Positive- and Zero-Sequence Impedance Estimation of YNyn0+d-Connected Main Power Transformers in Wind Power Applications

With the increased penetration of non-conventionalrenewable energy resources, such as wind power plants (WPPs),into the power system, a lot of interest has been placed on studyingtheir impact for system protection, planning and operationsto ensure continued reliability of the electric grid. The impactof WPPs on the grid is typically identified during generationinterconnection studies. One of the challenges faced by protectionand planning engineers, at an early stage in this process, isthat many of the studies involving these power plants must beperformed without specific data available because the equipmentis not built yet. Among all the needed data, a particular interest inthis study is placed on the positive- and zero-sequence impedancesof the main power transformer (MPT) that interconnects a windpower plant to the transmission system due to its contribution toshort-circuit current during ground faults. The most commonlyfound in practice MPT winding configurations is a high-voltagewinding in wye with neutral bushing;a low-voltage windingin wye with neutral bushing without phase shift between thesewindings, and a stabilizing tertiary winding connected in deltathat is not designed for external loading designated as YNyn0+d.Thus, this paper proposes a methodology to estimate the sequenceimpedances of YNyn0+d transformers from a statistical point ofview applying clustering and regression analyses on existing MPTtest report data.

A novel approach to conductive EMI noise source modeling

A new approach to conductive electromagnetic interference （EMI） noise source modeling, i. e. the source internal impedance extraction, is presented. First, the impedance magnitude is achieved through an exciting probe and a detecting probe, or through calculations based on insertion loss measurement results when inserting a series nigh-value known impedance or a shunt low-value known impedance in the circuit. Then the impedance phase is extracted by the Hilbert transform （HT） of the logarithm of the obtained impedance magnitude. Performance studies show that the estimated phase error can increase greatly at a zero frequency in the Hilbert transform because of the existence of a singular point, and this effect can be eliminated by introducing a zero-point when the noise source does not include a series-connected capacitive component. It is also found that when the frequency is nigher than 150 kHz, the estimated phase error is not sensitive to the inductive source but sensitive to the capacitive source. Finally, under the conditions of the same measurement accuracies for impedance magnitude, the accuracy of complex impedance based on the HT can be improved about 10 times when compared with the accuracy of estimated parameters based on the impedance magnitude fitting method （IMFM）.