FRACTURE LIMIT LOAD OF CONE SHAPE PART IN DRAWING PROCESS

The deformation characters and load status of the blank＇s potential fracture zone are analyzed at the moment when blank is approaching to punch comer in drawing process of cone shape part. Based on tension instability theory, the formula for calculating fracture limit load of cone shape part in drawing process is derived. Also, the formula is analyzed and verified by experiment.

STUDY OF THE STRESS INTENSITY FACTOR OF PREFORMED V SHAPE FRACTURE TIP

In order to make the fracture cross-section of rock smooth in controlled cutting-blast, generally, two V-shape-notches on the inner wall of a shot hole are notched in symmetry along the design direction. A V-shape notch approximately be considered as V-shape-fracture under certain condition. This paper gave the complex stress function of preformed V-shape-fracture under a blasting load. The stress field and displacement field at the tip of a preformed V-shape-fracture were derived with Westergaard's method, hence its stressintensity factor was obtained. To verify the derived results, blasting tests were made with concrete samples of 400mm×400mm×300mm, and all having, in the center, a drilled hole of 25mm in diameter and 200mm in height. The test result showed that the formulas derived are correct and effective.

Hydraulic fracture geometry and proppant distribution in thin interbedded shale oil reservoirs

Small-scale true triaxial sand fracturing experiments are conducted on thin interbedded shale samples made from cores of Permian Lucaogou Formation shale oil reservoir in Jimsar sag, Junggar Basin, NW China. Combined with high-precision CT scanning digital core model reconstruction technology, hydraulic fracture geometry and proppant distribution in thin interbedded shale oil reservoirs are studied. The research shows that: In thin interbedded shale oil reservoir, the interlayer difference of rock mechanics and the interlayer interface near the wellbore cannot restrain the growth of fracture height effectively, but has a significant impact on the fracture width distribution in the fracture height direction. Hydraulic fractures in these reservoirs tend to penetrate into the adjacent layer in “step-like” form, but have a smaller width at the interface deflection, which hinders the transport of proppant in vertical direction, resulting in a poor effect of layer-crossing growth. In shale layers with dense laminae, hydraulic fractures tend to form “丰” or “井” shapes. If the perforated interval is large in rock strength and high in breakdown pressure, the main fracture is fully developed initially, large in width, and supported by enough sand. In contrast, if the perforated interval is low in strength and rich in laminae, the fracturing fluid filtration loss is large, the breakdown pressure is low, the main fracture will not open wide initially, and likely to have sand plugging. Proppant is mainly concentrated in the main hydraulic fractures with large width near the perforated layer, activated laminae, branch fractures and fractures in adjacent layers contain only a small amount of(or zero) proppant. The proppant is placed in a limited range on the whole. The limit width of fracture that proppant can enter is about 2.7 times the proppant particle size.

A Pivotal Moment

Who are the winners and losers of the United States’rebalanced foreign policy?The cornerstone and legacy of U.S.President Barack Obama’s foreign policy was embodied through the declaration of a "pivot" to Asia five years ago.