A finite difference method for computing the axisymmetric, transonic flows over a nacelle is presented in this paper. By use of the conservative full-potential equation, body-fitted grid, and the exact boundary condit...A finite difference method for computing the axisymmetric, transonic flows over a nacelle is presented in this paper. By use of the conservative full-potential equation, body-fitted grid, and the exact boundary conditions, a new AF scheme is constructed according to the criterion of optimum convergence. The proposed scheme has been applied to transonic nacelle flow problems. Computation for several nacelles shows the rapid convergence of this scheme and excellent agreement with the experimental results.展开更多
Small-scale measurements of the radon exhalation rate using the flow-through and closed-loop methods were conducted on the surface of a uranium tailing pond to better understand the differences between the two methods...Small-scale measurements of the radon exhalation rate using the flow-through and closed-loop methods were conducted on the surface of a uranium tailing pond to better understand the differences between the two methods.An abnormal radon exhalation behavior was observed,leading to computational fluid dynamics(CFD)-based simulations in which dynamic radon migration in a porous medium and accumulation chamber was considered.Based on the in-situ experimental and numerical simulation results,variations in the radon exhalation rate subject to permeability,flow rate,and insertion depth were quantified and analyzed.The in-situ radon exhalation rates measured using the flow-through method were higher than those measured using the closed-loop method,which could be explained by the negative pressure difference between the inside and outside of the chamber during the measurements.The consistency of the variations in the radon exhalation rate between the experiments and simulations suggests the reliability of CFD-based techniques in obtaining the dynamic evolution of transient radon exhalation rates for diffusion and convection at the porous medium-air interface.The synergistic effects of the three factors(insertion depth,flow rate,and permeability)on the negative pressure difference and measured exhalation rate were quantified,and multivariate regression models were established,with positive correlations in most cases;the exhalation rate decreased with increasing insertion depth at a permeability of 1×10^(−11) m^(2).CFD-based simulations can provide theoretical guidance for improving the flow-through method and thus achieve accurate measurements.展开更多
Realizing fast and continuous generation of reactive oxygen species(ROSs)via iron-based advanced oxidation processes(AOPs)is significant in the environmental and biological fields.However,current AOPs assisted by co-c...Realizing fast and continuous generation of reactive oxygen species(ROSs)via iron-based advanced oxidation processes(AOPs)is significant in the environmental and biological fields.However,current AOPs assisted by co-catalysts still suffer from the poor mass/electron transfer and non-durable promotion effect,giving rise to the sluggish Fe^(2+)/Fe^(3+)cycle and low dynamic concentration of Fe^(2+)for ROS production.Herein,we present a three-dimensional(3D)macroscale co-catalyst functionalized with molybdenum disulfide(MoS_(2))to achieve ultra-efficient Fe^(2+)regeneration(equilibrium Fe^(2+)ratio of 82.4%)and remarkable stability(more than 20 cycles)via a circulating flow-through process.Unlike the conventional batch-type reactor,experiments and computational fluid dynamics simulations demonstrate that the optimal utilization of the 3D active area under the flow-through mode,initiated by the convectionenhanced mass/charge transfer for Fe^(2+)reduction and then strengthened by MoS_(2)-induced flow rotation for sufficient reactant mixing,is crucial for oxidant activation and subsequent ROS generation.Strikingly,the flow-through co-catalytic system with superwetting capabilities can even tackle the intricate oily wastewater stabilized by different surfactants without the loss of pollutant degradation efficiency.Our findings highlight an innovative co-catalyst system design to expand the applicability of AOPs based technology,especially in large-scale complex wastewater treatment.展开更多
Objective The objective of this report was to demonstrate the clinical application of free flow-through anterolateral thigh flaps for the treatment of high-tension electrical wrist burns.Methods We collected the data ...Objective The objective of this report was to demonstrate the clinical application of free flow-through anterolateral thigh flaps for the treatment of high-tension electrical wrist burns.Methods We collected the data of 8 patients with high-tension electrical wrist burns admitted to Beijing Jishuitan Hospital from January 2014 to December 2018.The clinical and pathological data were extracted from electronic hospital medical records.We obtained follow-up information through clinic visits.Results The injury sites for all 8 patients were the wrists,specifically 5 right and 3 left wrists,all of which were on the flexor side.Five patients had ulnar artery embolism necrosis and patency,with injury to the radial artery.Two patients had ulnar and radial arterial embolization and necrosis.The last patient had ulnar arterial embolization and necrosis with a normal radial artery.After debridement,the wound area ranged from 12 cm×9 cm to 25 cm×16 cm.The diagnoses for the eight patients were type II to type III high-tension electrical wrist burns.Free flow-through anterolateral thigh flaps(combined with great saphenous vein transplantation if necessary)were used to repair the wounds.The prognosis for all patients was good after six months to one year of follow-up.Conclusion Treating wrist types II and III high-tension electrical burns is still challenging in clinical practice.The use of free flow-through anterolateral thigh flaps(combined with great saphenous vein transplantation if necessary)to repair the wound and to restore the blood supply for the hand at the same time is a good choice for treating severe wrist electrical burns.展开更多
文摘A finite difference method for computing the axisymmetric, transonic flows over a nacelle is presented in this paper. By use of the conservative full-potential equation, body-fitted grid, and the exact boundary conditions, a new AF scheme is constructed according to the criterion of optimum convergence. The proposed scheme has been applied to transonic nacelle flow problems. Computation for several nacelles shows the rapid convergence of this scheme and excellent agreement with the experimental results.
