EFFECTS OF COOLED EXTERNAL EXHAUST GAS RECIRCULATION ON DIESEL HOMOGENEOUS CHARGE COMPRESSION IGNITION ENGINE

The effects of cooled external exhaust gas recirculation （EGR） on the combustion and emission performance of diesel fuel homogeneous charge compression ignition （HCCI） are studied. Homogeneous mixture is formed by injecting fuel in-cylinder in the negative valve overlap （NVO） period. So, the HCCI combustion which has low NOx and smoke emission is achieved. Cooled external EGR can delay the start of combustion effectively, which is very useful for high cetane fuel （diesel） HCCI, because these fuels can easily self-ignition, which makes the start of combustion more early. External EGR can avoid the knock combustion of HCCI at high load which means that the EGR can expand the high load limit. HCCI maintains low smoke emission at various EGR rate and various load compared with conventional diesel engine because there is no fuel-rich area in cylinder.

EGR的热效应和稀释效应对柴油机燃烧和排放的影响

以改进的KIVA-3V程序为计算平台,在转速为1,600,r/min,每循环喷油量为52.8,mg工况下,分别进行了EGR的热效应和稀释效应对柴油机燃烧和排放影响的数值模拟.结果表明,EGR的热效应对滞燃期影响较大,而稀释效应成为制约最高爆发压力和缸内温度的主要因素,且随着氧气体积分数的降低,热效应对最高爆发压力的影响增强;EGR导致碳烟排放增加是由于EGR的稀释效应,低温燃烧时碳烟排放的降低是EGR的稀释效应和热效应相互作用的结果;相比稀释效应,EGR的热效应是实现低温燃烧的主要因素,高进气热容更易改善NOx和碳烟排放的折衷关系.

Influence of Exhaust Gas Recirculation on Low-Load Diesel Engine Performance

In the condition of constant speed and light load, an experimental study of a turbocharged and intercooled diesel engine with exhaust gas recirculation （EGR） system focuses on the influence of different EGR rates on combustion process, dynamic performance, economic performance and emission performance of a diesel engine. With the increase of EGR rate, the oxygen concentration of the intake-side decreases, the fuel air equivalence ratio increases, and the maximum explosion pressure in the cylinder decreases. Meanwhile, the average temperature in the cylinder drops, the ignition delay is prolonged, the ignition timing delays, and the maximum heat release rate decreases. The increase of EGR rate makes NOx emissions decrease obviously and continue to decline. When EGR is low, the smoke rate enlarges slowly with the increase of EGR rate, and enlarges greatly at the rate higher than 43% and reaches the maximum at the rate of 57%. When EGR rate is higher than 61%, the smoke rate drops rapidly, and the content of CO and hydrocarbon （HC） increases rapidly with high EGR rate.

Combustion analysis of a hydrogen-diesel fuel operated DI diesel engine with exhaust gas recirculation

The rapid depletion of fossil fuel and growing demand necessitates researchers to find alternative fuels which are clean and sustainable. The need for finding renewable, low cost and environmentally friendly fuel resources can never be understated. An efficient method of generation and storage of hydrogen will enable automotive manufacturers to introduce hydrogen fuelled engine in the market. In this paper, a conventional DI diesel engine was modified to operate as gas engine. The intake manifold of the engine was supplied with hydrogen along with recirculated exhaust gas and air. The injection rates of hydrogen were maintained at three levels with 2 L/min, 4 L/min, 6 L/min and 8 L/min and 10 L/min with an injection pressure of 2 bar. Many of the combustion parameters like heat release rate （HRR）, ignition delay, combustion duration, rate of pressure rise （ROPR）, cumulative heat release rate （CHR）, and cyclic pressure fluctuations were measured. The HRR peak pressure decreased with the increase in EGR rate, while combustion duration increased with the EGR rate. The cyclic pressure variation also increased with the increase in EGR rate.

Nonlinear observer-based control design and experimental validation for gasoline engines with EGR

This paper presents a nonlinear observer-based control design approach for gasoline engines equipped with exhaust gas recirculation (EGR) system. A mean value engine model is designed for control which includes both the in take manifold and exhaust manifold dynamic focused on gas mass flows. Then, the nonlinear feedback controller based on the developed model is designed for the state tracking control, and the stability of the close loop system is guaranteed by a constructed Lyapunov function. Since the exhaust manifold pressure is usually unmeasurable in the production engines, a nonlinear observer-based feedback controller is proposed by using standard sensors equipped on the engine, and the asymptotic stability of the both observer dynamic system and control dynamic system are guaranteed with Lyapunov design assisted by the detail analysis of the model. The experimental validations show that the observer-based nonlinear feedback controller is able to regulate the in take pressure and exhaust pressure state to the desired values during both the steady-state and transient conditions quickly by only using the standard sensors.

