A low jitter All-Digital Phase-Locked Loop （ADPLL） used as a clock generator is designed. The Digital-Controlled Oscillator （DCO） for this ADPLL is a seven-stage ring oscillator with the delay of each stage change...A low jitter All-Digital Phase-Locked Loop （ADPLL） used as a clock generator is designed. The Digital-Controlled Oscillator （DCO） for this ADPLL is a seven-stage ring oscillator with the delay of each stage changeable. Based on the Impulse Sensitivity Function （ISF） analysis, an effective way is proposed to reduce the ADPLL＇s jitter by the careful design of the sizes of the inverters used in the DCO with a simple architecture other than a complex one. The ADPLL is implemented in a 0.18μm CMOS process with 1.SV supply voltage, occupies 0.046mm^2 of on-chip area. According to the measured results, the ADPLL can operate from 108MHz to 304MHz, and the peak-to-peak jitter is 139ps when the DCO＇s output frequency is 188MHz.展开更多
In order to effectively control the working state of the gyroscope in drive mode, the drive characteristics of the micro electromechanical system （MEMS） gyroscope are analyzed in principle. A novel drive circuit for...In order to effectively control the working state of the gyroscope in drive mode, the drive characteristics of the micro electromechanical system （MEMS） gyroscope are analyzed in principle. A novel drive circuit for the MEMS gyroscope in digital closed-loop control is proposed, which utilizes a digital phase-locked loop （PLL） in frequency control and an automatic gain control （AGC） method in amplitude control. A digital processing circuit with a field programmable gate array （FPGA） is designed and the experiments are carried out. The results indicate that when the temperature changes, the drive frequency can automatically track the resonant frequency of gyroscope in drive mode and that of the oscillating amplitude holds at a set value. And at room temperature, the relative deviation of the drive frequency is 0.624 ×10^-6 and the oscillating amplitude is 8.0 ×10^-6, which are 0. 094% and 18. 39% of the analog control program, respectively. Therefore, the control solution of the digital PLL in frequency and the AGC in amplitude is feasible.展开更多
This paper presents a novel digital dual-loop control scheme of the PWM(PUlse width modulate)inverter. Deadbeat control technique are employed to enhance the performance. Half switching period delayed sampling and con...This paper presents a novel digital dual-loop control scheme of the PWM(PUlse width modulate)inverter. Deadbeat control technique are employed to enhance the performance. Half switching period delayed sampling and control timing strategy is used to improve the system dynamic response. Simulation and experimental results presented in the paper verified the validity of the proposed control scheme.展开更多
The closed-loop stability issue of finite-precision realizations was investigated for digital control-lers implemented in block-floating-point format. The controller coefficient perturbation was analyzed resultingfrom...The closed-loop stability issue of finite-precision realizations was investigated for digital control-lers implemented in block-floating-point format. The controller coefficient perturbation was analyzed resultingfrom using finite word length (FWL) block-floating-point representation scheme. A block-floating-point FWL closed-loop stability measure was derived which considers both the dynamic range and precision. To facilitate the design of optimal finite-precision controller realizations, a computationally tractable block-floating-point FWL closed-loop stability measure was then introduced and the method of computing the value of this measure for a given controller realization was developed. The optimal controller realization is defined as the solution that maximizes the corresponding measure, and a numerical optimization approach was adopted to solve the resulting optimal realization problem. A numerical example was used to illustrate the design procedure and to compare the optimal controller realization with the initial realization.展开更多
The stable operation of first and second order Zero Crossing Digital Phase Locked Loop (ZCDPLL) is extended by using a Fixed Point Iteration (FPI) method with relaxation. The non-linear components of ZCDPLL such as sa...The stable operation of first and second order Zero Crossing Digital Phase Locked Loop (ZCDPLL) is extended by using a Fixed Point Iteration (FPI) method with relaxation. The non-linear components of ZCDPLL such as sampler phase detector and Digital Controlled Oscillator (DCO) lead to unstable and chaotic operation when the filter gains are high. FPI will be used to stabilize the chaotic operation and consequently extend the lock range of the loop. The proposed stabilized loop can work in higher filter gains which are needed for faster signal acquisition.展开更多
In this paper,a sensorless control strategy of a permanent magnet synchronous machine(PMSM)based on an improved rotor flux observer(IFO)is proposed.Due to the unknown integral initial value and the high harmonics caus...In this paper,a sensorless control strategy of a permanent magnet synchronous machine(PMSM)based on an improved rotor flux observer(IFO)is proposed.Due to the unknown integral initial value and the high harmonics caused by current sampling and inverter nonlinearities,the flux linkage estimated by traditional rotor flux observer may be inaccurate.In order to address these issues,a self-adaptive band-pass filter(SABPF)is designed to eliminate the DC component and high-frequency harmonics of the estimated equivalent rotor flux linkage.Furthermore,in order to avoid that the design of PI parameter is influenced by the amplitude of equivalent rotor flux linkage,an improved phase-locked loop(IPLL)is employed to obtain the rotor speed and to normalize the estimated equivalent rotor flux linkage.In addition,angle shift caused by an SABPF is compensated to improve the accuracy of the estimated flux linkage angle.Besides,the parameter robustness of this method is analyzed in detail.Finally,simulation and experimental results demonstrate the effectiveness and parameter robustness of the proposed method.展开更多
