悬臂式SGCMG的高速转子的径向振动特性研究

悬臂式单框架控制力矩陀螺(SGCMG)的高速转子在运行过程中将会激发复杂的微幅高频振动,迄今对SGCMG的这种振动特性的认识既不准确也不完整。首先,在线性假设的基础上分析了径向振动的来源——静动不平衡量所产生的离心力和力偶以及预紧轴承滚动面的几何误差产生的预紧力的波动;其次,在结构的基础上利用分析力学的方法得到了悬臂式高速转子的径向振动模型——相互耦合的二阶常微分方程组;最后,通过数值仿真和测试结果的对比验证了分析的合理性和模型的有效性。

基于Gimbal的手机情境感知应用开发

解释了情景感知的定义,介绍了Gimbal开发平台能够高效、方便地帮助开发者实现手机情景感知应用的开发,给出了应用该平台开发一个校园位置感知的手机应用的细节。

Error analysis and a new steering law design for spacecraft control system using SGCMGs

Based on the singular value decomposition theory,this paper analyzed the mechanism of escaping/avoiding singularity using generalized and weighted singularity-robust steering laws for a spacecraft that uses single gimbal control moment gyros （SGCMGs） as the actuator for the attitude control system.The expression of output-torque error is given at the point of singularity,proving the incompatible relationship between the gimbal rate and the output-torque error.The method of establishing a balance between the gimbal rate and the output-torque error is discussed,and a new steering law is designed.Simulation results show that the proposed steering law can effectively drive SGCMGs to escape away from singularities.

Application of Ultrasonic Motor to Control of Moment Gyroscope Gimbal Servo System

Attitude control system is one of the most important subsystems in a spacecraft.As a key actuator,the control moment gyroscope(CMG)mainly determines the performance of attitude control system.Whereas,the control accuracy and output torque smoothness of the CMG depends more on its gimbal servo system.Considering the constraints of size,mass and power consumption for a small satellite,here,a mini-CMG is designed,in which the gimbal servo system is driven by an ultrasonic motor.The good performances of the CMG are obtained by both the ultrasonic motor and the rotary inductosyn.The direct drive of gimbal improves its dynamic performance,with the output bandwidth above 20 Hz.The angular and speed closed-loop control obtains the 0.02°/s gimbal rate,and the output torque resolution better than 2×10^(-3) N·m.The ultrasonic motor provides 1.0N·m self-lock torque during power-off,with 12arc-second position accuracy.

Underactuated spacecraft angular velocity stabilization and three-axis attitude stabilization using two single gimbal control moment gyros

Angular velocity stabilization control and attitude stabilization control for an underactuated spacecraft using only two single gimbal control moment gyros （SGCMGs） as actuators is investigated. First of all, the dynamic model of the underactuated spacecraft is established and the singularity of different configurations with the two SGCMGs is analyzed. Under the assumption that the gimbal axes of the two SGCMGs are installed in any direction, and that the total system angular momentum is not zero, a state feedback control law via Lyapunov method is designed to globally asymptotically stabilize the angular velocity of spacecraft. Under the assumption that the gimbal axes of the two SGCMGs are coaxially installed along anyone of the three principal axes of spacecraft inertia, and that the total system angular momentum is zero, a discontinuous state feedback control law is designed to stabilize three-axis attitude of spacecraft with respect to the inertial frame. Furthermore, the singularity escape of SGCMGs for the above two control problems is also studied. Simulation results demonstrate the validity of the control laws.

An improved constrained steering law for SGCMGs with DPC

An improved constrained （IC） steering law for single gimbal control moment gyros （SGCMGs） with deformed pyramid configuration （DPC） is proposed, First of all, the original system with five pyramid configuration （FPC） whose two adjacent gyros are in failure state is reconfigured as a degraded system with DPC. Then, the singular angular momentum hypersurfaces of the original and the degraded systems are plotted via the singular angular momentum equa- tion of SGCMGs. Based on singular surfaces, the differences between FPC and DPC in singularity and momentum envelope are obtained directly, which provide an important reference for steering law design of DPC. Finally, an IC steering law is designed and applied to DPC. The simulation results demonstrate that the IC steering law has advantages in simplicity of calculation, avoidance of singularity and exactness of output torque, which endow the degraded system with fine controllability in a restricted workspace.

