A new kind of thermoelectric heat pump water heater for kitchens exhaust heat recovery was presented,and its performances were investigated under different operating voltages.The experiment results show that the coeff...A new kind of thermoelectric heat pump water heater for kitchens exhaust heat recovery was presented,and its performances were investigated under different operating voltages.The experiment results show that the coefficient of performance decreases and the temperature difference between the hot and cold sides becomes larger with the increase of the operating voltage,but the heating time becomes short.The higher the temperature of water,the greater the temperature difference between the hot and cold sides,leading to a smaller coefficient of performance.Under an exhaust temperature of 36 ℃,the coefficient of performance decreases from 1.66 to 1.22 when the temperature of water increases from 28 ℃ to 46 ℃ with operating voltage 16 V.Performance tests illustrate that,compared with the conventional electrical water heaters,the new kind of thermoelectric heat pump water heater is more coefficient.展开更多
Natural gas is transported from producing regions to consumption regions by using transmission pipelines at high pressures. At consumption regions, the pressure of natural gas is reduced in city gate stations(CGSs). B...Natural gas is transported from producing regions to consumption regions by using transmission pipelines at high pressures. At consumption regions, the pressure of natural gas is reduced in city gate stations(CGSs). Before the pressure reduction process, the temperature of natural gas is increased usually by using a water bath heater,which burns natural gas as fuel, to protect against freezing of natural gas. These types of heat exchangers have a low efficiency and consume a lot of fuel to generate the required heat. In the current study, the twisted configuration of the heating coil is proposed and investigated to enhance the heat transfer through a water bath heater with a nominal capacity of 1000 m^3·h^-1. Firstly, the implementation procedure is validated with data collected from the CGS of Qaleh-Jiq(located in Golestan province of Iran). A very good agreement is achieved between the obtained results and the real data. Then, three different twist ratios are considered to examine the twisting effects. The proposed technique is evaluated in the terms of velocity, temperature, and pressure variations, and the results are compared with the conventional case, i.e. straight configuration. It is found that both the heat transfer rate and the pressure drop augment as the twist ratio is raised. Finally, it is concluded that the twisted tubes can reduce the length of the gas coil by about 12.5% for the model with low twist ratio, 18.75% for the model with medium twist ratio, and 25% for the model with high twist ratio as compared to the straight configuration.展开更多
We present a micro-Pirani vacuum gauge using the low-resistivity monocrystal silicon as the heaters and heat sinks fabricated by the post complementary metal oxide semiconductor (CMOS) microelectromechanical system ...We present a micro-Pirani vacuum gauge using the low-resistivity monocrystal silicon as the heaters and heat sinks fabricated by the post complementary metal oxide semiconductor (CMOS) microelectromechanical system (MEMS) process. The metal interconnection of the device is fabricated by a 0.5 μm standard CMOS process on 8-inch silicon wafer. Then, a SiO2-Si low-temperature fusion bonding is developed to bond the CMOS wafer and the MEMS wafer, with the electrical connection realized by the tungsten through silicon via process. Wafer- level A1Ge euteetic bonding is adopted to package the Pirani gauge in a non-hermetic cavity to protect the gauge from being damaged or contaminated in the dicing and assembling process, and to make it suitable for actual applications. To increase the accuracy of the test and restrain negative influence of temperature drift, the Wheatstone bridge structure is introduced. The test results show that before capping, the gauge has an average sensitivity of 1.04 × 104 K.W-1Torr-1 in dynamic range of 0.01 20 Torr. After capping, the sensitivity of the gauge does not decrease but increases to 1.12 × 104 K.W-1 Torr-1.展开更多
China is the largest solar water heater producer and market in the world.Despite the fast growth and an installed capacity that accounts for the majority of the global gross,China's per capita solar hot water capa...China is the largest solar water heater producer and market in the world.Despite the fast growth and an installed capacity that accounts for the majority of the global gross,China's per capita solar hot water capacity is still very low,implying a huge margin of market potential;and the recognition of the industry in the global market is handicapped by the scattered scale of production and inconsistent product quality.To ensure continued growth of China's solar water heating(SWH) industry,Chinese Government has established a series of national SWH standards,three national testing centers,and a certification program to lay the foundation for the development of the Golden Sun product labeling system.China General Certification Center(CGC) developed the Golden Sun product certification and labeling system on a pass/fail basis evaluating with established criteria.The system was designed to help manufacturers acclimate to explicit consistent requirements and to identify and fix the deficiencies in the design and execution of the program itself.Timely revision and integration of the national standards are recommended to accommodate the test procedures and requirements to new technologies and the evolving SWH market.Strict implementation of the Golden Sun certification and labeling system are suggested to avail improving the quality control and forging internationally reputable brands of Chinese solar water heating products.展开更多
A new type of microchannel condenser applied in the air source heat pump water heater(ASHPWH)with cyclic heating was proposed in this study.The operating performance of the ASHPWH was frst tested.Then,the structure of...A new type of microchannel condenser applied in the air source heat pump water heater(ASHPWH)with cyclic heating was proposed in this study.The operating performance of the ASHPWH was frst tested.Then,the structure of the microchannel condenser was optimized with the implement of vortex generators.Finally,a numerical model of the ASHPWH was established and the optimized microchannel condenser was studied.The experimental results showed that the average coefficient of performance(COP)of the 1HP(735 W)ASHPWH reached 3.48.In addition,the optimized microchannel condenser could be matched with a 3 HP(2430W)ASHPWH with an average heating capacity of 10.30 kW,and achieving an average COP of 4.24,14.6%higher than the limit value in the national standard.展开更多
基金Supported by Hunan Science and Technology Office(06wk3023)National High Technology Research and Development Program of China(2006AA05Z229)Project-sponsored by SRFfor ROCS,SEM
文摘A new kind of thermoelectric heat pump water heater for kitchens exhaust heat recovery was presented,and its performances were investigated under different operating voltages.The experiment results show that the coefficient of performance decreases and the temperature difference between the hot and cold sides becomes larger with the increase of the operating voltage,but the heating time becomes short.The higher the temperature of water,the greater the temperature difference between the hot and cold sides,leading to a smaller coefficient of performance.Under an exhaust temperature of 36 ℃,the coefficient of performance decreases from 1.66 to 1.22 when the temperature of water increases from 28 ℃ to 46 ℃ with operating voltage 16 V.Performance tests illustrate that,compared with the conventional electrical water heaters,the new kind of thermoelectric heat pump water heater is more coefficient.
