Photon-counting LiDAR using a two-dimensional(2D)array detector has the advantages of high lateral resolution and fast acquisition speed.The non-uniform intensity profile of the illumination beam and non-uniform quant...Photon-counting LiDAR using a two-dimensional(2D)array detector has the advantages of high lateral resolution and fast acquisition speed.The non-uniform intensity profile of the illumination beam and non-uniform quantum efficiency of the detectors in the 2D array deteriorate the imaging quality.Herein,we propose a photon-counting LiDAR system that uses a spatial light modulator to control the spatial intensity to compensate for both the non-uniform intensity profile of the illumination beam,and the variation in the quantum efficiency of the detectors in the 2D array.By using a 635 nm peak wavelength and 4 mW average power semiconductor laser,lab-based experiments at a 4.27 m stand-off distance are performed to verify the effectiveness of the proposed method.Compared with the unmodulated method,the standard deviation of the intensity image of the proposed method is reduced from 0.109 to 0.089 for a whiteboard target,with an average signal photon number of 0.006 per pixel.展开更多
The design and implementation of a novel ADC architecture called ring-ADC for digital voltage regulator module controllers are presented. Based on the principle of voltage-controlled oscillators＇ transform from volta...The design and implementation of a novel ADC architecture called ring-ADC for digital voltage regulator module controllers are presented. Based on the principle of voltage-controlled oscillators＇ transform from voltage to frequency,the A/D conversion of ring-ADC achieves good linearity and precise calibration against process variations compared with the delay-line ADC. A differential pulse counting discriminator also helps decrease the power consumption of the ring-ADC. It is fabricated with a Chartered 0.35μm CMOS process, and the measurement results of the integral and differential nonlinearity performance are 0.92LSB and 1.2LSB respectively. The maximum gain error measured in ten sample chips is ± 3.85%. With sampling rate of 500kHz and when the voltage regulator module （VRM） works in steady state, the ring-ADC＇s average power consumption is 2.56mW. The ring-ADC is verified to meet the requirements for digital VRM controller application.展开更多
A novel concept of collision avoidance single-photon light detection and ranging（LIDAR） for vehicles has been demonstrated, in which chaotic pulse position modulation is applied on the transmitted laser pulses for r...A novel concept of collision avoidance single-photon light detection and ranging（LIDAR） for vehicles has been demonstrated, in which chaotic pulse position modulation is applied on the transmitted laser pulses for robust anti-crosstalk purposes. Besides, single-photon detectors（SPD） and time correlated single photon counting techniques are adapted, to sense the ultra-low power used for the consideration of compact structure and eye safety. Parameters including pulse rate, discrimination threshold, and number of accumulated pulses have been thoroughly analyzed based on the detection requirements, resulting in specified receiver operating characteristics curves. Both simulation and indoor experiments were performed to verify the excellent anti-crosstalk capability of the presented collision avoidance LIDAR despite ultra-low transmitting power.展开更多
We demonstrate binary phase shift keying(BPSK) modulation using a silicon Mach–Zehnder modulator with aπ-phase-shift voltage(Vπ) of-4.5 V.The single-drive push–pull traveling wave electrode has been optimized usin...We demonstrate binary phase shift keying(BPSK) modulation using a silicon Mach–Zehnder modulator with aπ-phase-shift voltage(Vπ) of-4.5 V.The single-drive push–pull traveling wave electrode has been optimized using numerical simulations with a 3 dB electro-optic bandwidth of 35 GHz.The 32 Gb/s BPSK constellation diagram is measured with an error vector magnitude of 18.9%.展开更多
We propose an optical transmitter with reduced modulator driving voltage. This reduction is achieved through an on-off ratio improvement technique based on FWM. We confirmed the feasibility of the method in a 43-Gbit/...We propose an optical transmitter with reduced modulator driving voltage. This reduction is achieved through an on-off ratio improvement technique based on FWM. We confirmed the feasibility of the method in a 43-Gbit/s experiment.展开更多
文摘Photon-counting LiDAR using a two-dimensional(2D)array detector has the advantages of high lateral resolution and fast acquisition speed.The non-uniform intensity profile of the illumination beam and non-uniform quantum efficiency of the detectors in the 2D array deteriorate the imaging quality.Herein,we propose a photon-counting LiDAR system that uses a spatial light modulator to control the spatial intensity to compensate for both the non-uniform intensity profile of the illumination beam,and the variation in the quantum efficiency of the detectors in the 2D array.By using a 635 nm peak wavelength and 4 mW average power semiconductor laser,lab-based experiments at a 4.27 m stand-off distance are performed to verify the effectiveness of the proposed method.Compared with the unmodulated method,the standard deviation of the intensity image of the proposed method is reduced from 0.109 to 0.089 for a whiteboard target,with an average signal photon number of 0.006 per pixel.
文摘The design and implementation of a novel ADC architecture called ring-ADC for digital voltage regulator module controllers are presented. Based on the principle of voltage-controlled oscillators＇ transform from voltage to frequency,the A/D conversion of ring-ADC achieves good linearity and precise calibration against process variations compared with the delay-line ADC. A differential pulse counting discriminator also helps decrease the power consumption of the ring-ADC. It is fabricated with a Chartered 0.35μm CMOS process, and the measurement results of the integral and differential nonlinearity performance are 0.92LSB and 1.2LSB respectively. The maximum gain error measured in ten sample chips is ± 3.85%. With sampling rate of 500kHz and when the voltage regulator module （VRM） works in steady state, the ring-ADC＇s average power consumption is 2.56mW. The ring-ADC is verified to meet the requirements for digital VRM controller application.
基金Project supported by Tsinghua University Initiative Scientific Research Program,China(Grant No.2014z21035)
文摘A novel concept of collision avoidance single-photon light detection and ranging（LIDAR） for vehicles has been demonstrated, in which chaotic pulse position modulation is applied on the transmitted laser pulses for robust anti-crosstalk purposes. Besides, single-photon detectors（SPD） and time correlated single photon counting techniques are adapted, to sense the ultra-low power used for the consideration of compact structure and eye safety. Parameters including pulse rate, discrimination threshold, and number of accumulated pulses have been thoroughly analyzed based on the detection requirements, resulting in specified receiver operating characteristics curves. Both simulation and indoor experiments were performed to verify the excellent anti-crosstalk capability of the presented collision avoidance LIDAR despite ultra-low transmitting power.
基金supported in part by the National 973 Program of China (2011CB301700)the National 863 Program of China (2013AA014402)+1 种基金the National Natural Science Foundation of China (NSFC)(61127016,61107041,and 61422508)the Specialized Research Fund for the Doctoral Program of Higher Education of Ministry of Education (20130073130005)
文摘We demonstrate binary phase shift keying(BPSK) modulation using a silicon Mach–Zehnder modulator with aπ-phase-shift voltage(Vπ) of-4.5 V.The single-drive push–pull traveling wave electrode has been optimized using numerical simulations with a 3 dB electro-optic bandwidth of 35 GHz.The 32 Gb/s BPSK constellation diagram is measured with an error vector magnitude of 18.9%.
文摘We propose an optical transmitter with reduced modulator driving voltage. This reduction is achieved through an on-off ratio improvement technique based on FWM. We confirmed the feasibility of the method in a 43-Gbit/s experiment.
