WAVE CURRENT FORCE COEFFICIENTS ON INCLINED CYLINDER AND A NEW ESTIMATION METHOD

Based on the review of present force coefficients estimation methods, a new method in the frequency domain, revised cross-spectrum estimation method, is presented in this paper. Some experiments on the wave-current force on inclined cylinders are also described and the wave current force coefficients are estimated by the revised cross-spectrum estimation method. From the results, it is found that the wave and current directions have some regular effect on the coefficients. According to the results, some empirical formulas are obtained for converting the wave-current force coefficients on inclined cylinders into a unified coefficient. Comparisons show that the unified coefficients are in good agreement with other results.

Darcy-Forchheimer Hybrid Nano Fluid Flow with Mixed Convection Past an Inclined Cylinder

This article aims to investigate the Darcy Forchhemier mixed convection flow of the hybrid nanofluid through an inclined extending cylinder.Two different nanoparticles such as carbon nanotubes(CNTs)and iron oxide Fe3O4 have been added to the base fluid in order to prepare a hybrid nanofluid.Nonlinear partial differential equations for momentum,energy and convective diffusion have been changed into dimensionless ordinary differential equations after using Von Karman approach.Homotopy analysis method(HAM),a powerful analytical approach has been used to find the solution to the given problem.The effects of the physical constraints on velocity,concentration and temperature profile have been drawn as well for discussion purpose.The numerical outcomes have been carried out for the drag force,heat transfer rate and diffusion rate etc.The Biot number of heat and mass transfer affects the fluid temperature whereas the Forchhemier parameter and the inclination angle decrease the velocity of the fluid flow.The results show that hybrid nanofluid is the best source of enhancing heat transfer and can be used for cooling purposes as well.

Evolution of three-dimensional cavitation following water entry of an inclined cylinder

The water entry of an inclined cylinder is firstly studied experimentally for low Froude number. The cylinder is 50 mm in diameter and 200 mm in length, with a moderate length to diameter ratio. As it is submerged below the water surface, the cavity is fully three-dimensional. Due to the rotation of the cylinder caused by the initial inclined impact, the cavity evolution is quite complicated and a new phenomenon is revealed. The cylinder moves along a curved trajectory in water, which greatly affects the evolution of the cavities. The cavity breaks up into two sub-cavities, and finally collapses because of hydrostatic pressure.

Use of Helical Strakes for FIV Suppression of Two Inclined Flexible Cylinders in A Side-by-Side Arrangement

The experimental studies on flow-induced vibrations(FIV) reduction of two side-by-side flexible cylinders inclined at 45° by using the helical strakes were carried out in a towing tank. The main aim of the experiment is to check whether the helical strakes with a pitch of 17.5 D and a height of 0.25 D, which is considered as the most effective vibration suppression device for the isolated cylinder undergoing vortex-shedding, still perform very well to reduce FIV of two inclined flexible cylinders in a side-by-side arrangement. The vibration of two identical inclined cylinders with a mass ratio of 1.90 and an aspect ratio of 350 was tested in the experiment. The center-to-center distance between the two cylinders was 3.0 D. The uniform flow was simulated by towing the cylinder models along the tank.The towing velocity varied from 0.05 to 1.0 m/s with an interval of 0.05 m/s. The maximum Reynolds number can be up to 1.6×104. Three cases were experimentally studied in this paper, including two side-by-side inclined smooth cylinders, only one smooth cylinder fitted with helical strakes in the two side-by-side inclined cylinders system and both two cylinders attached with helical strakes. The variations of displacement amplitude, dominant frequency, FIV suppression efficiency and dominant mode for the two side-by-side inclined cylinders with reduced velocity were shown and discussed.

WAVE FORCES ON INCLINED CYLINDER IN REGULAR WAVES

Through a series of model tests,the wave forces on horizontal and inclined circular cylinders are measured and analyzed.Based on Morison Equation and Stokes second order wave theory,the relationship between the hydrodynamic force coefficients with KC number and sub- merged water depth as well for horizontal cylinders are analyzed,also the relationship between the hydrodynamic force coefficients with KC number,inclined angle and the effect of water free surface as well for the inclined cylinders are investigated.

Passive VIV Reduction of An Inclined Flexible Cylinder by Means of Helical Strakes with Round-Section

A series of experimental tests of passive VIV suppression of an inclined flexible cylinder with round-sectioned helical strakes were carried out in a towing tank. During the tests, the cylinder models fitted with and without helical strakes were towed along the tank. The towing velocity ranged from 0.05 to 1.0 m/s with an interval of 0.05 m/s.Four different yaw angles(a=0°, 15°, 30° and 45°), defined as the angle between the axis of the cylinder and the plane orthogonal of the oncoming flow, were selected in the experiment. The main purpose of present experimental work is to further investigate the VIV suppression effectiveness of round-sectioned helical strakes on the inclined flexible cylinder. The VIV responses of the smooth cylinder and the cylinder with square-sectioned strakes under the same experimental condition were also presented for comparison. The experimental results indicated that the roundsectioned strake basically had a similar effect on VIV suppression compared with the square-sectioned one, and both can significantly reduce the VIV of the vertical cylinder which corresponded to the case of a=0°. But with the increase of yaw angle, the VIV suppression effectiveness of both round-and square-section strakes deteriorated dramatically, the staked cylinder even had a much stronger vibration than the smooth one did in the in-line(IL)direction.