基金National Natural Science Foundation of China(No.11575080)Hunan Provincial Natural Science Foundation of China(No.2022JJ30482)Hunan Provincial Innovation Foundation for Postgraduate(No.QL20220206).
文摘Small-scale measurements of the radon exhalation rate using the flow-through and closed-loop methods were conducted on the surface of a uranium tailing pond to better understand the differences between the two methods.An abnormal radon exhalation behavior was observed,leading to computational fluid dynamics(CFD)-based simulations in which dynamic radon migration in a porous medium and accumulation chamber was considered.Based on the in-situ experimental and numerical simulation results,variations in the radon exhalation rate subject to permeability,flow rate,and insertion depth were quantified and analyzed.The in-situ radon exhalation rates measured using the flow-through method were higher than those measured using the closed-loop method,which could be explained by the negative pressure difference between the inside and outside of the chamber during the measurements.The consistency of the variations in the radon exhalation rate between the experiments and simulations suggests the reliability of CFD-based techniques in obtaining the dynamic evolution of transient radon exhalation rates for diffusion and convection at the porous medium-air interface.The synergistic effects of the three factors(insertion depth,flow rate,and permeability)on the negative pressure difference and measured exhalation rate were quantified,and multivariate regression models were established,with positive correlations in most cases;the exhalation rate decreased with increasing insertion depth at a permeability of 1×10^(−11) m^(2).CFD-based simulations can provide theoretical guidance for improving the flow-through method and thus achieve accurate measurements.
基金supported by National Natural Science Foundation of China(52003240)Zhejiang Provincial Natural Science Foundation of China(LQ21B070007)China Postdoctoral Science Foundation(2022M722818).
文摘Realizing fast and continuous generation of reactive oxygen species(ROSs)via iron-based advanced oxidation processes(AOPs)is significant in the environmental and biological fields.However,current AOPs assisted by co-catalysts still suffer from the poor mass/electron transfer and non-durable promotion effect,giving rise to the sluggish Fe^(2+)/Fe^(3+)cycle and low dynamic concentration of Fe^(2+)for ROS production.Herein,we present a three-dimensional(3D)macroscale co-catalyst functionalized with molybdenum disulfide(MoS_(2))to achieve ultra-efficient Fe^(2+)regeneration(equilibrium Fe^(2+)ratio of 82.4%)and remarkable stability(more than 20 cycles)via a circulating flow-through process.Unlike the conventional batch-type reactor,experiments and computational fluid dynamics simulations demonstrate that the optimal utilization of the 3D active area under the flow-through mode,initiated by the convectionenhanced mass/charge transfer for Fe^(2+)reduction and then strengthened by MoS_(2)-induced flow rotation for sufficient reactant mixing,is crucial for oxidant activation and subsequent ROS generation.Strikingly,the flow-through co-catalytic system with superwetting capabilities can even tackle the intricate oily wastewater stabilized by different surfactants without the loss of pollutant degradation efficiency.Our findings highlight an innovative co-catalyst system design to expand the applicability of AOPs based technology,especially in large-scale complex wastewater treatment.
基金Beijing Jishuitan Hospital Nova Program Funding[XKXX201617]。
文摘Objective The objective of this report was to demonstrate the clinical application of free flow-through anterolateral thigh flaps for the treatment of high-tension electrical wrist burns.Methods We collected the data of 8 patients with high-tension electrical wrist burns admitted to Beijing Jishuitan Hospital from January 2014 to December 2018.The clinical and pathological data were extracted from electronic hospital medical records.We obtained follow-up information through clinic visits.Results The injury sites for all 8 patients were the wrists,specifically 5 right and 3 left wrists,all of which were on the flexor side.Five patients had ulnar artery embolism necrosis and patency,with injury to the radial artery.Two patients had ulnar and radial arterial embolization and necrosis.The last patient had ulnar arterial embolization and necrosis with a normal radial artery.After debridement,the wound area ranged from 12 cm×9 cm to 25 cm×16 cm.The diagnoses for the eight patients were type II to type III high-tension electrical wrist burns.Free flow-through anterolateral thigh flaps(combined with great saphenous vein transplantation if necessary)were used to repair the wounds.The prognosis for all patients was good after six months to one year of follow-up.Conclusion Treating wrist types II and III high-tension electrical burns is still challenging in clinical practice.The use of free flow-through anterolateral thigh flaps(combined with great saphenous vein transplantation if necessary)to repair the wound and to restore the blood supply for the hand at the same time is a good choice for treating severe wrist electrical burns.
