The simulation performance over complex building clusters of a wind simulation model（Wind Information Field Fast Analysis model, WIFFA） in a micro-scale air pollutant dispersion model system（Urban Microscale Air Po...The simulation performance over complex building clusters of a wind simulation model（Wind Information Field Fast Analysis model, WIFFA） in a micro-scale air pollutant dispersion model system（Urban Microscale Air Pollution dispersion Simulation model, UMAPS） is evaluated using various wind tunnel experimental data including the CEDVAL（Compilation of Experimental Data for Validation of Micro-Scale Dispersion Models） wind tunnel experiment data and the NJU-FZ experiment data（Nanjing University-Fang Zhuang neighborhood wind tunnel experiment data）. The results show that the wind model can reproduce the vortexes triggered by urban buildings well, and the flow patterns in urban street canyons and building clusters can also be represented. Due to the complex shapes of buildings and their distributions, the simulation deviations/discrepancies from the measurements are usually caused by the simplification of the building shapes and the determination of the key zone sizes. The computational efficiencies of different cases are also discussed in this paper. The model has a high computational efficiency compared to traditional numerical models that solve the Navier–Stokes equations, and can produce very high-resolution（1–5 m） wind fields of a complex neighborhood scale urban building canopy（～ 1 km ×1km） in less than 3 min when run on a personal computer.展开更多
The Lanzhou-Xinjiang High-speed Railway runs through an expansive windy area in a Gobi Desert, and sand-blocking fences were built to protect the railway from destruction by wind-blown sand. However, the shielding eff...The Lanzhou-Xinjiang High-speed Railway runs through an expansive windy area in a Gobi Desert, and sand-blocking fences were built to protect the railway from destruction by wind-blown sand. However, the shielding effect of the sand-blocking fence is below the expectation. In this study, effects of metal net fences with porosities of 0.5 and 0.7 were tested in a wind tunnel to determine the effectiveness of the employed two kinds of fences in reducing wind velocity and restraining wind-blown sand. Specifically, the horizontal wind velocities and sediment flux densities above the gravel surface were measured under different free-stream wind velocities for the following conditions： no fence at all, single fence with a porosity of 0.5, single fence with a porosity of 0.7, double fences with a porosity of 0.5, and double fences with a porosity of 0.7. Experimental results showed that the horizontal wind velocity was more significantly decreased by the fence with a porosity of 0.5, especially for the double fences. The horizontal wind velocity decreased approximately 65% at a distance of 3.25 m（i.e., 13 H, where H denotes the fence height） downwind the double fences, and no reverse flow or vortex was observed on the leeward side. The sediment flux density decreased exponentially with height above the gravel surface downwind in all tested fences. The reduction percentage of total sediment flux density was higher for the fence with a porosity of 0.5 than for the fence with a porosity of 0.7, especially for the double fences. Furthermore, the decreasing percentage of total sediment flux density decreased with increasing free-stream wind velocity. The results suggest that compared with metal net fence with a porosity of 0.7, the metal net fence with a porosity of 0.5 is more effective for controlling wind-blown sand in the expansive windy area where the Lanzhou-Xinjiang High-speed Railway runs through.展开更多
A computational fluid dynamics(CFD)calculation model for the airflow and heat transfer in an armored vehicle cooling wind tunnel is established.A practical method to determine computation region outside power train co...A computational fluid dynamics(CFD)calculation model for the airflow and heat transfer in an armored vehicle cooling wind tunnel is established.A practical method to determine computation region outside power train compartment,produce grid and ensure grid quality is put forward.A commercial software FLUENT can be used to obtain solutions numerically in 3-D space.Precision of CFD calculation results is verified.The CFD model is used in designing a vehicle cooling wind tunnel,and air flow resistance of fan blast baffle is calculated.The calculated results show feasibility of the CFD model and the method.展开更多
基金supported by the China Special Fund for Meteorological Research in the Public Interest(Grant No.GYHY201106049)the National Natural Science Foundation of China(Grant Nos.51538005 and 41375014)the Jiangsu Collaborative Innovation Center for Climate Change,China
文摘The simulation performance over complex building clusters of a wind simulation model（Wind Information Field Fast Analysis model, WIFFA） in a micro-scale air pollutant dispersion model system（Urban Microscale Air Pollution dispersion Simulation model, UMAPS） is evaluated using various wind tunnel experimental data including the CEDVAL（Compilation of Experimental Data for Validation of Micro-Scale Dispersion Models） wind tunnel experiment data and the NJU-FZ experiment data（Nanjing University-Fang Zhuang neighborhood wind tunnel experiment data）. The results show that the wind model can reproduce the vortexes triggered by urban buildings well, and the flow patterns in urban street canyons and building clusters can also be represented. Due to the complex shapes of buildings and their distributions, the simulation deviations/discrepancies from the measurements are usually caused by the simplification of the building shapes and the determination of the key zone sizes. The computational efficiencies of different cases are also discussed in this paper. The model has a high computational efficiency compared to traditional numerical models that solve the Navier–Stokes equations, and can produce very high-resolution（1–5 m） wind fields of a complex neighborhood scale urban building canopy（～ 1 km ×1km） in less than 3 min when run on a personal computer.
基金financially supported by the Scientific and Technological Services Network Planning Project of Northwest Institute of Eco-Environment and Resources, Chinese Academy of Sciences (HHS-TSS-STS-1504)the Technological Research and Developmental Planning Projects of China Railway Corporation (2015G005-B)the National Natural Science Foundation of China (41501010, 41401611)
文摘The Lanzhou-Xinjiang High-speed Railway runs through an expansive windy area in a Gobi Desert, and sand-blocking fences were built to protect the railway from destruction by wind-blown sand. However, the shielding effect of the sand-blocking fence is below the expectation. In this study, effects of metal net fences with porosities of 0.5 and 0.7 were tested in a wind tunnel to determine the effectiveness of the employed two kinds of fences in reducing wind velocity and restraining wind-blown sand. Specifically, the horizontal wind velocities and sediment flux densities above the gravel surface were measured under different free-stream wind velocities for the following conditions： no fence at all, single fence with a porosity of 0.5, single fence with a porosity of 0.7, double fences with a porosity of 0.5, and double fences with a porosity of 0.7. Experimental results showed that the horizontal wind velocity was more significantly decreased by the fence with a porosity of 0.5, especially for the double fences. The horizontal wind velocity decreased approximately 65% at a distance of 3.25 m（i.e., 13 H, where H denotes the fence height） downwind the double fences, and no reverse flow or vortex was observed on the leeward side. The sediment flux density decreased exponentially with height above the gravel surface downwind in all tested fences. The reduction percentage of total sediment flux density was higher for the fence with a porosity of 0.5 than for the fence with a porosity of 0.7, especially for the double fences. Furthermore, the decreasing percentage of total sediment flux density decreased with increasing free-stream wind velocity. The results suggest that compared with metal net fence with a porosity of 0.7, the metal net fence with a porosity of 0.5 is more effective for controlling wind-blown sand in the expansive windy area where the Lanzhou-Xinjiang High-speed Railway runs through.
文摘A computational fluid dynamics(CFD)calculation model for the airflow and heat transfer in an armored vehicle cooling wind tunnel is established.A practical method to determine computation region outside power train compartment,produce grid and ensure grid quality is put forward.A commercial software FLUENT can be used to obtain solutions numerically in 3-D space.Precision of CFD calculation results is verified.The CFD model is used in designing a vehicle cooling wind tunnel,and air flow resistance of fan blast baffle is calculated.The calculated results show feasibility of the CFD model and the method.
