Fiber core mode leakage induced by refractive index variation in high-power fiber laser

This paper presents an investigation of specific optical fiber core mode leakage behavior that occurs in high-power double-clad fiber lasers as a result of thermally-induced refractive index variations. A model of the power transfer between the core modes and the cladding modes during thermally-induced refractive index variations is established based on the mode coupling theory. The results of numerical simulations based on actual laser parameters are presented. Experimental measurements were also carried out, the results showed good agreement with the corresponding simulation results.

Low-repetition-rate, all-polarization-maintaining Yb-doped fiber laser mode-locked by a semiconductor saturable absorber

A low-repetition-rate, all-polarization-maintaining（PM）-fiber sub-nanosecond oscillator is presented, which is simple and low-cost, composed of standard components. The ring cavity is elongated by 114-m-long standard PM fiber, and passively mode-locked by a fiber pigtailed semiconductor saturable absorber. Linearly polarized pulses with 1.66 MHz repetition rate and 22 dB polarization extinction ratio are generated at a wavelength of 1030 nm, which is determined by an intracavity filter. In addition, to demonstrate that the oscillator is a good seed for high energy pulse generation, an all-fiber master oscillator power amplifier is built and amplified pulses with energy about 2 μJ are obtained.

Influence of mode competition on beam quality of fiber amplifier

Theoretical and experimental studies of the influence of the mode competition on the output beam quality of fiber amplifiers are presented. Rate equations and modal decomposition method are used in the theoretical model. In the experiment, the output beam-quality factor of a fiber amplifier, which is based on a Yb-doped double-clad large mode area fiber as a function of the seed beam quality and the pump power of the amplifier, is measured. The experimental results are consistent with the theoretical analysis.

260 fs,403 W coherently combined fiber laser with precise high‑order dispersion management

An ultrafast fiber laser system comprising two coherently combined amplifier channels is reported.Within this system,each channel incorporates a rod-type fiber power amplifier,with individual operations reaching approximately 233 W.The active-locking of these coherently combined channels,followed by compression using gratings,yields an output with a pulse energy of 504μJ and an average power of 403 W.Exceptional stability is maintained,with a 0.3%root mean square(RMS)deviation and a beam quality factor M^(2)<1.2.Notably,precise dispersion management of the front-end seed light effectively compensates for the accumulated high-order dispersion in subsequent amplification stages.This strategic approach results in a significant reduction in the final output pulse duration for the coherently combined laser beam,reducing it from 488 to 260 fs after the gratings compressor,while concurrently enhancing the energy of the primary peak from 65%to 92%.

Powerful 2 μm Silica Fiber Sources: A Review of Recent Progress and Prospects

A review on the progress of powerful 2 μm silica fiber sources in past decades is presented. We review the state-of-the-art records and representative achievements of 2 μm high-average-power continuous- wave, pulsed fiber lasers and amplifiers, and powerful superfluorescent sources. Challenges which limit the further power scaling of 2 μm silica fiber sources are discussed, including pumping brightness limitation, thermal problem and nonlinear effects. Potential and promising roadmaps to go beyond these limitations, like tandem pumping and beam combining, are discussed. Prospects of powerful 2 μm silica fiber sources are also presented in the end of paper.

73 nJ, 109 fs Yb-doped fiber laser at 19 MHz repetition rate in amplifier similariton regime

We report femtosecond pulse generation in an amplifier similariton oscillator and a prechirped fiber amplifier system. The final output power is 1.4W, and the fundamental repetition rate is 19.1 MHz after a single state fiber amplifier. The pulsewidth is 109 fs.