Health Monitoring of Long-Haul Fiber Communication System Using Chaotic OTDR

A novel chaotic optical time-domain reflectometry(OTDR)-based approach was proposed for monitoring long-haul fiber communication systems with multiple fiber segments. The self-phase modulation and group velocity dispersion effects of the optical cable was considered in demonstrating the proof-of-concept experiment and simulation. In experiments, the correlation peaks are clearly obtained from the correlation trace between the reference and reflected(or scattered) light signals propagating in three optical-fiber segments. The technique affords a high spatial resolution of 2 m, and further long-haul fiber simulations indicate that the sensing distance can be more than 3300 km. Thus, the new proposed technique can be effectively applied for health monitoring of long-haul fiber communication systems.

Optimization of Spectral Inverters in Optical Fiber Communication Systems with Mid-Span Spectrum Inversion

In this paper, signal distortions caused by spectral inverters which are used in 10Gb/s optical fiber communication systems with mid span spectrum inversion in terms of dispersion shift fibers are analyed numerically. It is shown that there exist the optimal input signal power, fiber length and fiblter bandwidth for the spectral in verters. System transmission penalty can be minimized by optimizing these parameters.

Equivalent Noise Models in Fiber Optical Communication Systems

An equivalent noise model of optical receiver amplifiers as shown in Fig.1 has been given in many fiber optical communication literatures. It is proved in this paper that this equivalent noise model is neither equivalent to the original one nor measurable. The main reason is that the position of the input impedance in this noise model is not the same with its in the typical noise model,but the same S vn , S in with the typical noise model are used. So the equivalent noise model above is wrong and is not fit to be taken into application.

Transmission Restriction and Suppression of Radio over Fiber Communication System

This article puts forward long-reach and high-performance Radio over Fiber (RoF) Communication Systems.Two schemes are proposed for solving the transmission restriction factors of the RoF system and verifies the system through experiments.One scheme is 40GHz RoF system based on external modulation with odd-order sideband-suppressed.The other one is 40GHz Optical Frequency Division Multiplexing (OFDM) system based on Optical Carrier-Suppression (OCS),external modulation.Both theory and experiment prove that the two systems allow not only low chromatic dispersion,but also long-distance transmission.

Polarization Jitters Caused by Fiber Nonlinearity in PM Optical Communication System

The phenomenon of polarization jitters caused by fiber nonlinearity is investigated. A general formula about the polarization jitter is concluded in polarization multiplexing (PM) system based on two orthogonal linear polarization states when the best polarization correction is used. A 100 Gb/s PM system based on NRZ code is investigated by simulation, and the Stocks parameter about polarization jitter and Poincare sphere diagrams are got for different power and phase difference of two orthogonal polarized light. The results show that the polarization jitters will be suppressed when the combined PM signal is the linear or circular polarization state.

Toward Low-Cost Flexible Intelligent OAM in Optical Fiber Communication Networks

Low-cost,flexible and intelligent optical performance monitoring and management is a key enabling technology for network quality guarantee,especially in the era of explosive growth of communication capacity and network scale.However,to the best of our knowledge,it is extremely challenging to implement real-time performance monitoring and operations,administration and maintenance(OAM) in a highly complex dynamic network.In this paper,we propose an innovative optical identification(OID) scheme that can realize both performance monitoring and some advanced OAM sub-functions.The basic concepts,applications,challenges and evolution directions of this OID tool are also discussed.

Fiber Grating Ring Laser in All Optical Communication System

Erbium fiber grating ring laser (EFRL) witn an integrated travelling wave and low polarization mode noise is reported. Through modulated experiment of a successful 2.488 Gb/s RZ data, it is shown that the EFRL is a promising alternative to DFB lasers for high-speed transmission applications.

