Accurate 3-D fracture network model for rock mass in dam foundation is of vital importance for stability,grouting and seepage analysis of dam foundation.With the aim of reducing deviation between fracture network mode...Accurate 3-D fracture network model for rock mass in dam foundation is of vital importance for stability,grouting and seepage analysis of dam foundation.With the aim of reducing deviation between fracture network model and measured data,a 3-D fracture network dynamic modeling method based on error analysis was proposed.Firstly,errors of four fracture volume density estimation methods(proposed by ODA,KULATILAKE,MAULDON,and SONG)and that of four fracture size estimation methods(proposed by EINSTEIN,SONG and TONON)were respectively compared,and the optimal methods were determined.Additionally,error index representing the deviation between fracture network model and measured data was established with integrated use of fractal dimension and relative absolute error(RAE).On this basis,the downhill simplex method was used to build the dynamic modeling method,which takes the minimum of error index as objective function and dynamically adjusts the fracture density and size parameters to correct the error index.Finally,the 3-D fracture network model could be obtained which meets the requirements.The proposed method was applied for 3-D fractures simulation in Miao Wei hydropower project in China for feasibility verification and the error index reduced from 2.618 to 0.337.展开更多
Serpentine nozzles are widely used in combat aircraft to realize strong stealth characteristics.Based on the layout characteristics within a confined space,a series of double serpentine nozzles with spanwise offsets a...Serpentine nozzles are widely used in combat aircraft to realize strong stealth characteristics.Based on the layout characteristics within a confined space,a series of double serpentine nozzles with spanwise offsets are established.Using computational fluid dynamics and Taguchi method,the influence mechanisms of the Distribution of Area(DA),Distributions of Centerline for the first and second‘S’sections in the Vertical direction(DCV1 and DCV2),and Distribution of Centerline in the Spanwise direction(DCS)are analyzed.The impact of these factors on the total pressure recovery coefficient can be ranked as DA>DCV2>DCS>DCV1,whereas their impacts on the discharge coefficient and axial thrust coefficient can be ranked as DCV2>DCS>DA>DCV1.Considering the statistical significance of these factors,a nozzle in which DA changes rapidly at the exit and DCV1,DCV2,and DCS change rapidly at the entrance gives the best aerodynamic performance.Compared to the worst configuration,the total pressure recovery coefficient,discharge coefficient,and axial thrust coefficient are improved by 1.6%,3.5%and 3.6%,respectively.DA influences the gas flow acceleration in the entire serpentine channel,resulting in different wall shear stress and friction losses.The various centerline distributions influence the gas flow acceleration effects and form complex wave structures in the constantarea extension section,resulting in different local and friction losses.展开更多
对于带未知模型参数和噪声方差的多传感器系统,基于分量按标量加权最优融合准则,提出了自校正解耦融合Kalman滤波器,并应用动态误差系统分析(Dynamic error system analysis,DESA)方法证明了它的收敛性.作为在信号处理中的应用,对带有...对于带未知模型参数和噪声方差的多传感器系统,基于分量按标量加权最优融合准则,提出了自校正解耦融合Kalman滤波器,并应用动态误差系统分析(Dynamic error system analysis,DESA)方法证明了它的收敛性.作为在信号处理中的应用,对带有色和白色观测噪声的多传感器多维自回归(Autoregressive,AR)信号,分别提出了AR信号模型参数估计的多维和多重偏差补偿递推最小二乘(Bias compensated recursive least-squares,BCRLS)算法,证明了两种算法的等价性,并且用DESA方法证明了它们的收敛性.在此基础上提出了AR信号的自校正融合Kalman滤波器,它具有渐近最优性.仿真例子说明了其有效性.展开更多
基金Project(51321065)supported by the Innovative Research Groups of the National Natural Science Foundation of ChinaProject(2013CB035904)supported by the National Basic Research Program of China(973 Program)Project(51439005)supported by the National Natural Science Foundation of China
文摘Accurate 3-D fracture network model for rock mass in dam foundation is of vital importance for stability,grouting and seepage analysis of dam foundation.With the aim of reducing deviation between fracture network model and measured data,a 3-D fracture network dynamic modeling method based on error analysis was proposed.Firstly,errors of four fracture volume density estimation methods(proposed by ODA,KULATILAKE,MAULDON,and SONG)and that of four fracture size estimation methods(proposed by EINSTEIN,SONG and TONON)were respectively compared,and the optimal methods were determined.Additionally,error index representing the deviation between fracture network model and measured data was established with integrated use of fractal dimension and relative absolute error(RAE).On this basis,the downhill simplex method was used to build the dynamic modeling method,which takes the minimum of error index as objective function and dynamically adjusts the fracture density and size parameters to correct the error index.Finally,the 3-D fracture network model could be obtained which meets the requirements.The proposed method was applied for 3-D fractures simulation in Miao Wei hydropower project in China for feasibility verification and the error index reduced from 2.618 to 0.337.
基金supported by the National Science and Technology Major Project of China(No.J2019-III-0009-0053).
文摘Serpentine nozzles are widely used in combat aircraft to realize strong stealth characteristics.Based on the layout characteristics within a confined space,a series of double serpentine nozzles with spanwise offsets are established.Using computational fluid dynamics and Taguchi method,the influence mechanisms of the Distribution of Area(DA),Distributions of Centerline for the first and second‘S’sections in the Vertical direction(DCV1 and DCV2),and Distribution of Centerline in the Spanwise direction(DCS)are analyzed.The impact of these factors on the total pressure recovery coefficient can be ranked as DA>DCV2>DCS>DCV1,whereas their impacts on the discharge coefficient and axial thrust coefficient can be ranked as DCV2>DCS>DA>DCV1.Considering the statistical significance of these factors,a nozzle in which DA changes rapidly at the exit and DCV1,DCV2,and DCS change rapidly at the entrance gives the best aerodynamic performance.Compared to the worst configuration,the total pressure recovery coefficient,discharge coefficient,and axial thrust coefficient are improved by 1.6%,3.5%and 3.6%,respectively.DA influences the gas flow acceleration in the entire serpentine channel,resulting in different wall shear stress and friction losses.The various centerline distributions influence the gas flow acceleration effects and form complex wave structures in the constantarea extension section,resulting in different local and friction losses.
