Effect of Mo and cold forging deformation on strength and ductility of cobalt-based alloy L605

Mo element was added to cobalt-based alloy L605,and cold forging deformation was performed.The effects of the addition and cold forging deformation on the microstructure and mechanical properties of the alloy were studied by thermodynamic calculation,electron backscatter diffraction,transmission electron microscopy,and X-ray diffraction.The stacking fault energy(SFE)of the alloy decreased after the addition,and the formation of stacking faults and intersections were promoted to improve the strength and hardness.The tensile strength of the alloy with Mo increased from 1190 to 1702 MPa after 24%cold deformation,producing significant work hardening.The strengthening mechanism is strain-induced martensitic transformation(SIMT)and deformation twinning.The alloy,combined with Mo and after 24%deformation,had both high strength and ductility in comparison with the original cobalt-based alloy L605.This is attributed to the lower SFE which caused the increase in stacking fault density.During the tensile process,theε-hcp phase was easily generated at the stacking fault to reduce the stress concentration and increase the ductility.Controlling SIMT by adjusting the density of stacking faults can improve the mechanical properties of cobalt-based alloys.Theε-hcp phase,the interaction between deformation twins and dislocations,and the interaction between e-hcp phases during cold forging deformation caused local stress concentration,lowering ductility and toughness.

Microstructure Evolution of Different Forging Processes for12%Cr Steel During Hot Deformation

Five forging experiments were designed and conducted to investigate the effect of process parameters on microstructure evolution during hot deformation for X12CrMoWVNbN10-1-1 steel.The experimental results indicated that average grain size became finer with the increasing number of upsetting and stretching.Especially,the size of stretching three times with upsetting twice had the most remarkable effect on refinement,and the size was only 27.36%of the original one.Moreover,the stress model was integrated into the software and finite element models were established.Simulation results demonstrated that the strain at center point of workpiece was far larger than critical strain value in each process,so that dynamic recrystallization(DRX) occurred in each workpiece,which implied DRX could occur for several times with the increasing number of upsetting and stretching,and uniform finer microstructure would be obtained.However,the results also showed that higher temperature was an unfavorable factor for grain refinement,so the times of heating should be limited for workpiece,and as many forging processes as possible should be finished in once heating.