Effect of exhaust gas recirculation and ethyl hexyl nitrate additive on biodiesel fuelled diesel engine for the reduction of NOx emissions

Cetane improvers reduce the ignition delay, which in turn reduces the combustion temperatures thereby reduce NOx emissions. Exhaust gas recirculation （EGR） proved to be an effective way to reduce the NOx emissions. In this present experimental work, a combination of exhaust gas recirculation and cetane improver ethyl hexyl nitrate （EHN） is used to investigate the performance and exhaust emissions of a single cylinder four stroke naturally aspirated direct injection and air cooled diesel engine. Test results show that the brake thermal efficiency increases with the increase in the percentage of EGR which is accompanied by a reduction in brake specific fuel consumption and exhaust gas temperatures, and that bio- diesel with cetane improver under 20% EGR reduces NOx emissions by 33% when compared to baseline fuel without EGR. However carbon monoxide （CO）, hydro carbon （HC） and smoke emissions increase with an increase in percentage of EGR.

Heat Transfer Enhancement by Vortex Generators for Compact Heat Exchanger of Automobiles

The paper describes the effects of heat transfer enhancement and gas-flow characteristics by wing-type-vortex-generators inside a rectangular gas-flow duct of a plate-fin structure exhaust gas recirculation (EGR) cooler used in a cooled-EGR system. The analyses are conducted using computational fluid dynamics (CFD). The numerical modelling is designed as a gas-flow rectangular duct of an EGR cooler using two fluids with high temperature gas and coolant water whose flow directions are opposite. The gas-flow duct used to separate two fluids is assembled with a stainless steel material. The inlet temperature and velocity of gas flowed inside gas-flow duct are 400°C and 30 m/s, respectively. Coolant water is flowed into two ducts on both a top and a bottom surface of the gas-flow duct, and the inlet temperature and velocity is 80°C and 0.6 m/s, respectively. Wing-type-vortex-generators are designed to achieve good cooling performance and low pressure drop and positioned at the center of the gas-flow duct with angle of inclination from 30 to 150 degrees at every 15 degrees. The temperature distributions and velocity vectors gained from numerical results were compared, and discussed. As a result, it is found that the vortices guided in the proximity of heat transfer surfaces play an important role in the heat transfer enhancement and low pressure drop. The collapse of the vortices is caused by complicated flow induced in the corner constituted by two surfaces inside gas-flow duct.

Simulation of VGT control based on charge oxygen concentration

A turbocharged diesel engine model was built with the GT-Power software,and experimentally verified.Then two different control variables for the control of the variable geometry turbocharger（VGT）were described,and their distinct effects on engine performance,i.e.NOxand soot emissions and fuel consumption,were simulated and compared on the basis of this model.The results showed that NOxemissions decreased obviously with the increase of exhaust gas recirculation（EGR）rate at constant boost pressure condition,but soot emissions and fuel consumption considerably increased.It was a good way to reduce NOxemissions without increasing fuel consumption and soot emissions when VGT was controlled to maintain the excess oxygen ratio unchanged as EGR rate increases.

NOx Emission Reduction Technology for Marine Engine Based on Tier-Ⅲ:A Review

The development of maritime trade has greatly promoted the development of diesel engines.However,with the increasingly serious environmental problems,more and more attention has been paid to the exhaust emissions of high-power marine diesel engines.The restrictions on SOx have been implemented globally,and the limitation of the NO,will be the next priority.This paper illustrates(a)Principle and research progress of NOx emissions-reduction technology of marine diesel engine;(b)Summary of advantages and disadvantages among various reduction technologies and their reduction effects;(c)The application effect of mainstream technology on board.Firstly,since exhaust gas recirculation(EGR)can achieve Tier-Ⅲ directly from Tier-Ⅰ without considering the increased fuel consumption.It is deemed as the most promising technology to reduce emissions by controlling combustion condition.However,EGR has shortcomings of excessive increase in ftiel consumption and generation of waste water,which need to be solved immediately.Secondly,selective catalytic reduction(SCR)is the most effective and straightforward means to achieve Tier-Ⅲ.Despite of the continuous optimization of SCR unit volume,the problem of scrap catalyst seriously limits its wide application.How to match the supercharger more efficiently is a key factor in choosing between high and low pressure SCR.Thirdly,nature gas(NG)engines are capable of achieving a reduction in NOx,but in order to meet the requirements of Tier-Ⅲ,it still needs to be assisted by other technologies.The emissions of hydrocarbon(HC)and CO in NG engines are huge defects that must be solved.Lastly,technologies such as the Miller cycle,Two-stage supercharging and mixed-water combustion can also reduce emissions but were rarely used alone.These technologies can be combined with EGR,SCR and NG engines to optimize the enginesJ economy and emission characteristics.

Transient emission simulation and optimization o turbocharged diesel engine

In order to alleviate the pressure of experi- mental research of turbocharged diesel engine under transient operations, a whole process simulation platform for turbocharged diesel engine under transient operations was established based on the multi-software coupling technologies of Matlab/Simulink, GT-Power, STAR-CD and artificial neural network. Aimed at the contradiction of NOx and soot emission control with exhaust gas recirculation （EGR） of turbocharged diesel engine under transient operations, on this simulation platform, a transient EGR valve control strategy was proposed, which adjusted the EGR valve in adjacent level based on the feedback of its opening according soot control limit under transient operations. Simulation and experimental results prove that the transient emission optimization effect of this control strategy is obvious. On the one hand, compared with the previous control strategy, which closed the EGR valve during the whole transient operations, soot emission is slightly increased by 9.5%, but it is still 9% lower than the control limit. On the other hand, compared with the previous control strategy, NOx transient emission is reduced by 44%.