Detecting Threats of Acoustic Information Leakage Through Fiber Optic Communications

Information leaks through regular fiber optic communications is possible in the form of eavesdropping on conversations, using standard fiber optic communications as illegal measuring network. The threat of leakage of audio information can create any kind of irregular light emission, as well as regular light beams modulated at acoustic frequencies. For information protection can be used a means of sound insulation, filtration and noising. This paper discusses the technical possibilities of countering threats by monitoring the optical radiation to detect eavesdropping.

352-Gbit/s single line rate THz wired transmission based on PS-4096QAM employing hollow-core fiber

We successfully demonstrate 32-Gbaud Probabilistically Shaped 4096-ary Quadrature Amplitude Modulation(PS-4096QAM)TeraHertz(THz)signal wired transmission at 325 GHz over the 1-m Hollow-Core Fiber(HCF)in a photon-assisted THz-wave communication system.By employing advanced Digital Signal Processing(DSP)and the PS technique,the 352-Gbit/s line rate(288-Gbit/s net rate)delivery with a net Spectral Efficiency(SE)of 9 bit/s/Hz is realized in the experiment,satisfying the 0.86-Normalized Generalized Mutual Information(NGMI)Low-Density Parity-Check(LDPC)threshold.

Applied electric field to fabricate colloidal crystals with the photonic band-gap in communication waveband

The macropore silica colloidal crystal templates were assembled orderly in a capillary glass tube by an applied electric field method to control silica deposition. In order to achieve the photonic band gap （PBG） of colloidal crystal in optical communication waveband, the diameter of silica microspheres is selected by Bragg diffraction formula. An experiment was designed to test the bandgap of the silica crystal templates. This paper discusses the formation process and the close-packed fashion of the silica colloidal crystal templates was discussed. The surface morphology of the templates was also analyzed. The results showed that the close-packed fashion of silica array templates was face-centered cubic （FCC） structure： The agreement is very good between the experimental data and the theoretical calculation.

Dispersion Monitoring Techniques in High Bit-rate Optical Communication Systems

For the efficient dynamic dispersion compensation, it is essential to monitor the dispersion accurately. The existing main dispersion monitoring techniques in high bit-rate optical communication systems are presented as well as their operating principles and research progress. The advantages and disadvantages of these methods are analyzed and discussed.

Discussion on the Integrated Communication System of Local Electric Power Network in China

This paper describes current situation and special requirements of local electric power communication network in China. The paper discusses the disadvantages of SDH and fiber loop carrier system applied to electric power communication network. It presents a new Communication System-IDS-2000 integrated digital communication system. The paper introduces the characteristics and application of IDS-2000 system in the local electric power communication network.

Converged Communication Technology and Application in Intelligent Dual-Interactive Power System

Acknowledgments Thanks for assistance and support, which is provided by State Grid Corporation of China and State Grid Communication Information ＆ Telecommunication Company, for the project in the process of research and development. Fibrlink Communications Co., Ltd will keep exerting itself to innovating, which aims for making more contribution of the smart grid on energy reduction and environment protection.

2.5 Gbit/s monolithic ICs for optical fiber transmitter and receiver in 0.35 μm CMOS process

2.5 Gbit/s monolithic integrated circuits （ICs） for optical fiber transmitter and receiver in 0.35 μm CMOS （complementary metal-oxide-semiconductor transistor） process are presented. The transmitter, which includes a 4： 1 multiplexer and a laser diode driver （LDD）, has four 622 Mbit/s random signals as its inputs and gets a 2.5 Gbit/s driving signal as its output; the receiver detects a 2.5 Gbit/s random signal and gets four 622 Mbit/s signals at the output. The main circuits include a trans-impedance amplifier （TIA）, a limiting amplifier, a clock and data recovery （CDR） unit, and a 1： 4 demultiplexer （DEMUX）. Test results prove the logic functions of the transmitter to be right, and the 10% to 90% rise and fall times of transmitter＇s output data eye diagram are 211.1 ps and 200 ps, respectively. The sensitivity of the receiver is measured to be better than 20 mV. The root mean square jitter of the DEMUX＇s output data is 15.6 ps and that of the clock after 1： 4 frequency dividing is 1.9 ps. Two chips are both applicable to 2.5 Gbit/s optical fiber communication systems.

