TDS-1 GNSS reflectometry wind geophysical model function response to GPS block types

This paper presents the TDS-1 GNSS reflectometry wind Geophysical Model Function(GMF)response to GPS block types.The observables were extracted from Delay Doppler Maps(DDMs)after taking the receiver antenna gains effects and GNSS-R geometry effects into account.Since the DDM is affected by GPS EffectiveIsotropic Radiated Power(EIRP),we first investigate the sensitivity of observables to the GPS block.Additionally,the observables at high SNRs are more sensitive to wind speed,but the spatial coverage at high signal to noise ratios(SNRs)is lower,while DDMs at low SNRs have the opposite characteristics.To balance the accuracy and spatial coverage,the DDM datasets are divided into two parts:high SNR(>0 dB)and low SNR(>−10 dB and≤0 dB)to develop wind GMF.Then,the influences of GPS block on wind speed retrieval both at high and low SNR is analyzed.Results show that the block types have impacts on wind GMF and the use of a prior GPS block can contribute to a better wind speed retrieval both at high and low SNR.Compared with ASCAT,the Root Mean Square Error(RMSE)value of wind speed retrieval at high and low SNR are 2.19 m/s and 3.13 m/s,respectively,when all TDS data are processed without distinguishing GPS block types.However,if the TDS data are separately processed and used to develop wind GMF through different blocks,both the accuracy and correlation coefficient can be improved to some extent.Finally,the influence of significant height of the swell(Hs)on SNR observables is analyzed,and it is demonstrated that there is no obvious linear or nonlinear relationship between them.

A high wind geophysical model fuction for Quik SCAT wind retrievals and application to Typhoon IOKE

The geophysical model function （GMF） describes the relationship between a backscattering and a sea surface wind, and enables a wind vector retrieval from backscattering measurements. It is clear that the GMF plays an important role in an ocean wind vector retrieval. The performance of the existing Ku-band model function QSCAT-1 is considered to be effective at low and moderate wind speed ranges. However, in the conditions of higher wind speeds, the existing algorithms diverge alarmingly, owing to the lack of in situ data required for developing the GMF for the high wind conditions, the QSCAT-1 appears to overestimate the a0, which results in underestimating the wind speeds. Several match-up QuikSCAT and special sensor microwave/imager （SSM/I） wind speed measurements of the typhoons occurring in the west Pacific Ocean are analyzed. The results show that the SSM/I wind exhibits better agreement with the ＂best track＂ analysis wind speed than the QuikSCAT wind retrieved using QSCAT-1. On the basis of this evaluation, a correction of the QSCAT-1 model function for wind speed above 16 m/s is proposed, which uses the collocated SSM/I and QuikSCAT measurements as a training set, and a neural network approach as a multiple nonlinear regression technologytechnology.In order to validate the revised GMF for high winds, the modified GMF was applied to the QuikSCAT observations of Hurricane IOKE. The wind estimated by the QuikSCAT for Typhoon IOKE in 2006 was improved with the maximum wind speed reaching 55 m/s. An error analysis was performed using the wind fields from the Holland model as the surface truth. The results show an improved agreement with the Holland model wind when compared with the wind estimated using the QSCAT-1. However, large bias still existed, indicating that the effects of rain must be considered for further improvement.