STRUCTURE IMPROVEMENT AND TEMPERATURE FIELD SIMULATION OF PREPARING NANOPOWDER BY EVAPORATION-CONDENSATION METHOD

A new apparatus, with a segregable conical water cooling condenser, which is heated by an electric arc using the evaporation-condensation method to prepare carbon-coated nanopowder, has been developed by the authors. Numerical simulation of the temperature field is done by the ANSYS software, and temperature in the reaction vessel is measured with the help of an experiment, to verify the simulation result. Influence of the temperature field in the reaction vessel, on the process of preparing nanopowder is then discussed simply. It is shown that the segregable conical water cooling condenser and carbon-coated surface process can be used to prepare steady carbon-coated metal nanopowder, at a lower cost and higher yield rate than the traditional structure. Simulation of the temperature field in the apparatus shows that the arc heating method can form a temperature field in the apparatus, which is quite favorable for nanopowder formation. Experiments show that the rational parameters using this apparatus, with the arc heating method to prepare carbon-coated nanopowder are electricity 60-100 A and arc length 5-8 mm.

Mathematical and Physical Fractals

A review of the concepts developed about mathematical and physical fractals is presented followed by experimental results of the latter, considered to be a fourth state of matter which pervades the universe from galaxies to submicroscopic systems. A model of multiple fractal aggregation via a computer code is shown to closely simulate physical fractals experiments carried out in simulated and in real low gravity.

Microstructural evolution and mechanism of grain growth in magnesia ceramics prepared by high pressure and temperature with ultra-high heating rate

The fast densification method of combustion reaction plus quick pressing was adopted to prepare nanocrystalline ceramics.The densification process of magnesia compact with a particle size of 100 nm was investigated,under the applied pressure of up to 170 MPa,and the temperature range of 1740–2080 K with ultra-high heating rate(above 1700 K/min).High-purity magnesia ceramics with a relative density of 98.8%and an average grain size of 120 nm was obtained at 1740 K,and the grain growth during the densification process was effectively restrained.The characteristic morphology of evaporation-condensation was observed in the compact prepared at 2080 K,which revealed the actual process of mass transfer by gas diffusion.Moreover,the investigation on the microstructure evolution and mechanism of grain growth was carried out,on the basis of as-preserved nanocrystalline ceramics.The result indicated that the grain growth of the nanocrystalline MgO was controlled by the mechanism of evaporation-condensation rather than surface diffusion.Furthermore,the pressure had an influence of restraining the grain growth based on solid diffusion and strengthening the effect of gas diffusion with the increasing temperature.Under the particular conditions,there existed an appropriate temperature for the densification of nanocrystalline magnesia,while the excessive temperature would exaggerate grain growth and impede densification.

Hydrodynamic Regimes,Knudsen Layer,Numerical Schemes:Definition of Boundary Fluxes

We propose a numerical solution to incorporate in the simulation of a system of conservation laws boundary conditions that come from a microscopic modeling in the small mean free path regime.The typical example we discuss is the derivation of the Euler system from the BGK equation.The boundary condition relies on the analysis of boundary layers formation that accounts from the fact that the incoming kinetic flux might be far from the thermodynamic equilibrium.