Feedback model of secondary electron emission in DC gas discharge plasmas

Feedback is said to exist in any amplifier when the fraction of output power in fed back as an input.Similarly,in gaseous discharge ions that incident on the cathode act as a natural feedback element to stabilize and self sustain the discharge.The present investigation is intended to emphasize the feedback nature of ions that emits secondary electrons（SEs）from the cathode surface in DC gas discharges.The average number of SEs emitted per incident ion and non ionic species（energetic neutrals,metastables and photons）which results from ion is defined as effective secondary electronemission coefficient（ESEEC,Eg）.In this study,we derive an analytic expression that corroborates the relation betweenEg and power influx by ion to the cathode based on the feedback theory of an amplifier.In addition,experimentally,we confirmed the typical positive feedback nature of SEEfrom the cathode in argon DC glow discharges.The experiment is done for three different cathode material of same dimension（tungsten（W）,copper（Cu）and brass）under identical discharge conditions（pressure：0.45 mbar,cathode bias：-600 V,discharge gab：15 cm and operating gas：argon）.Further,we found that theEg value of these cathode material controls the amount of feedback power given by ions.The difference in feedback leads different final output i.e the power carried by ion at cathode（Pi C￠∣）.The experimentally obtained value of Pi C￠∣is 4.28 W,6.87 W and9.26 W respectively for W,Cu and brass.In addition,the present investigation reveals that the amount of feedback power in a DC gas discharges not only affect the fraction of power fed back to the cathode but also the entire characteristics of the discharge.

Effects of Doubled_CO_2 Concentration on Ultrastructure, Supramolecular Architecture and Spectral Characteristics of Chloroplasts from Wheat

Wheat ( Triticum aestivum L.) plants were grown under ambient and doubled_CO 2(plus 350 μL/L) concentration in cylindrical open_top chamber to examine their effects on the ultrastructure, supramolecular architecture, absorption spectrum and low temperature (77 K) fluorescence emission spectrum of the chloroplasts from wheat leaves. The results were briefly summarized as follows: (1) The wheat leaves possessed normally developed chloroplasts with intact grana and stroma thylakoid membranes; The grana intertwined with stroma thylakoid membranes and increased slightly in stacking degree and the width of granum, in spite of more accumulated starch grains within the chloroplasts than those in control; (2) The particle density in the stacked region of the endoplasmic fracture face (EFs) and protoplasmic fracture face (PFs) and in the unstacked region the endoplasmic fracture face (EFu) and the protoplasmic fracture face (PFu) was significantly higher than that of control. Furthermore, in some cases many more particles on EFs faces of thylakoid membranes appeared as a paracrystalline particle array; (3) The variations in the structure of chloroplasts were consistent with the absorption spectra and the low temperature (77 K) fluorescence emission spectra of the chloroplasts developed under the doubled_CO 2 concentration. Results indicate that the capability of light energy absorption of chloroplasts and regulative capability of excitation energy distribution between PSⅡ and PSⅠ were raised by doubled_CO 2 concentration. This is very favorable for final productivity of wheat.

InAs/InAsSb type-Ⅱ superlattice with near room-temperature long-wave emission through interface engineering

Ga-free InAs/InAsSb type-Ⅱ superlattices(T2SL) have extensive application prospective in infrared photodetectors. Achieving higher operation temperature is critical to its commercial applications. Here, a fractional monolayer alloy method was used to grow InAsSb alloy with better controlled alloy composition. The as-grown T2SL gave eleven satellite peaks and a first satellite peak with a narrow full-width-half-maximum (FWHM) of 20.5arcsec (1 arcsec=0.01592°). Strain mapping results indicated limited Sb diffusion through the As-Sb exchange process at the interface. Moreover, unlike interface states caused by the As-Sb exchange effect, this relatively clear interface was distinctive with localized states with higher activation energies of the non-radiative recombination process ((18±1) meV and (84±12) meV at different temperature ranges), which means that this interface state introduced by fractional monolayer alloy growth method can effectively suppress Auger recombination process in T2SL. Through this interface engineering of InAs/InAsSb Type-Ⅱ superlattice, it achieved detective photoluminescence (PL) signal with the center wavelength of 9μm at 250K.

Particle-in-Cell Simulation Study on the Floating Potential of Spacecraft in the Low Earth Orbit

In order to further understand the characteristics of the floating potential of low earth orbit spacecraft,the effects of the electron current collection area,background electron temperature,photocurrent emission,spacecraft wake,and the shape of spacecraft on spacecraft floating potential were studied here by particle-in-cell simulation in the low earth orbit.The simulation results show that the electron current collection area and background electron temperature impact on the floating potential by changing the electron current collection of spacecraft.By increasing the electron current collection area or background electron temperature,the spacecraft will float at a lower electric potential with respect to the surrounding plasma.However,the spacecraft wake affects the floating potential by increasing the ion current collected by spacecraft.The emission of the photocurrent from the spacecraft surface,which compensates for the electrons collected from background plasma,causes the floating potential to increase.The shape of the spacecraft is also an important factor influencing the floating potential.

