Effect of Thermal Convection on Density Segregation in Binary Granular Gases with Dissipative Lateral Walls

Molecular dynamics simulations are employed to investigate the effect of thermal convection induced only by dissipative lateral walls on density segregation of the strongly driven binary granular gases under low gravity conditions. It is found that the thermal convection due to dissipative lateral walls has significant influence on the segregation intensity of the system. The dominant factor in determining the degree of segregation achieved by the system is found to be the relative convection rate between differing species. Moreover, a qualitative explanation is proposed for the relationship between the thermal convection due to dissipative lateral walls and the observed segregation intensity profiles.

GPU-based discrete element simulation on flow stability of flat-bottomed hopper

In this study, the flow stability of the flat-bottomed hopper was investigated via GPU-based discrete element method(DEM) simulation. With the material height inside the hopper reducing, the fluctuation of the flow rate indicates an unstable discharge. The flow regions of the unstable discharge were compared with that of the stable discharge, a key transformation zone, where the voidage showed the largest difference between unstable and stable discharge, was revealed. To identify the relevance of the key transformation zone and the hopper flow stability, the voidage variation of the key transformation zone with material height reducing was studied.A sharp increase in the voidage in the key transformation zone was considered to be the standard for judging the unstable hopper flow, and the ‘Top–Bottom effect' of the hopper was defined, which indicated the hopper flow was unstable when the hopper only had the top area and the bottom area, because the voidage of particles in the top area and the bottom area were both variables.

Calibration of Discrete Element Heat Transfer Parameters by Central Composite Design

The efficiency and precision of parameter calibration in discrete element method （DEM） are not satisfactory, and parameter calibration for granular heat transfer is rarely involved. Accordingly, parameter calibration for granular heat transfer with the DEM is studied. The heat transfer in granular assemblies is simulated with DEM, and the effective thermal conductivity （ETC） of these granular assemblies is measured with the transient method in simulations. The measurement testbed is designed to test the ETC of the granular assemblies under normal pressure and a vacuum based on the steady method. Central composite design （CCD） is used to simulate the impact of the DEM parameters on the ETC of granular assemblies, and the heat transfer parameters are calibrated and compared with experimental data. The results show that, within the scope of the considered parameters, the ETC of the granular assemblies increases with an increasing particle thermal conductivity and decreases with an increasing particle shear modulus and particle diameter. The particle thermal conductivity has the greatest impact on the ETC of granular assemblies followed by the particle shear modulus and then the particle diameter. The calibration results show good agreement with the experimental results. The error is less than 4%, which is within a reasonable range for the scope of the CCD parameters. The proposed research provides high efficiency and high accuracy parameter calibration for granular heat transfer in DEM.