Presented is a theoretical study of double-clad Er-doped fiber power amplifier(EDFA). Two kinds of double clad fibers(DCF) with rectangular and "flower" inner clad shapes are studied, and these fibers have d...Presented is a theoretical study of double-clad Er-doped fiber power amplifier(EDFA). Two kinds of double clad fibers(DCF) with rectangular and "flower" inner clad shapes are studied, and these fibers have different coupling constants and propagation losses. We calculate the effective pump power absorption ratio along the fiber with different coupling constants from the first cladding to the doped core and with different propagation losses for the power in the inner cladding. Then the gains of the double clad Er-doped fiber amplifiers versus fiber lengths are calculated using the EDFA model based on propagation and rate equations of a homogeneous, two-level medium.展开更多
Amplified spontaneous emission （ASE） in diode laser pumped double-clad fiber power amplifiers is studied experimentally, The dependences of ASE on fiber length and cross section of active core are discussed and the ...Amplified spontaneous emission （ASE） in diode laser pumped double-clad fiber power amplifiers is studied experimentally, The dependences of ASE on fiber length and cross section of active core are discussed and the variations of ASE power as the function of pumping and signal power are investigated. There are indications that long fibers with large mode area need stronger input signals to suppress ASE. It is shown that a 150 mW input signal can suppress the ASE by 40 dB in a 4 m large mode area fiber, while to efficiently suppress the ASE in a 10 m fiber, stronger input signal is needed. 12.5 W and 16.1 W single frequency CW output power are obtained from 4 m fiber and 10 m fiber respectively. No stimulated Brillouin scattering （SBS） was observed展开更多
Absorption efficiency of graded-index double-clad fiber lasers or amplifiers is analyzed. As ray optics method is no longer valid for graded-index case, the mode analysis method is used. Calculated results show that a...Absorption efficiency of graded-index double-clad fiber lasers or amplifiers is analyzed. As ray optics method is no longer valid for graded-index case, the mode analysis method is used. Calculated results show that absorption efficiency for a graded-index is higher than that for a step-index in symmetric case. In offset core case, the graded-index can achieve the same absorption efficiency with much smaller offset distance. Absorption efficiencies for different graded-index profiles of the inner cladding are compared.展开更多
Multiple-beam fringes of equal chromatic order interferometry is a powerful technique to extract optical properties over a continuous range of spectrum. In this paper we develop a theory for the spectral shape of the ...Multiple-beam fringes of equal chromatic order interferometry is a powerful technique to extract optical properties over a continuous range of spectrum. In this paper we develop a theory for the spectral shape of the fringes of equal chromatic order (FECO) that are formed across a double-clad fiber. The modified single term Sellmeier dispersion formula is used to construct the refractive index dispersion curves for the liquid, claddings, and core. Expressions for the paraxial optical path length for several rays passing through the fiber and the liquid are developed. The condition of bright fringe is applied to get an analytical expression for the spectral shape of the FECO across a double-clad fiber with an elliptical/circular inner cladding. A potential application of this theory is to determine the dispersion of Kerr constant of the claddings and the core of the fiber. To illustrate the theory and its application, simulation examples are provided and discussed.展开更多
This paper presents an investigation of specific optical fiber core mode leakage behavior that occurs in high-power double-clad fiber lasers as a result of thermally-induced refractive index variations. A model of the...This paper presents an investigation of specific optical fiber core mode leakage behavior that occurs in high-power double-clad fiber lasers as a result of thermally-induced refractive index variations. A model of the power transfer between the core modes and the cladding modes during thermally-induced refractive index variations is established based on the mode coupling theory. The results of numerical simulations based on actual laser parameters are presented. Experimental measurements were also carried out, the results showed good agreement with the corresponding simulation results.展开更多