基金Islamic Azad University(IAU)Shahrood Branch,Shahrood,IranGolestan Province Gas Company,Gorgan,Iran for their sponsorships.
文摘Natural gas is transported from producing regions to consumption regions by using transmission pipelines at high pressures. At consumption regions, the pressure of natural gas is reduced in city gate stations(CGSs). Before the pressure reduction process, the temperature of natural gas is increased usually by using a water bath heater,which burns natural gas as fuel, to protect against freezing of natural gas. These types of heat exchangers have a low efficiency and consume a lot of fuel to generate the required heat. In the current study, the twisted configuration of the heating coil is proposed and investigated to enhance the heat transfer through a water bath heater with a nominal capacity of 1000 m^3·h^-1. Firstly, the implementation procedure is validated with data collected from the CGS of Qaleh-Jiq(located in Golestan province of Iran). A very good agreement is achieved between the obtained results and the real data. Then, three different twist ratios are considered to examine the twisting effects. The proposed technique is evaluated in the terms of velocity, temperature, and pressure variations, and the results are compared with the conventional case, i.e. straight configuration. It is found that both the heat transfer rate and the pressure drop augment as the twist ratio is raised. Finally, it is concluded that the twisted tubes can reduce the length of the gas coil by about 12.5% for the model with low twist ratio, 18.75% for the model with medium twist ratio, and 25% for the model with high twist ratio as compared to the straight configuration.
基金Supported by the National High Technology Research and Development Program of China under Grant No 2015AA042602
文摘We present a micro-Pirani vacuum gauge using the low-resistivity monocrystal silicon as the heaters and heat sinks fabricated by the post complementary metal oxide semiconductor (CMOS) microelectromechanical system (MEMS) process. The metal interconnection of the device is fabricated by a 0.5 μm standard CMOS process on 8-inch silicon wafer. Then, a SiO2-Si low-temperature fusion bonding is developed to bond the CMOS wafer and the MEMS wafer, with the electrical connection realized by the tungsten through silicon via process. Wafer- level A1Ge euteetic bonding is adopted to package the Pirani gauge in a non-hermetic cavity to protect the gauge from being damaged or contaminated in the dicing and assembling process, and to make it suitable for actual applications. To increase the accuracy of the test and restrain negative influence of temperature drift, the Wheatstone bridge structure is introduced. The test results show that before capping, the gauge has an average sensitivity of 1.04 × 104 K.W-1Torr-1 in dynamic range of 0.01 20 Torr. After capping, the sensitivity of the gauge does not decrease but increases to 1.12 × 104 K.W-1 Torr-1.
文摘China is the largest solar water heater producer and market in the world.Despite the fast growth and an installed capacity that accounts for the majority of the global gross,China's per capita solar hot water capacity is still very low,implying a huge margin of market potential;and the recognition of the industry in the global market is handicapped by the scattered scale of production and inconsistent product quality.To ensure continued growth of China's solar water heating(SWH) industry,Chinese Government has established a series of national SWH standards,three national testing centers,and a certification program to lay the foundation for the development of the Golden Sun product labeling system.China General Certification Center(CGC) developed the Golden Sun product certification and labeling system on a pass/fail basis evaluating with established criteria.The system was designed to help manufacturers acclimate to explicit consistent requirements and to identify and fix the deficiencies in the design and execution of the program itself.Timely revision and integration of the national standards are recommended to accommodate the test procedures and requirements to new technologies and the evolving SWH market.Strict implementation of the Golden Sun certification and labeling system are suggested to avail improving the quality control and forging internationally reputable brands of Chinese solar water heating products.
基金the National Natural Science Foundation of China(No.51776117)。
文摘A new type of microchannel condenser applied in the air source heat pump water heater(ASHPWH)with cyclic heating was proposed in this study.The operating performance of the ASHPWH was frst tested.Then,the structure of the microchannel condenser was optimized with the implement of vortex generators.Finally,a numerical model of the ASHPWH was established and the optimized microchannel condenser was studied.The experimental results showed that the average coefficient of performance(COP)of the 1HP(735 W)ASHPWH reached 3.48.In addition,the optimized microchannel condenser could be matched with a 3 HP(2430W)ASHPWH with an average heating capacity of 10.30 kW,and achieving an average COP of 4.24,14.6%higher than the limit value in the national standard.