protected, while in the DSSP- DiR algorithm, only partial segments on the primary path need to be protected, which can reduce more backup bandwidths than that in the SPP-DiR algorithm. Simulation results show that the DSSP-DiR algorithm achieves higher resource utilization ratio, lower protection failure probability, and shorter recovery time than the SPP-DiR algorithm.展开更多
This paper presents software reliability growth models(SRGMs) with change-point based on the stochastic differential equation(SDE).Although SRGMs based on SDE have been developed in a large scale software system,consi...This paper presents software reliability growth models(SRGMs) with change-point based on the stochastic differential equation(SDE).Although SRGMs based on SDE have been developed in a large scale software system,considering the variation of failure distribution in the existing models during testing time is limited.These SDE SRGMs assume that failures have the same distribution.However,in practice,the fault detection rate can be affected by some factors and may be changed at certain point as time proceeds.With respect to this issue,in this paper,SDE SRGMs with changepoint are proposed to precisely reflect the variations of the failure distribution.A real data set is used to evaluate the new models.The experimental results show that the proposed models have a fairly accurate prediction capability.展开更多
In a structural system reliability analysis that lacks probabilistic information, calculating the numerical characteristics of the state functions, especially the first four moments of the state functions, is necessar...In a structural system reliability analysis that lacks probabilistic information, calculating the numerical characteristics of the state functions, especially the first four moments of the state functions, is necessary. Based on that, the structural system reliability is analyzed with a fourth-order moment method. The reliability sensitivity is required to conduct the differential operation of the numerical characteristic functions. A reliability sensitivity analysis formula is then derived in combination with the relation of the differential operation. Based on the matrix theory and Kronecker algebra, this paper systematically derives a matrix expression of the first four moments of the state functions, and establishes the matrix relation between the first four moments of the state functions and those of the basic random variables. On this basis, a differential operation formula of the first four moments of the state functions is further derived against the first four moments of the basic random variables. The vector relation between the state functions and the multidimensional basic random variables is described by means of the matrix operation to extend the operation method. Finally, a concise and intuitive formula is obtained to explore the inherent essential relation between the numerical characteristics of the state functions and those of the basic random variables, leading to a universal equation for the two kinds of numerical characteristics.展开更多
Due to high cost of fixing failures, safety concerns, and legal liabilities, organizations need to produce software that is highly reliable. Software reliability growth models have been developed by software developer...Due to high cost of fixing failures, safety concerns, and legal liabilities, organizations need to produce software that is highly reliable. Software reliability growth models have been developed by software developers in tracking and measuring the growth of reliability. Most of the Software Reliability Growth Models, which have been proposed, treat the event of software fault detection in the testing and operational phase as a counting process. Moreover, if the size of software system is large, the number of software faults detected during the testing phase becomes large, and the change of the number of faults which are detected and removed through debugging activities becomes sufficiently small compared with the initial fault content at the beginning of the testing phase. Therefore in such a situation, we can model the software fault detection process as a stochastic process with a continuous state space. Recently, Artificial Neural Networks (ANN) have been applied in software reliability growth prediction. In this paper, we propose an ANN based software reliability growth model based on Ito type of stochastic differential equation. The model has been validated, evaluated and compared with other existing NHPP model by applying it on actual failure/fault removal data sets cited from real software development projects. The proposed model integrated with the concept of stochastic differential equation performs comparatively better than the existing NHPP based model.展开更多
馈线自动化是提高配电网可靠性的重要措施,但其投入资金巨大。为了有效解决可靠性与经济性相矛盾的问题,结合10 k V配电网馈线自动化建设取得经济效益较少的实际情况,提出了馈线自动化差异化配置策略。首先,建立了辐射分段接线和联络分...馈线自动化是提高配电网可靠性的重要措施,但其投入资金巨大。为了有效解决可靠性与经济性相矛盾的问题,结合10 k V配电网馈线自动化建设取得经济效益较少的实际情况,提出了馈线自动化差异化配置策略。首先,建立了辐射分段接线和联络分段接线2种可靠性计算模型;其次,对馈线自动化4种典型方式分别进行经济性分析;然后,提出了10 k V配电网馈线自动化优化配置实施流程,实现了以单位投资减少停电时间为最优化目标的配置策略。通过天津某区馈线自动化改造的实际工程案例,验证了差异化优化配置策略的可行性。展开更多
基金supported by the National Natural Science Foundation of China (60673142)Applied Basic Research Project of Sichuan Province (2006J13-067)
文摘To improve the resource utilization ratio and shorten the recovery time of the shared path protection with differentiated reliability （SPP-DiR） algorithm, an algorithm called dynamic shared segment protection with differentiated reliability （DSSP-DiR） is proposed for survivable GMPLS networks. In the proposed algorithm, a primary path is dynamically divided into several segments according to the differentiated reliability requirements of the customers. In the SPP-DiR algorithm, the whole primary path should be protected, while in the DSSP- DiR algorithm, only partial segments on the primary path need to be protected, which can reduce more backup bandwidths than that in the SPP-DiR algorithm. Simulation results show that the DSSP-DiR algorithm achieves higher resource utilization ratio, lower protection failure probability, and shorter recovery time than the SPP-DiR algorithm.