Density-matrix-formalism based scheme for polarization mode dispersion monitoring and compensation in optical fiber communication systems

We propose a density-matrix-formalism based scheme to study polarization mode dispersion(PMD)monitoring and compensation in optical fiber communication systems.Compared to traditional monitoring and compensation schemes based on the PMD vector in the Stokes space,the scheme we proposed requires no auxiliary matrices and can be handily extended to any higher-dimensional modal space,which is advantageous in mode-division multiplexing(MDM)systems.A 28 GBaud polarization division multiplexing quadrature phase-shift keying(PDM-QPSK)coherent simulation system is built to demonstrate that our scheme can implement the monitoring and compensation of 170 ps large differential-group-delay(DGD)that far exceeds the typical DGDs in practical optical communication systems.The results verify the effectiveness of the density-matrix-formalism based scheme in PMD monitoring and compensation,thus pave the way for further applications of the scheme in more general MDM optical communication systems.

Experimental demonstration of single-mode fiber coupling using adaptive fiber coupler

Coupling plane wave into a single-mode fiber （SMF） with high and steady coupling efficiency is crucial for fiber- based free-space laser systems, where random angular jitters are the main influencing factors of fiber coupling. In this paper, we verified a new adaptive-optic device named adaptive fiber coupler （AFC） which could compensate angular jitters and improve the SMF coupling efficiency in some degree. Experiments of SMF coupling under the angular jitter situation using AFC have been achieved. Stochastic parallel gradient descent （SPGD） algorithm is employed as the control strategy, of which the iteration rate is 625 Hz. In closed loop, the coupling efficiency keeps above 65% when angular errors are below 80/3tad. The compensation bandwidth is 35 Hz at sine-jitter of 15 ~rad amplitude with average coupling efficiency of above 60%. Also, experiments with simulated turbulence have been studied. The average coupling efficiency increases from 31.97% in open loop to 61.33% in closed loop, and mean square error （MSE） of coupling efficiency drops from 7.43% to 1.75%.

Design of a Tapered Lens for Semiconductor Laser to Single-Mode Fiber Coupling

The theoretical investigation of the coupling efficiency of a laser diode to a single mode fiber via a hemispherical lens on the tip of the tapered fiber in the presence of possible transverse offset and angular mismatch is reported.Without the misalignment,coupling efficiency increases with the decreasing of taper length.With the misalignment,this relation is that the coupling efficiency decreases with each kind of offset.

A Novel and Fast Model of Erbium-doped Fiber Amplifiers

A novel and fast model of erbium-doped fiber amplifiers (EDFAs) is presented. By calculating a typical EDFA, numerical results are compared with the results obtained by spectral-solved method. The results of comparison show that such a model can improve the computational speed and preserve the precision. Some characteristics of the EDFA are then analyzed using this model. The results are consistent with those of the experiments.

Impacts of operational parameters on nonlinear polarization rotation-based passively mode-locked fiber laser

The operational parameters including the polarization controlling and the pump power in a nonlinear polarization rotation-based passively mode-locked fiber laser are studied in this paper.The carrier rate equations of the activated erbium-doped fiber are first employed together with the nonlinear Shro¨dinger equations to reveal the relation between the operational parameters and the output state of the passively mode-locked fiber laser.The numerical and experimental results demonstrate that the output state of the mode-locked laser varies with the polarization controlling and the pump power.The periodicity of the polarization controlling is observed.With given pump power,there exists a set of polarization controlling under which the ultra-short pulse can be generated.With given polarization controlling,the mode-locked state can be maintained generally except for some particular values of pump power.Three shapes of the output optical spectra from the fiber cavity can be identified when the pump power changes.The results in this paper provide a comprehensive insight into the operation of the nonlinear polarization rotation-based passively mode-locked fiber laser.