A time-domain digitally controlled oscillator （DCO） is proposed. The DCO is composed of a free-running ring oscillator （FRO） and a two lap-selectors integrated flying-adder （FA）. With a coiled cell array which a...A time-domain digitally controlled oscillator （DCO） is proposed. The DCO is composed of a free-running ring oscillator （FRO） and a two lap-selectors integrated flying-adder （FA）. With a coiled cell array which allows uniform loading capacitances of the delay cells, the FRO produces 32 outputs with consistent tap spacing for the FA as reference clocks. The FA uses the outputs from the FRO to generate the output of the DCO according to the control number, resulting in a linear dependence of the output period, instead of the frequency on the digital controlling word input. Thus the proposed DCO ensures a good conversion linearity in a time-domain, and is suitable for time-domain all-digital phase locked loop applications. The DCO was implemented in a standard 0.13μm digital logic CMOS process. The measurement results show that the DCO has a linear and monotonic tuning curve with gain variation of less than 10%, and a very low root mean square period jitter of 9.3 ps in the output clocks. The DCO works well at supply voltages ranging from 0.6 to 1.2 V, and consumes 4 mW of power with 500 MHz frequency output at 1.2 V supply voltage.展开更多
A novel variable step-size modified super-exponential iteration(MSEI)decision feedback blind equalization(DFE)algorithm with second-order digital phase-locked loop is put forward to improve the convergence performance...A novel variable step-size modified super-exponential iteration(MSEI)decision feedback blind equalization(DFE)algorithm with second-order digital phase-locked loop is put forward to improve the convergence performance of super-exponential iteration DFE algorithm.Based on the MSEI-DFE algorithm,it is first proposed to develop an error function as an improvement to the error function of MSEI,which effectively achieves faster convergence speed of the algorithm.Subsequently,a hyperbolic tangent function variable step-size algorithm is developed considering the high variation rate of the hyperbolic tangent function around zero,so as to further improve the convergence speed of the algorithm.In the end,a second-order digital phase-locked loop is introduced into the decision feedback equalizer to track and compensate for the phase rotation of equalizer input signals.For the multipath underwater acoustic channel with mixed phase and phase rotation,quadrature phase shift keying(QPSK)and 16 quadrature amplitude modulation(16QAM)modulated signals are used in the computer simulation of the algorithm in terms of convergence and carrier recovery performance.The results show that the proposed algorithm can considerably improve convergence speed and steady-state error,make effective compensation for phase rotation,and efficiently facilitate carrier recovery.展开更多
文摘A low jitter All-Digital Phase-Locked Loop （ADPLL） used as a clock generator is designed. The Digital-Controlled Oscillator （DCO） for this ADPLL is a seven-stage ring oscillator with the delay of each stage changeable. Based on the Impulse Sensitivity Function （ISF） analysis, an effective way is proposed to reduce the ADPLL＇s jitter by the careful design of the sizes of the inverters used in the DCO with a simple architecture other than a complex one. The ADPLL is implemented in a 0.18μm CMOS process with 1.SV supply voltage, occupies 0.046mm^2 of on-chip area. According to the measured results, the ADPLL can operate from 108MHz to 304MHz, and the peak-to-peak jitter is 139ps when the DCO＇s output frequency is 188MHz.
基金The National Natural Science Foundation of China(No. 60974116 )the Research Fund of Aeronautics Science (No.20090869007)Specialized Research Fund for the Doctoral Program of Higher Education (No. 200902861063)
文摘In order to effectively control the working state of the gyroscope in drive mode, the drive characteristics of the micro electromechanical system （MEMS） gyroscope are analyzed in principle. A novel drive circuit for the MEMS gyroscope in digital closed-loop control is proposed, which utilizes a digital phase-locked loop （PLL） in frequency control and an automatic gain control （AGC） method in amplitude control. A digital processing circuit with a field programmable gate array （FPGA） is designed and the experiments are carried out. The results indicate that when the temperature changes, the drive frequency can automatically track the resonant frequency of gyroscope in drive mode and that of the oscillating amplitude holds at a set value. And at room temperature, the relative deviation of the drive frequency is 0.624 ×10^-6 and the oscillating amplitude is 8.0 ×10^-6, which are 0. 094% and 18. 39% of the analog control program, respectively. Therefore, the control solution of the digital PLL in frequency and the AGC in amplitude is feasible.