Steering laws analysis of SGCMGs based on singular value decomposition theory

The steering laws of single gimbal control moment gyros （SGCMGs） are analyzed and compared in this paper for a spacecraft attitude control system based on singular value decomposition （SVD） theory. The mechanism of steering laws escaping singularity, especially how the steering laws affect singularity of gimbal configuration and the output torque error, is studied using SVD theory. Performance of various steering laws are analyzed and compared quantitatively by simulation. The obtained results can be used as a reference for designers.

Modeling and Simulation of Two Axes Gimbal Using Fuzzy Control

The application of the guided missile seeker is to provide stability to the sensor’s line of sight toward a target by isolating it from the missile motion and vibration.The main objective of this paper is not only to present the physical modeling of two axes gimbal system but also to improve its performance through using fuzzy logic controlling approach.The paper is started by deriving the mathematical model for gimbals motion using Newton’s second law,followed by designing the mechanical parts of model using SOLIDWORKS and converted to xml file to connect dc motors and sensors using MATLAB/SimMechanics.Then,a Mamdani-type fuzzy and a Proportional-Integral-Derivative(PID)controllers were designed using MATLAB software.The performance of both controllers was evaluated and tested for different types of input shapes.The simulation results showed that self-tuning fuzzy controller provides better performance,since no overshoot,small steady-state error and small settling time compared to PID controller.

Initial virtual flight test for a dynamically similar aircraft model with control augmentation system

To satisfy the validation requirements of flight control law for advanced aircraft,a wind tunnel based virtual flight testing has been implemented in a low speed wind tunnel.A 3-degree-offreedom gimbal,ventrally installed in the model,was used in conjunction with an actively controlled dynamically similar model of aircraft,which was equipped with the inertial measurement unit,attitude and heading reference system,embedded computer and servo-actuators.The model,which could be rotated around its center of gravity freely by the aerodynamic moments,together with the flow field,operator and real time control system made up the closed-loop testing circuit.The model is statically unstable in longitudinal direction,and it can fly stably in wind tunnel with the function of control augmentation of the flight control laws.The experimental results indicate that the model responds well to the operator＇s instructions.The response of the model in the tests shows reasonable agreement with the simulation results.The difference of response of angle of attack is less than 0.5°.The effect of stability augmentation and attitude control law was validated in the test,meanwhile the feasibility of virtual flight test technique treated as preliminary evaluation tool for advanced flight vehicle configuration research was also verified.

A New Measurement Method for Unbalanced Moments in a Two-axis Gimbaled Seeker

This article presents a novel method to measure unbalanced moments in a two-axis gimbaled seeker commonly believed to seviously influence the tracking accuracy and stabilizing capability. This method enables individual measurement of unbalanced moments, and judgment of the seeker＇ s status-balanced or not. Furthermore, an instrument is designed based on this method and calibrated. The effectiveness of the proposed method is validated through a simulation. The experimental results show a satisfied level of accuracy the measurements have. This work forms a basis for the further development of a more stabilized gimbaled seeker with less induced vibration and consumed power.

Singularity radius gradient-based rapid singularity-escape steering law for SGCMGs

In order to visualize singularity of SGCMGs in gimbal angle space,a novel continuous bounded singularity parameter--Singularity Radius,whose sign can distinctly determine singularity type,is proposed.Then a rapid singularity-escape steering law is proposed basing on gradient of Singularity Radius and residual base vector to drive the SGCMG system to neighboring singular boundary,and quickly escape elliptic singularities.Finally,simulation results on Pyramid-type and skew-type configuration demonstrate the effectiveness and rapidness of the proposed steering law.

Gimbal orientation study and assessment for the autonomous underwater vehicles

Autonomous underwater vehicles are at present being used for scientific,commercial and military submerged applications.In this paper,a system has been proposed which can be used underwater as remotely operated underwater vehicle for submerged survey for different purposes.These systems require self-sufficient direction and control frameworks so as to perform submerged assignments.Displaying,framework identification and control of these vehicles are as yet real dynamic zones of innovative work.This theory is worried about the plan and improvement of an Autonomous Underwater Vehicle(AUV)specifically proposed for passage into global submerged vehicle rivalries.The theory comprises of two stages;the first includes the plan and development of the vehicle while the subsequent stage is worried about the demonstrating and framework identification of the vehicle,just as the reproduction of a control system.The structure and advancement of the vehicle comprised of actualizing a mechanical and electrical framework,just as the reconciliation of subsystems.The framework identification of the vehicle parameters comprised of utilizing locally available sensors to perform static and dynamic tests.Least squares estimation was utilized to gauge the parameters from the pre-researched data obtained.