Removal of disinfection by-products formation potential by biologically intensified process

The removal of disinfection by-products formation potential(DBPFP) in artificially intensified biological activated carbon(IBAC) process which is developed on the basis of traditional ozone granular activated carbon was evaluated. By IBAC removals of 31% and 68% for THMFP and HAAFP were obtained respectively. Under identical conditions, the removals of the same substances were 4% and 32% respectively only by the granular activated carbon(GAC) process. Compared with GAC, the high removal rates of the two formed potential substances were due to the increasing of bioactivity of the media and the synergistic capabilities of biological degradation cooperating with activated carbon adsorption of organic compounds. A clear linear correlation(R 2=0.9562 and R 2=0.9007) between DOC HAAFP removal rate and Empty Bed Contact Time(EBCT) of IBAC process was observed, while that between THMFP removal rate and EBCT of GAC was R 2=0.9782. In addition certain linear correlations between THMFP, HAAFP and UV 254 (R 2=0.855 and R 2=0.7702) were found for the treated water. For IBAC process there are also more advantages such as long backwashing cycle time, low backwashing intensity and prolonging activated carbon lifetime and so on.

Performance of biotrickling filters packed with structured or cubic polyurethane sponges for VOC removal

Two identical bench-scale biotrickling filters （BTFs）, BTF 1 and BTF 2, were evaluated for toluene removal at various gas empty bed contact times （EBCTs） and organic loadings. BTF 1 and BTF 2 were packed with structured and cubic synthetic polyurethane sponges, respectively. At a constant toluene loading of 16 g/（m3.hr）, toluene removal efficiencies decreased from 98.8% to 64.3% for BTF 1 and from 98.4% to 74.1% for BTF 2 as gas EBCT decreased from 30 to 5 sec. When the toluene loading increased from 35 to 140 g/（m3.hr） at a gas EBCT of 30 sec, the removal efficiencies decreased from 99.1% to 77.4% for BTF 1 and from 99.0% to 81.5% for BTF 2. The pressure drop for both BTFs increased with increased air flow rate, and did not significantly vary while the toluene loading was increased under similar operation conditions. BTF 1 and BTF 2 could start up successfully within 19 and 27 days, respectively, when packed with fresh sponge media, and the performances could be restored in 3-7 days after biomass was removed and wasted from the media. BTF 2 displayed higher removal efficiency even under shorter EBCT or higher loading rate than BTF1 when other operation conditions were similar, while it showed lower pressure drop than BTF 1 during the whole period of operation. These results demonstrated that both BTFs could treat waste gas containing toluene effectively.

A review on treatment of disinfection byproduct precursors by biological activated carbon process

Disinfection by-products(DBPs)in water systems have attracted increasing attention due to their toxic effects.Removal of precursors(mainly natural organic matter(NOM))prior to the disinfection process has been recognized as the ideal strategy to control the DBP levels.Currently,biological activated carbon(BAC)process is a highly recommended and prevalent process for treatment of DBP precursors in advanced water treatment.This paper first introduces the fundamental knowledge of BAC process,including the history,basic principles,typical process flow,and basic operational parameters.Then,the selection of BAC process for treatment of DBP precursors is explained in detail based on the comparative analysis of dominant water treatment technologies from the aspects of mechanisms for NOM removal as well as the treatability of different groups of DBP precursors.Next,a thorough overview is presented to summarize the recent developments and breakthroughs in the removal of DBP precursors using BAC process,and the contents involved include effect of pre-BAC ozonation,removal performance of various DBP precursors,toxicity risk reduction,fractional analysis of NOM,effect of empty bed contact time(EBCT)and engineered biofiltration.Finally,some recommendations are made to strengthen current research and address the knowledge gaps,including the issues of microbial mechanisms,toxicity evaluation,degradation kinetics and microbial products.