文摘This paper presents a novel digital dual-loop control scheme of the PWM(PUlse width modulate)inverter. Deadbeat control technique are employed to enhance the performance. Half switching period delayed sampling and control timing strategy is used to improve the system dynamic response. Simulation and experimental results presented in the paper verified the validity of the proposed control scheme.
文摘The closed-loop stability issue of finite-precision realizations was investigated for digital control-lers implemented in block-floating-point format. The controller coefficient perturbation was analyzed resultingfrom using finite word length (FWL) block-floating-point representation scheme. A block-floating-point FWL closed-loop stability measure was derived which considers both the dynamic range and precision. To facilitate the design of optimal finite-precision controller realizations, a computationally tractable block-floating-point FWL closed-loop stability measure was then introduced and the method of computing the value of this measure for a given controller realization was developed. The optimal controller realization is defined as the solution that maximizes the corresponding measure, and a numerical optimization approach was adopted to solve the resulting optimal realization problem. A numerical example was used to illustrate the design procedure and to compare the optimal controller realization with the initial realization.
文摘The stable operation of first and second order Zero Crossing Digital Phase Locked Loop (ZCDPLL) is extended by using a Fixed Point Iteration (FPI) method with relaxation. The non-linear components of ZCDPLL such as sampler phase detector and Digital Controlled Oscillator (DCO) lead to unstable and chaotic operation when the filter gains are high. FPI will be used to stabilize the chaotic operation and consequently extend the lock range of the loop. The proposed stabilized loop can work in higher filter gains which are needed for faster signal acquisition.
基金This work has been partly supported by National Natural Science Foundation of China(NSFC 51877093,51707079,and 51807075),National Key Research and Development Program of China(Project ID:YS2018YFGH000200),and Fund。
文摘In this paper,a sensorless control strategy of a permanent magnet synchronous machine(PMSM)based on an improved rotor flux observer(IFO)is proposed.Due to the unknown integral initial value and the high harmonics caused by current sampling and inverter nonlinearities,the flux linkage estimated by traditional rotor flux observer may be inaccurate.In order to address these issues,a self-adaptive band-pass filter(SABPF)is designed to eliminate the DC component and high-frequency harmonics of the estimated equivalent rotor flux linkage.Furthermore,in order to avoid that the design of PI parameter is influenced by the amplitude of equivalent rotor flux linkage,an improved phase-locked loop(IPLL)is employed to obtain the rotor speed and to normalize the estimated equivalent rotor flux linkage.In addition,angle shift caused by an SABPF is compensated to improve the accuracy of the estimated flux linkage angle.Besides,the parameter robustness of this method is analyzed in detail.Finally,simulation and experimental results demonstrate the effectiveness and parameter robustness of the proposed method.
文摘A time-domain digitally controlled oscillator （DCO） is proposed. The DCO is composed of a free-running ring oscillator （FRO） and a two lap-selectors integrated flying-adder （FA）. With a coiled cell array which allows uniform loading capacitances of the delay cells, the FRO produces 32 outputs with consistent tap spacing for the FA as reference clocks. The FA uses the outputs from the FRO to generate the output of the DCO according to the control number, resulting in a linear dependence of the output period, instead of the frequency on the digital controlling word input. Thus the proposed DCO ensures a good conversion linearity in a time-domain, and is suitable for time-domain all-digital phase locked loop applications. The DCO was implemented in a standard 0.13μm digital logic CMOS process. The measurement results show that the DCO has a linear and monotonic tuning curve with gain variation of less than 10%, and a very low root mean square period jitter of 9.3 ps in the output clocks. The DCO works well at supply voltages ranging from 0.6 to 1.2 V, and consumes 4 mW of power with 500 MHz frequency output at 1.2 V supply voltage.
基金supported by the National Natural Science Foundation of China(61671461)。
文摘A novel variable step-size modified super-exponential iteration(MSEI)decision feedback blind equalization(DFE)algorithm with second-order digital phase-locked loop is put forward to improve the convergence performance of super-exponential iteration DFE algorithm.Based on the MSEI-DFE algorithm,it is first proposed to develop an error function as an improvement to the error function of MSEI,which effectively achieves faster convergence speed of the algorithm.Subsequently,a hyperbolic tangent function variable step-size algorithm is developed considering the high variation rate of the hyperbolic tangent function around zero,so as to further improve the convergence speed of the algorithm.In the end,a second-order digital phase-locked loop is introduced into the decision feedback equalizer to track and compensate for the phase rotation of equalizer input signals.For the multipath underwater acoustic channel with mixed phase and phase rotation,quadrature phase shift keying(QPSK)and 16 quadrature amplitude modulation(16QAM)modulated signals are used in the computer simulation of the algorithm in terms of convergence and carrier recovery performance.The results show that the proposed algorithm can considerably improve convergence speed and steady-state error,make effective compensation for phase rotation,and efficiently facilitate carrier recovery.