Simultaneous retrieval of land surface temperature and emissivity from the FengYun-4A advanced geosynchronous radiation imager

This paper extends a new temperature and emissivity separation(TES)algorithm for retrieving land surface temperature and emissivity(LST and LSE)to the Advanced Geosynchronous Radiation Imager(AGRI)onboard Fengyun-4A,China’s newest geostationary meteorological satellite.The extended TES algorithm was named the AGRI TES algorithm.The AGRI TES algorithm employs a modified water vapor scaling(WVS)method and a recalibrated empirical function over vegetated surfaces.In situ validation and cross-validation are utilized to investigate the accuracy of the retrieved LST and LSE.LST validation using the collected field measurements showed that the mean bias and RMSE of AGRI TES LST are 0.58 and 2.93 K in the daytime and−0.30 K and 2.18 K at nighttime,respectively;the AGRI official LST is systematically underestimated.Compared with the MODIS LST and LSE products(MYD21),the average bias and RMSE of AGRI TES LST are−0.26 K and 1.65 K,respectively.The AGRI TES LSE outperforms the AGRI official LSE in terms of accuracy and spatial integrity.This study demonstrates the good performance of the AGRI TES algorithm for the retrieval of high-quality LST and LSE,and the potential of the AGRI TES algorithm in producing operational LST and LSE products.

New hybrid algorithm for land surface temperature retrieval from multiple-band thermal infrared image without atmospheric and emissivity data inputs

Land surface temperature(LST)retrieval from thermal infrared(TIR)remote sensing image requires atmospheric and land surface emissivity(LSE)data that are sometimes unattainable.To overcome this problem,a hybrid algorithm is developed to retrieve LST without atmospheric correction and LSE data input,by combining the split-window(SW)and temperature–emissivity separation(TES)algorithms.The SW algorithm is used to estimate surface-emitting radiance in adjacent TIR bands,and such radiance is applied to the TES algorithm to retrieve LST and LSE.The hybrid algorithm is implemented on five TIR bands of the Advanced Spaceborne Thermal Emission and Reflection Radiometer(ASTER).Analysis shows that the hybrid algorithm can estimate LST and LSE with an error of 0.5–1.5 K and 0.007–0.020,respectively.Moreover,the LST error of the hybrid algorithm is equivalent to that of the original ASTER TES algorithm,involving 1%–2%uncertainty in atmospheric correction.The hybrid algorithm is validated using ground-measured LST at six sites and ASTER LST products,indicating that the temperature difference between the ASTER TES algorithm and the hybrid algorithm is 1.4 K and about 2.5–3.5 K compared to the ground measurement.Finally,the hybrid algorithm is applied to at two places.

Physics-based simultaneous retrieval of atmospheric temperature-humidity profiles and land surface temperature-emissivity by integrating Terra/Aqua MODIS measurements

Atmospheric temperature-humidity profiles and land or sea surface temperature are coupled actions in the earth system process. Based on the numerical perturbation form of the atmospheric radiative transfer equation, a physics-based algorithm is pre- sented to integrate four pairs of MODIS measurements from the Terra and Aqua satellites to retrieve simultaneously atmospheric temperature-humidity profile, land-surface temperature and emissivity. Three pairs of MODIS data at two field sites in China, Luancheng and Poyang Lake areas, have been chosen to test and validate the model. Two pairs of atmospheric tem- perature and humidity profiles, land surface temperature (LST), and land surface emissivity (LSE) have been retrieved simul- taneously for every pair of MODIS measurements respectively by the proposed physical algorithm for the study area. The synchronous field measurements at two field sites were conducted to validate the retrieval LST, the differences between the retrieved LST and the field measurements are in the range of -0.15 K and 1.11 K. The emissivity errors of MODIS bands 31 and 32, compared with the EOS MODIS LST/LSE data products (MOD11_L2/MYD11_L2 V5) by the physics-based day/night algorithm, are from 0.0018 to 0.44 and from 0.0058 to 1.24, respectively. Meanwhile, the retrieved atmospheric profiles fully agree with the standard atmospheric temperature-water vapor profiles and with the results from single MODIS data onboard Terra or Aqua satellite by the former two-step physical algorithm. Therefore, the proposed algorithm is robust enough to improve the retrieval accuracy of the atmospheric profiles and land surface parameters. And it will have four pairs of the retrieval results for one area each day by integrating these MODIS measurements from Terra and Aqua satellites.