Nd<sup>3+</sup> -doped double-clad fiber is a new type of fiber that has large N.A.and large receivingarea compared with single-clad rare-earth-doped fiber.So Nd<sup>3+</sup>-doped double-clad ...Nd<sup>3+</sup> -doped double-clad fiber is a new type of fiber that has large N.A.and large receivingarea compared with single-clad rare-earth-doped fiber.So Nd<sup>3+</sup>-doped double-clad fiberpumped directly by laser-diode arrays can be manufactured into high-power fiber lasers,high-power superfluorescence sources and high-gain fiber amplifiers,and they will be applied展开更多
Heat handling has been a significant problem of the high power fiber laser systems as the output power increases rapidly.Cladding power stripper(CPS) which is used to deal with the unwanted optical power and light is ...Heat handling has been a significant problem of the high power fiber laser systems as the output power increases rapidly.Cladding power stripper(CPS) which is used to deal with the unwanted optical power and light is required for higher cooling ability. So the methods of stripping the unwanted light attracted much attention recently, and the thermal effect is given. However, few investigations focus on the dissipation of the heat converted from the unwanted light. In this paper,an approach of active cooling for CPS is demonstrated. This is achieved by using microchannel cooling technology in heat sinking in CPS to improve the efficiency of heat exchange. In order to explain the mechanism of CPS the function of it and consistence of categories of the unwanted light are detailed firstly. Then microchannel heat sinking is proposed and verified by the heat exchange theory. At last, the design of the CPS with microchannel heat sinking is shown and following experiment is conducted. The final temperature of the device with 1000 W cladding power was demonstrated at last to verify the ability of heat distribution of the CPS component. This suggests that these CPSs can be used to stripe a thousand of watts of light in high power double cladding fiber lasers.展开更多
The ultimate capacity of a cladding-pumped 10/130 Tm:fiber is experimentally investigated with a 793 nm laser diode bidirectionally pumped amplifier. The laser system works stably at the output powers of 52 W,65 W, an...The ultimate capacity of a cladding-pumped 10/130 Tm:fiber is experimentally investigated with a 793 nm laser diode bidirectionally pumped amplifier. The laser system works stably at the output powers of 52 W,65 W, and 87 W. Eventually, the damage of the amplifier occurs when the output power reaches about 103.5 W with a total incident pump power of 176.8 W. Considering the incident seed power of 12.3 W,the amplifier conversion efficiency is estimated to be about 51.6% before it is damaged. With valuable exploration, we achieve the first air-cooling 60 W Tm:fiber laser at 1945.845 nm with a spectral linewidth of 0.4 nm.The laser power stability reaches 1.24% during a continuous test time of >65 h. The beam quality is measured as M_x^2=1.16 and M_y^2=1.14.展开更多
基金Foundation of Beijing Jiaotong University(2005RC034)
文摘Presented is a theoretical study of double-clad Er-doped fiber power amplifier(EDFA). Two kinds of double clad fibers(DCF) with rectangular and "flower" inner clad shapes are studied, and these fibers have different coupling constants and propagation losses. We calculate the effective pump power absorption ratio along the fiber with different coupling constants from the first cladding to the doped core and with different propagation losses for the power in the inner cladding. Then the gains of the double clad Er-doped fiber amplifiers versus fiber lengths are calculated using the EDFA model based on propagation and rate equations of a homogeneous, two-level medium.
基金the Ministerial Level Advanced Research Foundation (41302010107)
文摘Amplified spontaneous emission （ASE） in diode laser pumped double-clad fiber power amplifiers is studied experimentally, The dependences of ASE on fiber length and cross section of active core are discussed and the variations of ASE power as the function of pumping and signal power are investigated. There are indications that long fibers with large mode area need stronger input signals to suppress ASE. It is shown that a 150 mW input signal can suppress the ASE by 40 dB in a 4 m large mode area fiber, while to efficiently suppress the ASE in a 10 m fiber, stronger input signal is needed. 12.5 W and 16.1 W single frequency CW output power are obtained from 4 m fiber and 10 m fiber respectively. No stimulated Brillouin scattering （SBS） was observed
文摘Absorption efficiency of graded-index double-clad fiber lasers or amplifiers is analyzed. As ray optics method is no longer valid for graded-index case, the mode analysis method is used. Calculated results show that absorption efficiency for a graded-index is higher than that for a step-index in symmetric case. In offset core case, the graded-index can achieve the same absorption efficiency with much smaller offset distance. Absorption efficiencies for different graded-index profiles of the inner cladding are compared.