Flow of variable thermal conductivity fluid due to inclined stretching cylinder with viscous dissipation and thermal radiation

The aim of the present study is to investigate the flow of the Casson fluid by an inclined stretching cylinder. A heat transfer analysis is carried out in the presence of thermal radiation and viscous dissipation effects. The temperature dependent thermal conductivity of the Casson fluid is considered. The relevant equations are first simplified under usual boundary layer assumptions, and then transformed into ordinary differential equations by suitable transformations. The transformed ordinary differential equations are computed for the series solutions of velocity and temperature. A convergence analysis is shown explicitly. Velocity and temperature fields are discussed for different physical parameters by graphs and numerical values. It is found that the velocity decreases with the increase in the angle of inclination while increases with the increase in the mixed convection parameter. The enhancement in the thermal conductivity and radiation effects corresponds to a higher fluid temperature. It is also found that heat transfer is more pronounced in a cylinder when it is compared with a flat plate. The thermal boundary layer thickness increases with the increase in the Eckert number. The radiation and variable thermal conductivity decreases the heat transfer rate at the surface.

Hydrodynamic Forces on Smooth Inclined Cyh'nders in Oscillatory Flow

-The hydrodynamic forces on a smooth inclined circular cylinder exposed to oscillating flow were experimentally investigated at Reynolds number (Re) in the range 40000-200000 and Keulegan-Capenter number (KC) in the interval from 5-40. In the test, Re number and KC number were varied systematically. The inertia force coefficient (Cu) and the drag force coefficient (CD) in Morison equation were determined from the measured loads and the water particle kinematics. In this analysis a modified form of Morison equation was used since it uses the normal velocity and acceleration. Thus, the applicability of the Cross Flow Principle was assumed. This principle, simply stated, is as follows: the force acting in the direction normal to the axis of a cylinder placed at some oblique angle with the direction of flow is expressed in terms of the normal component of flow only, and the axial component is disregarded. Both the total in-line force coefficient (CF) and transverse force (lift) coefficient (Cf) were analyzed in terms of their maximum and root mean square values. All the in-line and lift force coefficients were given as a functions of Re and KC number. F'rom this research, it can be seen that the Cross-Flow Principle does not always work well. It seems valid for the total in- line force at high Re and large KC numbers. The Cu for a = 45 is larger and the CD for a = 45 is smaller than that for a = 90 ?and Re> 80000. The hydrodynamic force coefficients CD and Cu for the inclined cylinder are only the functions of the oblique angle (a) and KC number, but not of the Re number.

Thermo-bioconvection transport of nanofluid over an inclined stretching cylinder with Cattaneo–Christov double-diffusion

In this paper,Newtonian nanofluid flow is observed under the effects of the magnetic field,activation energy and motile microorganisms over an inclined stretchable cylinder.The magnificent aspects of nanoliquid are demonstrated by enduring the Brownian motion and thermophoresis diffusion features.Nonlinear higher order partial differential equations are transformed into first-order ordinary differential equations with suitable similarity variables.The attained sets of governing equations are then cracked by bvp4 c procedure in MATLAB mathematical software.The numerical and graphical outcomes of controlling parameters such as Prandtl number,mixed convection,activation energy,thermophoresis,Brownian parameter,Biot number,Lewis number,Peclet number and motile concentration parameter against the velocity,temperature,volumetric concentration and motile concentration of nanoparticles of the fluid are discussed.The velocity is enhanced with the growth valuation in mixed convection and decay by rising variation of buoyancy ratio parameter,magnetic parameter and bio-convective Rayleigh parameter.The evolution in motile microorganisms is due to the increasing values of microorganisms Biot number.The presented data can be helpful in enhancement of manufacturing processes,biomolecules,extrusion systems applications and energy production improvement.

Effects of Thermal Radiation and Slip Mechanism on Mixed Convection Flow of Williamson Nanofluid Over an Inclined Stretching Cylinder

The current investigation highlights the mixed convection slip flow and radiative heat transport of uniformly electrically conducting Williamson nanofluid yield by an inclined circular cylinder in the presence of Brownian motion and thermophoresis parameter.A Lorentzian magnetic body force model is employed and magnetic induction effects are neglected.The governing equations are reduced to a system of nonlinear ordinary differential equations with associated boundary conditions by applying scaling group transformations.The reduced nonlinear ordinary differential equations are then solved numerically by Runge-Kutta-Fehlberg fifth-order method with shooting technique.The effects of magnetic field,Prandtl number,mixed convection parameter,buoyancy ratio parameter,Brownian motion parameter,thermophoresis parameter,heat generation/absorption parameter,mass transfer parameter,radiation parameter and Schmidt number on the skin friction coefficient and local Nusselt are analyzed and discussed.It is found that the velocity of the fluid decreases with decrease in curvature parameter,whereas it increases with mixed convection parameter.Further,the local Nusselt number decreases with an increase in the radiation parameter.The numerical comparison is also presented with the existing published results and found that the present results are in excellent agreement which also confirms the validity of the present methodology.