REMOTE SENSING OF AIR TEMPERATURE PROFILE AND SURFACE EMISSIVITY FROM HIRS2 DATA

A physical method,based on the simplification of surface radiation terms in remote sensing equations, has been suggested to retrieve the surface temperature,vertical temperature profile and surface emissivity from the first eight channel observations of TIROS-N/HIRS2.Analyses of several examples indicate that this method can obtain much more accurate temperatures in the lower atmosphere than a statistical technique, and that the surface temperature and emissivity retrieved are also reasonable.

EMISSIVITIES OF NATURAL SURFACES AND SURFACE TEMPERATURE

A simple method of determining emissivity of surface using Eppley pyrgeometer in situ is presented to evaluate surface temperature exactly.The indicated temperature of radiometer needs corrections for actual sky thermal radiance and for true surface emissivities.Comparisons between radiation temperature and surface mercury-thermometer temperature at Nagqu,northern Tibet during December 1985—January 1986 have shown that their differences are mostly within 2—4℃

Plasma parameter diagnosis using hydrogen emission spectra of a quartz-chamber 2.45 GHz ECRIS at Peking University

A quartz-chamber 2.45 GHz electron cyclotron resonance ion source(ECRIS) was designed for diagnostic purposes at Peking University [Patent Number: ZL 201110026605.4]. This ion source can produce a maximum 84 m A hydrogen ion beam at 50 k V with a duty factor of 10%. The root-mean-square(RMS) emittance of this beam is less than 0.12π mm mrad. In our initial work,the electron temperature and electron density inside the plasma chamber had been measured with the line intensity ratio of noble gases. Based on these results, the atomic and molecular emission spectra of hydrogen were applied to determine the dissociation degree of hydrogen and the vibrational temperature of hydrogen molecules in the ground state, respectively. Measurements were performed at gas pressures from 4×10^(-4) to 1×10^(-3) Pa and at input peak RF power ranging from 1000 to 1800 W. The dissociation degree of hydrogen in the range of 0.5%-10% and the vibrational temperature of hydrogen molecules in the ground state in the range of 3500-8500 K were obtained. The plasma processes inside this ECRIS chamber were discussed based on these results.

Preparation and performance evaluation of Er_2O_3 coating-type selective emitter

An Er203 coating-type selective emitter for themophotovoltaic application was prepared by plasma spray technology. The test results show that plasma spray technology could be used to prepare the Er203 coating-type selective emitter with good stability at 1400℃. Based on the measurements of the high temperature normal spectral emissivity and the spectral hemispherical emissivity of the samples at room temperature, the influence of the coating thickness was discussed, and the selective emission performance of the sample was evaluated using radiative efficiency as the criterion. The results demonstrate that the emission of substrate could not be neglected unless the coating thickness would be larger than the penetration depth, which is around 100 μm. The selective emission peak of the Er203 coating occurs at 1550 nm, matching well with the GaSb cells. However, the radiative efficiency is not larger than that of the SiC emitter, because the non-convertible emission of 1.725-5 μm accounts for a large proportion of the total radiation power, especially at high temperature. Effective suppression of this band emission is essential to the improvement of the radiation efficiency of the emitter.

Spatiotemporal dynamic of environmental indices of watershed sustainability in connection with land-use change

Exploring spatial and temporal land-use changes is valuable for local governments to address issues of sustainability and planning policy where urbanization and industrialization are taking place.Besides anthropogenic effects,natural driving forces like climate change may also affect sustainability.However,such relationships have not been studied minutely.Hence,this study first investigates the land-use changes and their relationship with land surface temperature(LST)for the Shazand Watershed,Iran,in 1986,1998,2008,and 2016 coincided with supplementary industrialization stages.Furthermore,the relations among LST and other biophysical parameters,including Normalized Difference Vegetation Index(NDVI),Normalized Difference Buildup Index(NDBI),and Normalized Difference Water Index(NDWI),were analyzed,and corresponding variations were explored.The results indicated that the mean LST of the study watershed has an increasing trend from 1986 to 2008 due to land-use change and drought intensification.Later,LST decreased in 2016.Lower LST was associated with irrigation farming and orchard,and higher LST was related to sparse oak forest areas.There was also a negative correlation between LST and NDVI.As a result,it was inferred that greenery declined LST.Conversely,a positive correlation was found between LST and NDBI resulting from the built-up areas.Since LST could influence biological,physical,chemical processes,it can therefore be supported as an effective index for environmental sustainability assessment.