基金Supported by the International Science&Technology Cooperation Program of China(No.2010DFA14400)the National Natural Science Foundation of China(No.60503015)the National High Technology Research and Development Programme of China(No.2008AA01A201)
文摘This paper presents software reliability growth models(SRGMs) with change-point based on the stochastic differential equation(SDE).Although SRGMs based on SDE have been developed in a large scale software system,considering the variation of failure distribution in the existing models during testing time is limited.These SDE SRGMs assume that failures have the same distribution.However,in practice,the fault detection rate can be affected by some factors and may be changed at certain point as time proceeds.With respect to this issue,in this paper,SDE SRGMs with changepoint are proposed to precisely reflect the variations of the failure distribution.A real data set is used to evaluate the new models.The experimental results show that the proposed models have a fairly accurate prediction capability.
基金Project supported by the National Natural Science Foundation of China(Nos.51135003 and U1234208)the Major State Basic Research Development Program of China(973 Program)(No.2014CB046303)
文摘In a structural system reliability analysis that lacks probabilistic information, calculating the numerical characteristics of the state functions, especially the first four moments of the state functions, is necessary. Based on that, the structural system reliability is analyzed with a fourth-order moment method. The reliability sensitivity is required to conduct the differential operation of the numerical characteristic functions. A reliability sensitivity analysis formula is then derived in combination with the relation of the differential operation. Based on the matrix theory and Kronecker algebra, this paper systematically derives a matrix expression of the first four moments of the state functions, and establishes the matrix relation between the first four moments of the state functions and those of the basic random variables. On this basis, a differential operation formula of the first four moments of the state functions is further derived against the first four moments of the basic random variables. The vector relation between the state functions and the multidimensional basic random variables is described by means of the matrix operation to extend the operation method. Finally, a concise and intuitive formula is obtained to explore the inherent essential relation between the numerical characteristics of the state functions and those of the basic random variables, leading to a universal equation for the two kinds of numerical characteristics.
文摘Due to high cost of fixing failures, safety concerns, and legal liabilities, organizations need to produce software that is highly reliable. Software reliability growth models have been developed by software developers in tracking and measuring the growth of reliability. Most of the Software Reliability Growth Models, which have been proposed, treat the event of software fault detection in the testing and operational phase as a counting process. Moreover, if the size of software system is large, the number of software faults detected during the testing phase becomes large, and the change of the number of faults which are detected and removed through debugging activities becomes sufficiently small compared with the initial fault content at the beginning of the testing phase. Therefore in such a situation, we can model the software fault detection process as a stochastic process with a continuous state space. Recently, Artificial Neural Networks (ANN) have been applied in software reliability growth prediction. In this paper, we propose an ANN based software reliability growth model based on Ito type of stochastic differential equation. The model has been validated, evaluated and compared with other existing NHPP model by applying it on actual failure/fault removal data sets cited from real software development projects. The proposed model integrated with the concept of stochastic differential equation performs comparatively better than the existing NHPP based model.
文摘馈线自动化是提高配电网可靠性的重要措施,但其投入资金巨大。为了有效解决可靠性与经济性相矛盾的问题,结合10 k V配电网馈线自动化建设取得经济效益较少的实际情况,提出了馈线自动化差异化配置策略。首先,建立了辐射分段接线和联络分段接线2种可靠性计算模型;其次,对馈线自动化4种典型方式分别进行经济性分析;然后,提出了10 k V配电网馈线自动化优化配置实施流程,实现了以单位投资减少停电时间为最优化目标的配置策略。通过天津某区馈线自动化改造的实际工程案例,验证了差异化优化配置策略的可行性。