文摘Multiple-beam fringes of equal chromatic order interferometry is a powerful technique to extract optical properties over a continuous range of spectrum. In this paper we develop a theory for the spectral shape of the fringes of equal chromatic order (FECO) that are formed across a double-clad fiber. The modified single term Sellmeier dispersion formula is used to construct the refractive index dispersion curves for the liquid, claddings, and core. Expressions for the paraxial optical path length for several rays passing through the fiber and the liquid are developed. The condition of bright fringe is applied to get an analytical expression for the spectral shape of the FECO across a double-clad fiber with an elliptical/circular inner cladding. A potential application of this theory is to determine the dispersion of Kerr constant of the claddings and the core of the fiber. To illustrate the theory and its application, simulation examples are provided and discussed.
基金Project supported by the National Natural Science Foundation of China(Grant Nos.61307057 and 61675114)
文摘This paper presents an investigation of specific optical fiber core mode leakage behavior that occurs in high-power double-clad fiber lasers as a result of thermally-induced refractive index variations. A model of the power transfer between the core modes and the cladding modes during thermally-induced refractive index variations is established based on the mode coupling theory. The results of numerical simulations based on actual laser parameters are presented. Experimental measurements were also carried out, the results showed good agreement with the corresponding simulation results.
文摘Nd<sup>3+</sup> -doped double-clad fiber is a new type of fiber that has large N.A.and large receivingarea compared with single-clad rare-earth-doped fiber.So Nd<sup>3+</sup>-doped double-clad fiberpumped directly by laser-diode arrays can be manufactured into high-power fiber lasers,high-power superfluorescence sources and high-gain fiber amplifiers,and they will be applied
文摘Heat handling has been a significant problem of the high power fiber laser systems as the output power increases rapidly.Cladding power stripper(CPS) which is used to deal with the unwanted optical power and light is required for higher cooling ability. So the methods of stripping the unwanted light attracted much attention recently, and the thermal effect is given. However, few investigations focus on the dissipation of the heat converted from the unwanted light. In this paper,an approach of active cooling for CPS is demonstrated. This is achieved by using microchannel cooling technology in heat sinking in CPS to improve the efficiency of heat exchange. In order to explain the mechanism of CPS the function of it and consistence of categories of the unwanted light are detailed firstly. Then microchannel heat sinking is proposed and verified by the heat exchange theory. At last, the design of the CPS with microchannel heat sinking is shown and following experiment is conducted. The final temperature of the device with 1000 W cladding power was demonstrated at last to verify the ability of heat distribution of the CPS component. This suggests that these CPSs can be used to stripe a thousand of watts of light in high power double cladding fiber lasers.
基金the China Postdoctoral Science Foundation(No.2018M630355)the National Natural Science Foundation of China(No.61905150)the Characteristic Innovation Projects of Scientific Research in Universities of Guangdong Province(Natural Science)(No.2018KTSCX348).
文摘The ultimate capacity of a cladding-pumped 10/130 Tm:fiber is experimentally investigated with a 793 nm laser diode bidirectionally pumped amplifier. The laser system works stably at the output powers of 52 W,65 W, and 87 W. Eventually, the damage of the amplifier occurs when the output power reaches about 103.5 W with a total incident pump power of 176.8 W. Considering the incident seed power of 12.3 W,the amplifier conversion efficiency is estimated to be about 51.6% before it is damaged. With valuable exploration, we achieve the first air-cooling 60 W Tm:fiber laser at 1945.845 nm with a spectral linewidth of 0.4 nm.The laser power stability reaches 1.24% during a continuous test time of >65 h. The beam quality is measured as M_x^2=1.16 and M_y^2=1.14.
